挂篮底模纵梁受力简化计算方法及承重分配系数

以一桥梁施工工程实例为依托,采用有限元软件ANSYS对桥梁悬臂施工中使用的菱形挂篮进行仿真分析.提出3种简化模式计算底模纵梁的承重分配,对比发现将底模纵梁承受的外荷载简化为集中荷载,并分配至挂篮下前后横梁的方法是最优简化计算方法.在此基础上对挂篮底模纵梁承重分配系数进行优化,从而简化了繁琐的挂篮底模纵梁受力分析计算,保证了挂篮结构设计和施工的安全.     

哈牡线季节性冻土接触网基础处理措施探讨

针对哈尔滨至牡丹江电气化改造工程季节性冻土分布的实际工程特点,结合季节性冻土条件下接触网基础的设计理念,对本项目选用的扩大型钢柱基础和不带扩底的拉线基础进行切向冻胀应力计算分析,并考虑影响切向冻胀力的水分、土质、负温以及基础侧表面的粗糙度等主要因素,提出了对钢柱基础采用换填加扩大型基础的处理措施,对接触网的下锚拉线基础提出了换填及加大埋深等防冻胀处理措施以抵抗季节性冻土的上拔力。     

Simulation on progressive collapse behaviour of whole ship model under extreme waves using idealized structural unit method

To ensure the safety of navigating ship, working loads and structural load-carrying capacity are two important aspects. In the present paper, a total simulation system combing load calculation and structural collapse analysis is applied to simulate progressive collapse behaviour of a single-hull Kamsarmax type bulk carrier. A three dimensional singularity distribution method is adopted to calculate pressure distribution with time history. A mixed structural model, collapse part simulated by ISUM elements and remaining part by elastic FEM elements with relative coarse mesh, is proposed for collapse analysis. Progressive collapse behaviour obtained by ISUM is good agreement with that by nonlinear software package, MARC. However, the calculation time of ISUM analysis is about 1/70 of MARC analysis. The applicability to structure system, high accuracy and sufficient efficiency of ISUM had been demonstrated.     

内压载荷下X80管道裂纹应力分布规律研究

为了研究内压作用下管道裂纹应力场分布规律,以含有表面裂纹的X80管道为研究对象,对不同形状、不同方向、不同内压、不同尺寸的含裂纹管道进行仿真分析和实验验证。结果表明:裂纹尖端处应力远大于裂纹中心应力。裂纹形状对应力影响作用较小,随着裂纹方向与管道轴向夹角增大,裂纹尖端应力先增大后减小,随着管道内压、裂纹深度、裂纹长度的增大,裂纹尖端处应力随之线性增大。其中,裂纹长度对裂纹尖端应力的影响小于管道内压和裂纹深度。     

格拉斯磁环匀强磁场分析

以毕奥-萨伐尔定律为基础,建立亥姆霍兹线圈以及格拉斯磁环中心磁场分布模型,并计算了它们内部的轴向磁感应强度分布,绘出了空间分布图,分析了轴向磁感应强度与x、y坐标的关系,分析结果得到了亥姆霍兹线圈和格拉斯磁环内部匀强磁场分布区域,通过比较得到格拉斯磁环内部的匀强磁场区域比亥姆霍兹线圈内部的匀强磁场分布区域更大的结论。     

A copula-based approach for estimating the travel time reliability of urban arterial

