Optimal tolls for multi-class traffic: Analytical formulations and policy implications

This paper puts together an analytical formulation to compute optimal tolls for multi-class traffic. The formulation is comprised of two major modules. The first one is an optimization component aimed at computing optimal tolls assuming a Stackelberg game in which the toll agency sets the tolls, and the equilibrating traffic plays the role of the followers. The optimization component is supported by a set of cost models that estimate the externalities as a function of a multivariate vector of traffic flows. These models were estimated using Taylor series expansions of the output obtained from traffic simulations of a hypothetical test case. Of importance to the paper is the total travel time function estimated using this approach that expresses total travel time as a multivariate function of the traffic volumes. The formulation presented in the paper is then applied to a variety of scenarios to gain insight into the optimality of current toll policies. The optimal tolls are computed for two different cases: independent tolls, and tolls proportional to passenger car equivalencies (PCE).The numerical results clearly show that setting tolls proportional to PCEs leads to lower values of welfare that are on average 15% lower than when using independent tolls, though, in some cases the total welfare could be up to 33% lower. This is a consequence of two factors. First, the case of independent tolls has more degrees of freedom than the case of tolls proportional to PCEs. Second, tolls proportional to PCEs do not account for externalities other than congestion, which is likely to lead to lower welfare values.The analytical formulations and numerical results indicate that, because the total travel time is a non-linear function of the traffic volumes, the marginal social costs and thus the optimal congestion tolls also depend on the traffic volumes for each vehicle class. As a result of this, for the relatively low volumes of truck traffic observed in real life, the optimal congestion tolls for trucks could indeed be either lower or about the same as for passenger cars. This stand in sharp contrast with what is implied in the use of PCEs, i.e., that the contribution to congestion are constant. This latter assumption leads to optimal truck congestion tolls that are always proportional to the PCE values.The comparison of the toll ratios (truck tolls divided by passenger car tolls) for both observed and optimal conditions suggests that the tolls for small trucks are about the right level, maybe a slightly lower than optimal. However, the analysis of the toll ratio for large trucks seems to indicate a significant overcharge. The estimates show that the average observed toll ratio for large trucks is even higher than the maximum optimal toll ratio found in the numerical experiments. This suggests that the tolls for large trucks are set on the basis of revenue generation principles while the passenger car tolls are being set based on a mild form of welfare maximization. This leads to a suboptimal cross-subsidization of passenger car traffic in detriment of an important sector of the economy.     

The external cost of speed at sea: An analysis based on selected short sea shipping routes

According to the mid-term review of the EU White Paper on Transport, Short Sea Shipping (SSS) is expected to grow at a rate of 59% (metric tonnes) between 2000 and 2020. If we consider that the overall expected increase in both freight exchanges and volume is 50%, sea transport is one of the most feasible alternatives to reduce traffic congestion on European roads. Maritime transportation may compete with road transport as far as certain traffics are concerned, but only when assuming external costs. This paper analyzes several intermodal transport chains involving a sea leg by comparing the effect of pollutant emissions from different ship types and road transport in terms of potential external cost savings. The translation of these emissions into environmental costs shows, for certain conditions, savings in the case of sea transport that would justify the use of an environmental bonus to promote the sea option.     

Gantry crane operations to transfer containers between trains: A simulation study of a Spanish terminal

Freight transfer operations are critical in combined transport networks. In this paper a simulation model and modelling approach to the transfer of cargo between trains at rail terminals is presented. The model is used to study the Port-Bou terminal, the main intermodal terminal at the Spanish-French frontier. Four different gantry crane operation modes to interchange containers between trains are evaluated. These operation rules are tested in several scenarios to examine the critical factors of the system and the best operation rule for each situation. Latest generation software is used to develop the model that incorporates modular programming and enhanced graphic systems for output representation. It allows a dynamic display of the simulated system and, likewise, the possibility of developing modules that can be reused in other studies. The research shows how simulation can be a useful planning tool in the rail transportation context.     

CO2 air–sea disequilibrium and preformed alkalinity in the Pacific and Indian oceans calculated from subsurface layer data

This work estimates new regionalized empirical parameterizations for preformed alkalinity (A_T^o) and the CO₂ air–sea disequilibrium (?C_dis). Both are key terms for the computation of anthropogenic CO₂ in the back-calculation methods. Data from the subsurface layer (75–180 m depth range) covering an area from North to South and from 19°E to 67.5°W (Pacific and Indian oceans) were taken from GLODAP (The Global Ocean Data Analysis Project) database. The subsurface layer is proved as a reliable reference for representing the main characteristics of the different water masses of the oceans. Besides, handing data from the two ocean basins altogether makes the new parameterizations of A_T^o and ?C_dis to be more globally consistent. Nevertheless, each ocean basin, at least in some regions, has different oceanographic characteristics based on its proper dynamical processes and water masses formation. In order to maintain each ocean basin ‘identity’ the whole domain was divided in six different regions (two of them sharing waters from Pacific and Indian oceans) and parameterizations in each region for both terms were obtained. Previously, data were transformed into a grid of 4°lat. × 5°lon. and the results obtained from the parameterizations were visualized and compare with pCO₂ climatologies. From the comparisons with previous ?C_dis estimations good results are obtained showing the reliability and robustness of the new regionalized empiric parameterizations.     

