Bus Priority Using pre-signals

The need to provide efficient public transport services in urban areas has led to the implementation of bus priority measures in many congested cities. Much interest has recently centred on priority at signal controlled junctions, including the concept of pre-signals, where traffic signals are installed at or near the end of a with-flow bus lane to provide buses with priority access to the downstream junction. Although a number of pre-signals have now been installed in the U.K., particularly in London, there has been very little published research into their design, operation and optimisation. This paper addresses these points through the development of analytical procedures which allow pre-implementation evaluation of specific categories of pre-signals. The paper initially sets out three categories of pre-signal, which have different operating characteristics, different requirements for signalling and different impacts on capacity and delay. Key issues concerning signalling arrangements for these categories are then discussed, together with a summary of the analytical approach adopted and the assumptions required. Equations are developed to allow appropriate signal timings to be calculated for pre-signalised intersections. Further equations are then developed to enable delays to priority and non-priority traffic, with and without pre-signals, to be estimated with delay being taken here as the key performance criterion. The paper concludes with three application examples illustrating how the equations are applied and the impacts of pre-signals in different situations.The analyses confirm the potential benefits of pre-signals, where these signals apply to non-priority traffic only. Where buses are also subject to a pre-signal, it is shown that disbenefits to buses can often occur, unless bus detectors are used to gain priority signalling.     

分段线性变参数控制在数字式自动找平控制系统中的应用

为了验证分段线性变参数控制在自动找平控制系统中的应用前景,对自动找平控制系统的结构、控制方式进行了介绍;分析了分段线性控制方式的工作原理及特点,在实验室建立了沥青混凝土摊铺机数字式自动找平控制系统试验台,设计了3套试验方案,即普通电磁阀方案、高速开关阀方案和分段线性控制方案;对这3种控制方案进行了试验比较,得出了在阶跃干扰作用下,3种控制方案的响应速度及产生超调时的超调量。结果表明:分段线性控制方案具有较快的响应速度,但在系统产生超调时,其超调量相对较大。     

非港湾式公交停车对道路交通流的影响分析

公交车进出站点不仅影响本身,也给其他车辆运行带来很大干扰。文章首先比较全面地分析非港湾式公交停车影响下道路交通流特征,然后借助于EXCEL软件,构建关于公交停车频率、公交停车时间、最大公交停车长度及其存在时间、道路流量的车速和车头时距多元线性模型,并进行了严格的数学检验。该研究为合理分析路段交通流状况、正确计算区间行驶车速与车头时距提供了依据。     

基于动态水域网格计算的船舶领域研究

为了满足现代船舶的发展需求,结合船舶自动识别系统(AIS)数据量巨大,包含了丰富的船舶信息等优点.本文利用SQL2012对AIS数据进行处理,建立包含船舶静态信息和动态信息的数据库;借助C#程序语言,构建以中心船舶为原点的网格坐标系,并以船舶间相对距离方位计算周围船舶在网格中的相对位置坐标;对同长度和类型的船舶进行网格叠加计算,并以船舶频数的方式进行统计,采用数据处理软件Matlab以最小二乘法的方式对统计结果进行处理;对研究水域的主要船型不同尺度的船舶领域进行对比和统计分析,并对不同船型船舶领域略作讨论,总结得出开阔水域船舶领域的特点.     

集装箱装卸桥吊具卷缆系统防失控改造

针对西门子电控系统集装箱桥吊吊具卷缆子系统在使用过程中发现的缺陷进行改造。通过修改西门子变频器参数,可有效避免桥吊吊具卷缆系统由于通信故障引发的失控,不但节约了成本,而且提高了桥吊可靠性。     

路侧公交专用车道模式下右转交织长度建模

在设置路侧公交专用道的交叉口处,可通过划定交织区的方式允许右转车辆借用一定长度的公交专用道通行.合理规划公交车与右转车的交织区长度有利于提高借道右转的通行效率,减少在交织区前的排队车辆数从而降低道路混乱程度,保障公交车的专用路权.本文分析了公交站点影响下的公交车车头时距分布,建立了右转车穿越交织区长度计算模型,并结合实际调查数据进行了算例分析和模型验证.研究成果可为公交优先条件下的交叉口空间优化设计提供理论参考.     