Estimating the travel time reliability (TTR) of urban arterial is critical for real-time and reliable route guidance and provides theoretical bases and technical support for sophisticated traffic management and control. The state-of-art procedures for arterial TTR estimation usually assume that path travel time follows a certain distribution, with less consideration about segment correlations. However, the conventional approach is usually unrealistic because an important feature of urban arterial is the dependent structure of travel times on continuous segments. In this study, a copula-based approach that incorporates the stochastic characteristics of segments travel time is proposed to model arterial travel time distribution (TTD), which serves as a basis for TTR quantification. First, segments correlation is empirically analyzed and different types of copula models are examined. Then, fitting marginal distributions for segment TTD is conducted by parametric and non-parametric regression analysis, respectively. Based on the estimated parameters of the models, the best-fitting copula is determined in terms of the goodness-of-fit tests. Last, the model is examined at two study sites with AVI data and NGSIM trajectory data, respectively. The results of path TTD estimation demonstrate the advantage of the proposed copula-based approach, compared with the convolution model without capturing segments correlation and the empirical distribution fitting methods. Furthermore, when considering the segments correlation effect, it was found that the estimated path TTR is more accurate than that by the convolution model.     

Extreme hawser tension assessment for FPSO vessel during offloading operation in Bohai bay

The Floating Production Storage and Offloading Unit (FPSO) is an offshore vessel that produces and stores crude oil prior to tanker transport.Robust prediction of extreme hawser tensions during Floating Production Storage and Offloading (FPSO) operation is an important safety concern. Excessive hawser tension may occur during offloading operations, posing an operational risk. In this paper, AQWA has been used to analyze vessel response due to hydrodynamic wave loads, acting on a specific FPSO vessel under actual sea conditions. Experimental validation of numerical results has been discussed as well.This paper advocates methodology for estimating extreme response statistics, based on simulations (or measurements). The modified ACER (averaged conditional exceedance rate) method is presented in brief detail. Proposed methodology provides an accurate extreme value prediction, utilizing all available data efficiently. In this study the estimated return level values, obtained by ACER method, are compared to the corresponding return level values obtained by Gumbel method. Based on the overall performance of the proposed method, it is concluded that the improved ACER method can provide more robust and accurate prediction of the extreme hawser tension.Data declustering issue has been addressed. Paper highlights ability of ACER method to account for a set of varying sea state probabilities, as required in engineering long term statistical analysis.Described approach may be well used at the vessel design stage, while defining optimal vessel parameters that would minimize potential FPSO hawser tension.     

南昌地铁砾砂层渣土改良技术试验研究

随着土压平衡盾构的广泛推广和应用,其地层适应性也越来越强,但盾构机在一些特殊地层中掘进时,渣土无法满足盾构施工对渣土流塑性的要求,易造成刀盘结饼、掌子面压力不稳定、刀盘磨损严重等问题。泡沫渣土改良技术是保证施工安全、顺利进行的关键技术之一。本文针对两种工程现场常用的泡沫进行泡沫基础性能试验,并以南昌地铁3号线盾构区间为工程背景,针对该区间砾砂地层进行改良渣土坍落度试验,对不同注入率和不同发泡剂的改良效果进行分析。研究发现,两种泡沫剂的建议使用浓度为3%;渣土流动性随泡沫注入率的增大而提高。在试验所用土样条件下,建议施工时使用的泡沫注入率为20%~30%。     

垃圾土力学特性及其路基填筑应用研究

将垃圾土应用于公路路基填筑是实现垃圾土大规模资源化利用的有效途径。本文首先对实际垃圾土进行筛分处理,制得适用于公路路基的垃圾筛余土(简称垃圾土);进而,通过室内试验研究了直接压实垃圾土和固化垃圾土的抗剪强度、CBR值等力学特性;以此为基础,修筑直接压实垃圾土路基试验段,并采用适宜的新型施工工艺修筑固化垃圾土路基试验段,监测路基的工后沉降随时间的变化规律,对比两种垃圾土路基的应用效果。结果表明:固化垃圾土与直接压实垃圾土相比,粘聚力提高1.6~1.9倍,内摩擦角提高30%以上,CBR值提高4.5~5.1倍;固化垃圾土路基的工后沉降比直接压实垃圾土路基降低64.7%,且能够更早地趋于稳定。以上结果证明:本文提出的固化垃圾土路基施工工艺和垃圾土资源化利用途径是可行的。