轻型货车轮胎接地压力分布实测

利用自主开发的轮胎接地压力测试仪,进行了轻型货车不同花纹和不同使用年限轮胎,在不同轮胎胎压和不同负荷作用下,轮胎的接地压力分布规律测量。实测结果发现:轻型货车轮胎与路面的接触形状更接近于矩形;新胎比旧胎的接地压力要均匀些;轮胎胎压与平均接地压力、轮胎负荷与平均接地压力、轮胎负荷与有效接地面积基本上呈线性关系。     

江苏省交通事故时间分布分析

根据江苏省有关交通事故数据,利用统计方法对交通事故发生的时间特征进行分析。通过分析交通事故年时间分布规律的波峰曲线,得出江苏省交通事故发生数量开始振荡变化,逐年上升的势头有望于近期遏制。通过分析交通事故、月、周、小时时间分布曲线,得出交通事故高峰小时出现在交通量高峰小时之后的9~12h、14~16h,两者不重合。死亡高峰时段(危险时段)多发生在18~21h的3h内。研究结论对不同时间内如何采取不同的安全对策来降低江苏省交通事故具有指导作用。     

船舶烧伤病房气流组织分析与优化

针对舰船舱室气流组织的形式特点,以烧伤病房作为研究对象建立数学模型,通过使用Airpak软件对烧伤病房不同设计方案下的气流组织进行了计算仿真,通过舱室温湿度,空气流速,热舒适指标等参数的对比,获得舱室的压力、温度、速度、热舒适性指标等的分布特性,对烧伤病房气流组织进行了分析并提出了优化方法,可以有效提高人员的舒适性和气流组织效果。     

挂篮底模纵梁受力简化计算方法及承重分配系数

以一桥梁施工工程实例为依托,采用有限元软件ANSYS对桥梁悬臂施工中使用的菱形挂篮进行仿真分析.提出3种简化模式计算底模纵梁的承重分配,对比发现将底模纵梁承受的外荷载简化为集中荷载,并分配至挂篮下前后横梁的方法是最优简化计算方法.在此基础上对挂篮底模纵梁承重分配系数进行优化,从而简化了繁琐的挂篮底模纵梁受力分析计算,保证了挂篮结构设计和施工的安全.     

Simulation on progressive collapse behaviour of whole ship model under extreme waves using idealized structural unit method

To ensure the safety of navigating ship, working loads and structural load-carrying capacity are two important aspects. In the present paper, a total simulation system combing load calculation and structural collapse analysis is applied to simulate progressive collapse behaviour of a single-hull Kamsarmax type bulk carrier. A three dimensional singularity distribution method is adopted to calculate pressure distribution with time history. A mixed structural model, collapse part simulated by ISUM elements and remaining part by elastic FEM elements with relative coarse mesh, is proposed for collapse analysis. Progressive collapse behaviour obtained by ISUM is good agreement with that by nonlinear software package, MARC. However, the calculation time of ISUM analysis is about 1/70 of MARC analysis. The applicability to structure system, high accuracy and sufficient efficiency of ISUM had been demonstrated.     

内压载荷下X80管道裂纹应力分布规律研究

为了研究内压作用下管道裂纹应力场分布规律,以含有表面裂纹的X80管道为研究对象,对不同形状、不同方向、不同内压、不同尺寸的含裂纹管道进行仿真分析和实验验证。结果表明:裂纹尖端处应力远大于裂纹中心应力。裂纹形状对应力影响作用较小,随着裂纹方向与管道轴向夹角增大,裂纹尖端应力先增大后减小,随着管道内压、裂纹深度、裂纹长度的增大,裂纹尖端处应力随之线性增大。其中,裂纹长度对裂纹尖端应力的影响小于管道内压和裂纹深度。     

格拉斯磁环匀强磁场分析

以毕奥-萨伐尔定律为基础,建立亥姆霍兹线圈以及格拉斯磁环中心磁场分布模型,并计算了它们内部的轴向磁感应强度分布,绘出了空间分布图,分析了轴向磁感应强度与x、y坐标的关系,分析结果得到了亥姆霍兹线圈和格拉斯磁环内部匀强磁场分布区域,通过比较得到格拉斯磁环内部的匀强磁场区域比亥姆霍兹线圈内部的匀强磁场分布区域更大的结论。     

柴油机排气污染物PM和NOx催化处理反应平台设计与应用

使用自行设计的程序温控的催化反应平台和模拟配气系统相连接,测试并获得催化剂的催化还原NOx和催化氧化PM的准确的催化性能数据.使用该催化反应平台和常柴CZ2102型柴油机实验平台相连接,获得在稀燃条件下介孔镧铈锆铝复合氧化物对PM和NOx的催化处理实验的应用数据.为同时去除柴油机排气污染物PM颗粒和NOx的工程应用打下坚实的基础.     

A copula-based approach for estimating the travel time reliability of urban arterial

Estimating the travel time reliability (TTR) of urban arterial is critical for real-time and reliable route guidance and provides theoretical bases and technical support for sophisticated traffic management and control. The state-of-art procedures for arterial TTR estimation usually assume that path travel time follows a certain distribution, with less consideration about segment correlations. However, the conventional approach is usually unrealistic because an important feature of urban arterial is the dependent structure of travel times on continuous segments. In this study, a copula-based approach that incorporates the stochastic characteristics of segments travel time is proposed to model arterial travel time distribution (TTD), which serves as a basis for TTR quantification. First, segments correlation is empirically analyzed and different types of copula models are examined. Then, fitting marginal distributions for segment TTD is conducted by parametric and non-parametric regression analysis, respectively. Based on the estimated parameters of the models, the best-fitting copula is determined in terms of the goodness-of-fit tests. Last, the model is examined at two study sites with AVI data and NGSIM trajectory data, respectively. The results of path TTD estimation demonstrate the advantage of the proposed copula-based approach, compared with the convolution model without capturing segments correlation and the empirical distribution fitting methods. Furthermore, when considering the segments correlation effect, it was found that the estimated path TTR is more accurate than that by the convolution model.