碳纤维技术在桥梁加固工程中应用的探讨

通过对比跨度32 m铁路预应力混凝土梁用不同方法加固前后的力学性能,研究碳纤维加固技术应用的适宜场合。研究结果表明:在抗弯加固方面,碳纤维加固更适合于原结构高度较小、配筋较少、荷载变化不大的构件;对于梁高大、配筋多、活载作用大的桥梁,特别是预应力混凝土梁,因新增碳纤维的面积远远小于实体梁面积,加固后构件的刚度,钢筋应力的改善有限,其加固的效果不如预应力加固。采用黏贴碳纤维布的加固方法基本无法提高实体梁的抗裂性能,但在梁体开裂后,碳纤维对梁体的裂缝发展有较好的约束作用。     

汽车用碳纤维复合摩阻材料的摩擦磨损特性研究

在采用正交设计优化碳纤维复合摩阻材料的基础上，针对汽车制动器衬片的实际工况，研究了碳纤维复合摩阻材料的摩擦磨损特性及磨损机制分析了碳纤维含量、强度及表面状态等对磨损机制的影响。研究结果表明，碳纤维复合摩阻材料的磨损性能、工作寿命及抗热衰退性能均明显高于传统的石棉摩阻材料。     

柴油、乳化油和甲醇喷雾燃烧光强波的研究

探讨了柴油机燃烧光强波的性质。在不同压力、氧浓度的条件下，对柴油、乳化油、甲酵喷雾的燃烧光强波进行了测量分析。结果表明，柴油机的燃烧光强波所反应的是火焰内碳粒的氧化历程。对于不同的燃料，燃烧光强波的强弱并不仅仅取决于火焰中碳粒的数量，同时还取决于火焰中的氧浓度。     

Flying with climate liability? Economic valuation of voluntary carbon offsets using forced choices

This study aims to examine how key aspects of voluntary climate action influence economic values of aviation carbon offsets using an Australian case study, where voluntary carbon offset programs for the aviation sector were active under a carbon tax between July 01, 2012 and July 17, 2014. An online survey was administered during the period using choice experiments. This rare and short-lived Australian experience is useful to gain insights into how individuals respond to the new public policy in terms of the perceived economic value of voluntary offsets for air travel. According to the estimation results, supporters of the mandatory tax policy held a welfare value of voluntary carbon offsets for their domestic flights that is three times larger than non-supporters (i.e., $AU27.83 vs. $AU9.40). It is $AU12.27 on average per ton of carbon offsets per person for domestic flights and $AU0.92 for international long-haul flights. The findings endorse that individuals seem to attach personal responsibility for carbon emissions (i.e. climate liability or carbon conscience) to frequent domestic flights, but not so much to intercontinental flights. Furthermore, reported flight frequencies by respondents did not place any significant impact on economic values of voluntary carbon offsets in both domestic and international frameworks. A coupled approach between forced choices and certainty responses was adapted, where no-choice options were retrieved, potentially improving choice experiments. Results suggest that airlines should consider simplifying their carbon offset programs to fixed levels (e.g. £3, £10, and £20 as in the case of British Airways), regardless of geographical boundaries, while governments should promote both mandatory and voluntary climate measures in tandem.     

Effects of battery chemistry and performance on the life cycle greenhouse gas intensity of electric mobility

