| 利用可编程控制器对立式车床的改造 |
| |
| 引用本文： | 吴海燕.利用可编程控制器对立式车床的改造[J].机电设备,2007,24(12):33-36. |
| |
| 作者姓名： | 吴海燕 |
| |
| 作者单位： | 威海职业学院,威海,264210 |
| |
| 摘 要： | 用可编程控制器对立式车床(C5116A)进行改造,在机床原有的操作方式和机床的主电路不变的情况下,使机床的控制线路大为简化,从而使机床故障率降低.文中提出了总体构思,设计出了PLC的梯形图及接线图,列出了改造后各电器元件的代号与老图纸的代号的对照表.并介绍了部分电路的调试过程.
|
| 关 键 词： | PLC 软件编程 梯形图 调试 |
| 文章编号： | 1005-8354(2007)12-0033-04 |
| 修稿时间： | 2007年7月29日 |
Rebuilding the vertical lathe with PLC |
| |
| WU Hai-yan.Rebuilding the vertical lathe with PLC[J].Mechanical and Electrical Equipment,2007,24(12):33-36. |
| |
| Authors: | WU Hai-yan |
| |
| Abstract: | C5116A vertical lathe was rebuilt with PLC. Under the precondition of no change of the lathe's original operating mode and main circuits,its control circuits were simplified greatly to make its fault ratio reduced. The paper proposed the overall design,gave the ladder chart and wiring scheme of PLC,presented the comparison table of code name of the rebuilt electric components to that of the previous blue print,finally introduced the debugging process of the partial electric circuits. |
| |
| Keywords: | PLC software programming ladder chart debugging |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