Analytical and simulation approaches to understand combined effects of transit signal priority and road-space priority measures

Transit signal priority (TSP) may be combined with road-space priority (RSP) measures to increase its effectiveness. Previous studies have investigated the combination of TSP and RSP measures, such as TSP with dedicated bus lanes (DBLs) and TSP with queue jump lanes (QJLs). However, in these studies, combined effects are usually not compared with separate effects of each measure. In addition, there is no comprehensive study dedicated to understanding combined effects of TSP and RSP measures. It remains unclear whether combining TSP and RSP measures creates an additive effect where the combined effect of TSP and RSP measures is equal to the sum of their separate effects. The existence of such an additive effect would suggest considerable benefits from combining TSP and RSP measures. This paper explores combined effects of TSP and RSP measures, including TSP with DBLs and TSP with QJLs. Analytical results based on time-space diagrams indicate that at an intersection level, the combined effect on bus delay savings is smaller than the additive effect if there is no nearside bus stop and the traffic condition in the base case is under-saturated or near-saturated. With a near-side bus stop, the combined effect on bus delay savings at an intersection level can be better than the additive effect (or over-additive effect), depending on dwell time, distance from the bus stop to the stop line, traffic demand, and cycle length. In addition, analytical results suggest that at an arterial level, the combined effect on bus delay savings can be the over-additive effect with suitable signal offsets. These results are confirmed by a micro-simulation case study. Combined effects on arterial and side-street traffic delays are also discussed.     

基于碳化硅器件的高频化高效率船用变频器

碳化硅器件的应用能够显著减小电力电子变换器的重量、体积、成本,大幅提升电力电子系统的性能。本文基于碳化硅器件的高频化高效率船用变频器设计,采用电压源型双PWM交-直-交变频器系统拓扑结构,前级整流部分和后级逆变均使用最新一代碳化硅器件,提出有源前端(AFE)变频器系统拓扑结构、整流与逆变系统控制策略,以及主电路参数计算方法。系统仿真和试验结果表明,该设计方式是实现船用变频器高性能、小型化的有效技术途径。     

变邻域搜索求解公共交通乘务调度问题

公共交通乘务调度问题是一个将车辆工作切分为一组合法班次的过程,它是NP难问题,许多求解方法的效率都与班次评价密不可分,本文通过裁剪TOPSIS方法(Technique for Order Preference by Similarity to an Ideal Solution)设计了TOPSIS班次评价方法.此外,通过裁剪变邻域搜索算法使之适合求解乘务调度问题,提出了基于变邻域搜索的乘务调度方法(Crew Scheduling Approach Based on Variable Neighbourhood Search,VNS),其中,并入了TOPSIS班次评价方法在调度过程中进行班次评价,设计了两种带概率的复合邻域结构以增加搜索的多样性,帮助跳出局部最优,在VNS中利用模拟退火算法进行局部搜索.利用中国公共交通中的11组实例进行了测试,测试结果表明,VNS优于两种新近提出的乘务调度方法,且其结果关于班次数接近于下界.     

基于混合选择模型的汽车共享选择行为研究

为了深入分析出行者的汽车共享选择行为,首先以技术接受模型和计划行为理论为框架,将对汽车共享选择行为具有影响的心理因素整合到传统的离散选择模型之中,形成混合选择模型.然后,基于南京市的实证调查数据,运用混合选择模型对出行者的汽车共享选择行为进行研究.结果表明,出行者对于汽车共享的感知有用性、感知易用性、行为态度、知觉行为控制等心理态度潜变量对其选择行为产生显著的正向影响,混合选择模型比传统不带潜变量MNL模型对实证数据具有更高的拟合度.