On the observability of the fortnightly cycle of the Tagus estuary turbid plume using MODIS ocean colour images

Using three years (2003 to 2005) of MODIS-Aqua normalized water-leaving radiance at 551 nm this paper shows a fortnightly cycle in the Tagus estuary turbid plume. The Tagus estuary is one of the largest estuaries of the west coast of Europe and is located in the most populated area of Portugal, including the capital Lisbon. The turbid plume has been detected by the backscattering characteristics of the surface waters in the vicinity of the estuary mouth. In fortnightly scales, the turbid plume has smaller dimensions during and after neap tides and higher dimensions during and after spring tides. This is most probably associated with the fortnightly spring–neap tidal cycle and the consequent increase in turbidity inside the estuary during spring tides. During the summer weak spring tides (tidal amplitude approximately 2.5 m) no turbid plume is observed for an entire fortnightly cycle. Outside the summer months, precipitation, river discharge and winds, were found to increase the turbid area, but the fortnightly cycle appears to be superimposed on the large time-scale variability, and present throughout the year.     

Belief and fuzzy theories for driving behavior assessment in case of accident scenarios

The estimation of the overspeed risk before the accident is among the main goals of this paper. The proposed method uses the Energy Equivalent Speed (EES) to assess the severity of an eventual accident. However, the driver behavior evaluation should take into account the parameters related to the Driver, the Vehicle and the Environment (DVE) system. For this purpose, this paper considers a two-level strategy to predict the global risk of an event using the Dempster-Shafer Theory (DST) and the Fuzzy Theory (FT). This paper presents two methods to develop the Expert Model-based Basic Probability Assignment (EM based BPA), which is the most important task in the DST. The first one is based on the accident statistics and the second method deals with the relationship between the Fuzzy and Belief measurements. The experimental data is collected by one driver using our test vehicle and a Micro-intelligent Black Box (Micro-iBB) to collect the driving data. The sensitivity of the developed models is analysed. Our main evaluation concerns the Usage Based Insurance (UBI) applications based on the driving behavior. So, the obtained masses over the defined referential subsets in the DST are used as a score to compute the driver’s insurance premium.     

The influence of variable message signs on en-route diversion between a toll highway and a free competing alternative

Transportation - In the field of road transport, Advanced Traveller Information Systems represent a relevant tool to manage road traffic, improve drivers’ utility and make a more efficient...     

Drivers’ adoption of electronic payment in the Spanish toll road network

Transportation - Electronic Toll Collection (ETC) systems are based on tags, on-board units associated to personal bank accounts, used for paying tolls electronically. Despite the benefits...     

Modification of the Highway Capacity Manual two‐lane highway analysis procedure for Spanish conditions

The US Highway Capacity Manual (HCM) methodology is used in Spain to evaluate traffic operation and quality of service. The effect of passing manoeuvre on two‐lane highway operational performance is considered through adjustment factors to average travel speeds and percent time spent following. The procedure is largely based on simulations in TWOPAS and passing behaviours observed during US calibrations in the 1970s. It is not clear whether US driving behaviour and vehicles' performance are comparable with Spanish conditions. The objective of this research is to adapt the HCM 2010 methodology to Spanish driver behaviour, for base conditions (i.e. no passing restrictions). To do so, TWOPAS was calibrated and validated based on current Spanish passing field data. The calibration used a genetic algorithm. The case study included an ideal two‐lane highway with varying directional traffic flow rate, directional split and percentage of trucks. The updated methodology for base conditions is simpler than the current HCM 2010 and does not rely on interpolation from tables. Copyright © 2016 John Wiley & Sons, Ltd.     

Mathematical model for optimising the sequence for clearing snow from the manoeuvring area during winter operations

This article considers the optimisation of the sequence for clearing snow from stretches of the manoeuvring area of an airport. This issue involves the optimisation of limited resources to remove snow from taxiways and runways thereby leaving them in an acceptable condition for operating aircraft. The airfield is divided into subsets of significant stretches for the purpose of operations and target times are established during which these are open to aircraft traffic. The document contains several mathematical models each with different functions, such as the end time of the process, the sum of the end times of each stretch and gap between the estimated and the real end times. During this process, we introduce different operating restrictions on partial fulfilment of the operational targets as applied to zones of special interest, or relating to the operation of the snow‐clearing machines. The problem is solved by optimisation based on linear programming. The article gives the results of the computational tests carried out on five distinct models of the manoeuvring area, which cover increasingly complex situations and larger areas. The mathematical model is particularised for the case of the manoeuvring area of Adolfo Suarez Madrid—Barajas Airport. Copyright © 2016 John Wiley & Sons, Ltd.

Highlights
• Optimal sequence for clearing snow from the manoeuvring area of an airport.
• Contains optimising algorithms solved using CPLEX LP‐based tree search.
• Restrictions on partial fulfilment of operational targets applied to subsets of significant stretches, used for planning the operation of snow‐clearing machines.
• Model applied to the case of the manoeuvring area of Adolfo Suárez Madrid Barajas Airport.
• Conclusions are given on the results of the computational tests carried out. There are five models of the manoeuvring area which cover increasingly complex situations and larger areas.