南海风浪条件下Spar式浮式风机平台的构型及参数

使用WAMIT软件建立了OC3-Hywind Spar式浮式风机模型，联合FAST软件计算了浮式风机在不同工况下的幅值响应算子；结合为南海海域波浪条件优化后的JONSWAP谱，对浮式风机进行了不同工况下的响应谱分析及最大响应值计算；进一步阐述了浮式平台结构构型参数的变化对整体结构在南海相应工况下的运动影响。     

散杂码头设计中节能增效措施的应用

针对码头工程中如何多方位将节能增效措施融入到设计中的问题,以长江江苏段某散杂码头及其堆场的设计为例,在工艺、结构、电气等方面采用多方位比较的方法,工艺采用装船机、取料机和皮带机变频联动系统、旋转式过渡皮带车以及三工位头部伸缩装置等措施,结构方面陆域轨道基础采用新型专利,电气方面采用风光互补路灯及岸电系统等不同的节能增效措施,使项目更经济合理、效益显著。     

计及叶片载荷的双机对转式海流发电机系泊系统动力分析

本文设计了一种新型的双机对转式海流发电机并对其系泊系统与叶片载荷和直径关系进行模拟分析。首先将单机式海流发电机与已有研究进行对比验证其可靠性，然后在不改变系泊方式的前提下，设计出双机式结构，并通过分析机身位移和旋转比较两种系统的稳定性。为考虑叶片载荷对系泊系统影响，在Orcaflex中对不同精细程度的叶片进行建模，分别对比单一翼型/三翼型/九翼型的数值模拟结果。接着使用M-BEMT软件优化后的翼型参数，对比使用原始升阻力系数的三翼型发电机的模拟结果，同时将使用不同直径叶片的发电机系统进行对比，说明双机式发电机的稳定性更优，对海流发电机及其系泊系统的设计提供重要参考价值。     

海上风机支撑结构的时域和频域疲劳对比研究

对海上风机支撑结构进行动力响应分析,求出结构危险节点的载荷谱和功率谱密度函数,结合疲劳损伤模型和Dirlik概率模型,分别在时域和频域内对支撑结构进行疲劳寿命分析.由于时域法计算疲劳寿命需进行应力循环计数,这一过程需处理的数据庞大,耗时长.频域法省去应力循环计数,代之以概率密度函数,可相对准确、快速地计算结构的疲劳寿命.分析结果表明,采用Dirlik概率模型的频域分析法能较准确地反映海上风机支撑结构在随机载荷作用下的疲劳损伤情况,计算结果误差在可接受范围内.     

燃机动力学建模中复杂结构处理方法研究

提出了三种以动力学相似为基础的转子动力学建模关键技术,并以某型燃气轮机建模为例,对该关键技术进行了验证。利用三种方法,对该燃气轮机的动力学特性进行研究,并与整机试验结果进行了对比。结果表明,动力学分析的准确程度主要由模型决定,本文所提出的三种建模关键技术能够反映结构的真实特性,可用于具有类似结构的双转子系统。     

燃气向心透平的非定常流动特性研究

以燃气为工质的向心透平常用于微型燃气轮机系统中,有着重要的工程应用价值。本研究关注燃气向心透平的非定常流动特性,基于一台功率等级为1MW,转速为30000rpm的燃气向心透平,首先进行了热力设计,得到了其关键位置的燃气工质热力参数及透平的模型尺寸。其次基于三维粘性数值模拟计算的方法,采用SST k-ω湍流模型及六面体结构化网格在商用软件CFX中对燃气向心透平进行了定常与非定常气动计算,详细分析了其气动特性及非定常流动状况。最终,分析了这一燃气向心透平的非定常气流激振力在时域及频域分布,并准确评估了其流量、扭矩、功率及效率等关键参数。     

某型汽轮机超速脱扣试验浅析

某型汽轮机的超速保护装置采用脱扣结构,文章针对该汽轮机的超速脱扣结构进行分析,总结此种超速脱扣装置的装配要求和试验方法,以利于该型汽轮机的生产。     

非对称双体船片体构型及阻力性能的数值研究

对于海上风电双体运维船而言,兴波阻力是其总阻力的重要组成部分.本文基于CFD技术对非对称双体船进行初步研究,通过改变双体船左右片体角度以及改变单侧片体肥瘦程度来实现内外片体排水体积差的目的2个方面来研究非对称双体船的阻力性能,比较各方案的阻力,综合考虑最终得出最优方案,为今后双体风电运维船的船型设计与优化提供一个新的研究方向.     

The influence of fully nonlinear wave forces on aero-hydro-elastic calculations of monopile wind turbines

The response of an offshore wind turbine tower and its monopile foundation has been investigated when exposed to linear and fully nonlinear irregular waves on four different water depths. The investigation focuses on the consequences of including full nonlinearity in the wave kinematics. The linear and nonlinear irregular wave realizations are calculated using the fully nonlinear potential flow wave model OceanWave3D [1]. The linear and nonlinear wave realizations are compared using both a static analysis on a fixed monopile and dynamic calculations with the aeroelastic code Flex5 [2]. The conclusion from this analysis is that linear wave theory is generally sufficient for estimating the fatigue loading, but wave nonlinearity is important in determining the ultimate design loads.     

Time domain analysis procedures for fatigue assessment of a semi-submersible wind turbine

Long term time domain analysis of the nominal stress for fatigue assessment of the tower and platform members of a three-column semi-submersible was performed by fully coupled time domain analyses in Simo-Riflex-AeroDyn. By combining the nominal stress ranges with stress concentration factors, hot spot stresses for fatigue damage calculation can be obtained. The aim of the study was to investigate the necessary simulation duration, number of random realisations and bin sizes for the discretisation of the joint wind and wave distribution. A total of 2316 3-h time domain simulations, were performed.In mild sea states with wind speeds between 7 and 9 m/s, the tower and pontoon experienced high fatigue damage due to resonance in the first bending frequency of the tower from the tower wake blade passing frequency (3P).Important fatigue effects seemed to be captured by 1 h simulations, and the sensitivity to number of random realisations was low when running simulations of more than 1 h. Fatigue damage for the tower base converged faster with simulation duration and number of random realisations than it did for the platform members.Bin sizes of 2 m/s for wind, 1 s for wave periods and 1 m for wave heights seemed to give acceptable estimates of total fatigue damage. It is, however, important that wind speeds that give coinciding 3P and tower resonance are included and that wave periods that give the largest pitch motion are included in the analysis.