潜艇均衡系统自流注水调节阀稳态噪声试验研究

本文模拟建立了潜艇均衡系统自流注水试验系统,对不同假海压力、不同系统流量、不同出口背压及串联2台调节阀时自流注水稳定过程振动噪声进行研究。结果表明:潜艇均衡注水振动噪声随着假海深度的增大而增大;空气噪声随流量调节阀开度的增大而增大,在流量调节阀开度为60°-70°之间,振动加速度及水动力噪声产生峰值;在出口背压为0-0.5 MPa之间时,振动噪声值均大于无背压状态,峰值为0.2 MPa;串联2台流量调节阀可大幅降低自流注水振动噪声。     

Dynamic recrystallization behavior and microstructural evolution in SPHC steel

The dynamic recrystallization(DRX) behaviors in SPHC steel were investigated with hot compression tests at deformation temperatures of 950-1 150,strain rates of 0.1-15 s-1,and initial austenite grain sizes of 86-232 μm.The effects of deformation temperature,strain,strain rate and the initial austenite grain size on the microstructural evolution during DRX were studied in detail.The results show that DRX is observed under the condition of the Zener-Hollomon parameter being less than 1.07×10 13 s-1.The deformation activation energy for SPHC steel is calculated to be 299.4 kJ/mol by regression analysis.Austenite grain size of DRX is refined with decreasing temperature and increasing strain rate under steady state conditions,but it is not influenced by the initial grain size.The mathematical equation of DRX grain size of SPHC steel is obtained.     

舰船纵倾均衡移水过程瞬态噪声控制试验研究

本文模拟建立了舰船纵倾均衡移水试验系统,对不同移水压力、电液球阀启闭时间、管路固定方式等条件下移水过程中的瞬态噪声进行研究.结果表明:纵倾移水过程的瞬态噪声值呈曲线波动状态,最大振动加速度级和最大空气噪声值均发生在电液球阀关闭过程中,随着移水压力的增加,最大噪声值逐渐增大;电液球阀快速关闭时,移水管路存在明显的水锤现象,延长电液球阀的关闭时间,可以有效抑止系统水锤的冲击,降低移水过程中最大瞬态噪声值;移水管路采用弹性支撑方式,可有效降低移水管路的振动噪声.     

Static softening characteristics and static recrystallization kinetics of aluminum alloy A6082 after hot deformation

The static softening behavior of aluminum alloy A6082 was investigated by interrupted hot tests conducted on Gleeble-1500 simulator at deformation temperatures from 573 to 773 K and strain rates from 0.1 to 10 s⁻¹, with a pre-strain from 0.3 to 0.7 and variable inter-pass delay times. The offset method was applied to convert the changes in flow stress between two passes to static softening fraction. The microstructural changes were characterized by the quantitative metallography of quenched specimens. The results showed both static softening and static recrystallization curves exhibited a simple sigmoidal shape; the static softening is related to the static recrystallization in a nonlinear manner with 50% static recrystallized volume fraction corresponding to 80% static softening fraction; an increase in temperature, strain rate or pre-strain yields a decrease in the time for 50% static recrysallized volume fraction, on which the temperature has the most remarkable influence; Si and Mn additions accelerate the process of static recrystallization. Finally, the equations of static recrystallization kinetics of this alloy were developed with a good agreement between the predicted and experimental results.