Lithium traction batteries are a key enabling technology for plug-in electric vehicles (PEVs). Traction battery manufacture contributes to vehicle production emissions, and battery performance can have significant effects on life cycle greenhouse gas (GHG) emissions for PEVs. To assess emissions from PEVs, a life cycle perspective that accounts for vehicle production and operation is needed. However, the contribution of batteries to life cycle emissions hinge on a number of factors that are largely absent from previous analyses, notably the interaction of battery chemistry alternatives and the number of electric vehicle kilometers of travel (e-VKT) delivered by a battery. We compare life cycle GHG emissions from lithium-based traction batteries for vehicles using a probabilistic approach based on 24 hypothetical vehicles modeled on the current US market. We simulate life-cycle emissions for five commercial lithium chemistries. Examining these chemistries leads to estimates of emissions from battery production of 194–494 kg CO₂ equivalent (CO₂e) per kWh of battery capacity. Combined battery production and fuel cycle emissions intensity for plug-in hybrid electric vehicles is 226–386 g CO₂e/e-VKT, and for all-electric vehicles 148–254 g CO₂e/e-VKT. This compares to emissions for vehicle operation alone of 140–244 g CO₂e/e-VKT for grid-charged electric vehicles. Emissions estimates are highly dependent on the emissions intensity of the operating grid, but other upstream factors including material production emissions, and operating conditions including battery cycle life and climate, also affect life cycle GHG performance. Overall, we find battery production is 5–15% of vehicle operation GHG emissions on an e-VKT basis.     

CFRP加固损伤钢板的拉伸及疲劳性能研究

文章基于Dugdale模型理论提出CFRP加固含裂纹钢板加固量的计算方法。通过虚拟裂纹闭合法建立模型来模拟塑性钢板的破坏过程,并完成相关试验,验证了CFRP加固含裂纹钢板有效粘贴长度、有效粘贴宽度取值的有效性。同时利用Paris公式预估疲劳寿命,并结合相关试验数据,探究了CFRP加固对含裂纹钢板疲劳寿命的提高作用。研究表明,有效粘贴长度、有效粘贴宽度的理论取值有效;通过CFRP双侧加固竖裂纹、斜裂纹钢板构件可分别使其疲劳寿命得到显著提高。     

A multi-objective optimization model for sustainable logistics facility location

This paper offers an exploratory study of sustainable facility location. The methodology, based on the classical uncapacitated facility location problem, provides decision makers with a multi-objective optimization model to determine the trade-off among economic, service and environmental considerations. Our results indicate that it may be desirable to open more facilities than optimal from a narrow economic perspective to reduce the carbon dioxide emissions of transport and to improve service reliability.     

碳纤维复合材料与铝合金连接方式选型研究

多材料混合车身设计是汽车轻量化的重要手段,其中铝和碳纤维的连接是轻量化车身结构设计和工艺装配面临的挑战。研究了SPR、FDR、抽芯铆钉3种连接方式及结构胶应用于碳纤维复合材料和铝合金异种材料的连接,测定了连接结构的剪切和十字拉伸性能,分析了连接方式和结构胶对力学性能和失效模式的影响,旨在指导碳纤维复合材料连接设计与选择。     

高速公路炭质页（泥）岩路堤变形特性研究

文章依托六寨至河池高速公路项目,介绍了炭质页岩的工程特性、化学组成及物理力学性质,研究了复杂应力条件下炭质页岩路堤的湿化变形特性,并提出了相应的技术参数选取要点和变形控制措施。     

Modeling the relationships among urban passenger travel carbon dioxide emissions,transportation demand and supply,population density,and proxy policy variables

To support the development of policies that reduce greenhouse gas (GHG) emissions by encouraging reduced travel and increased use of efficient transportation modes, it is necessary to better understand the explanatory effects that transportation, population density, and policy variables have on passenger travel related CO₂ emissions. This study presents the development of a model of CO₂ emissions per capita as a function of various explanatory variables using data on 146 urbanized areas in the United States. The model takes into account selectivity bias resulting from the fact that adopting policies aimed at reducing emissions in an urbanized area may be partly driven by the presence of environmental concerns in that area. The results indicate that population density, transit share, freeway lane-miles per capita, private vehicle occupancy, and average travel time have a statistically significant explanatory effect on passenger travel related CO₂ emissions. In addition, the presence of automobile emissions inspection programs, which serves as a proxy indicator of other policies addressing environmental concerns and which could influence travelers in making environmentally favorable travel choices, markedly changes the manner in which transportation variables explain CO₂ emission levels.