浅层地下水开采对高速铁路工程的影响及对策

研究目的：研究掌握浅层地下水开采引起的地面沉降特征及其对高速铁路工程的影响,提出针对性的防治对策与工程措施,供高速铁路勘测、设计及施工参考。研究方法：结合华北平原地面沉降情况,建立浅层地下水开采引起地面沉降的固结沉降模型。研制离心场中地基抽水的模拟和测量系统,进行了离心模型试验,测量抽水过程中粉土地基孔隙水压力和沉降的变化及分布规律,并对比分析了对不同型式桥梁的影响。研究结果：对浅层地下水开采引起的地面沉降机理进行初步分析,基于离心模型试验结果探讨了浅层抽水引起地基沉降的过程和特征,评价了地基不均匀沉降对特殊桥梁形式的影响,并提出了针对性的防治措施和对策。研究结论：浅层地下水开采造成的不均匀沉降对高速铁路工程的影响较大,需通过控制线路附近地下水开采、采取适宜的工程结构措施加以防治。     

Analysis of Influence of Design Parameters on Steered Wheels Shimmy of Heavy Vehicles

In choosing the steering system parameters the tendency is towards the minimization of kinematic errors that appear during turning. For that developed procedures exist that take into account also the influence of kinematic of the suspension system on kinematic parameters of vehicle turning. Besides that, maintenance tests have shown, that increased deflections of the suspension system lead to increased wear of tires of steered wheels. In this paper, a method is developed for minimization of steered wheel shimmy and its wear also during the straight-line drive of heavy vehicles. The procedure can also be used in the phase of designing the heavy vehicles.     

沿海船舶油污损害赔偿的法律适用

对沿海油污损害赔偿在适用《国际油污损害民事责任公约》、《民法通则》、《中华人民共和国海洋环境保护法》《、防止船舶污染海域管理条例》《、海商法》等法律、法规时的有关情况及问题进行分析,得出如下结论:有涉外因素的船舶油污案件应优先适用国际公约;无涉外因素的沿海船舶油污案件应适用国内法,其中沿海船舶油污损害赔偿责任基础应适用《民法通则》,其责任限额应适用《海商法》及交通部《关于不满300总吨及沿海运输、沿海作业船舶海事赔偿限额的规定》。     

Identification of Vibration Parameters for Motor Vehicles

Identification of the vibration parameters of motor vehicles, as well as of dynamic systems in general, represents a complex problem. Many experimental-theoretical procedures have been proposed in order to solve the problem but there is no generally accepted method. The development of a method for the identification of the vibration parameters of motor vehicles is described in this paper. The identification of the unknown parameters is achieved by the use of experimental data applied to an vibration model with a known structure but unknown physical parameters. The methods of nonlinear programming are employed in the computations. The elastic and damping elements, including the tyres, are also by assumption nonlinear. Verification of the reliability of the method is carried out by using two vibration models of the vehicle - one with known and the other with unknown values of the vibration parameters.     

Temporal variations of water flow between the Venetian lagoon and the open sea

Long-term measurements of the water flow at three Venice Lagoon inlets with the bottom-mounted ADCPs show that the main part of the variance (>90%) is associated with the tidal variability. Semi-diurnal constituents (mainly M2 and S2) are responsible for about 80% of the flow variance. Phase-lag between the axial current and sea-level is on the order of 2 h for M2 and 4 h for the K1, the maximum inflow leading the sea-level maximum. Phase-difference of tidal flows between inlets shows that Chioggia leads both Malamocco and Lido, suggesting that tidal signal progresses northward, thus in the opposite direction of both the semi-diurnal and diurnal tidal signals in the open Adriatic currents. The sea-level slope between the open sea and the lagoon interior controls the inlet flow, which is due to the time lag being constant for all tidal constituents. It was shown that tidal oscillations at Punta Salute (lagoon interior) lag those in Lido by about 45 min. The pressure gradient due to the sea-level slope generates the flow acceleration. Only for large current speeds (>0.5 m/s), the bottom friction term becomes equally important as the local acceleration and the horizontal pressure gradient terms. Wind effects manifest as a remote forcing through Adriatic seiches at semi-diurnal and diurnal scales, and as a local forcing at very long time scales on the order of a month. This latter mechanism is limited to a winter period (November–January). Seiches are present over the entire year, being however, more energetic and frequent during autumn and winter.     

The Definition of the Tires Limit of Admissible Nonuniformity by Using the Vehicle Vibratory Model

Purpose of this article was to especially emphasize the contribution of tires nonuniformity radial and lateral force variation to vehicles vibrations, within developed nonlinear dynamic model of a vehicle. The tire nonuniformity force variations are introduced in simulations processes by radial and lateral dynamic forces in the area of wheels-road contact. The limits of admissible Peak - to - Peak radial and lateral force variation and Peak - to - Peak first harmonic radial and lateral force variation nonuniformity were defined by using a vehicle vibratory model. The tire nonuniformity parameters were defined from the aspect of vertical seat cushion and the steering wheel rim vibrations using the developed optimization program and the Pentium 90 MHz computer.