首页 | 本学科首页   官方微博 | 高级检索  
     

玉米秸秆纤维沥青混合料路用性能及机理分析
引用本文:李振霞,陈渊召,周建彬,孙爽,刘津源,李政辰,王琪琛. 玉米秸秆纤维沥青混合料路用性能及机理分析[J]. 中国公路学报, 2019, 32(2): 47-58
作者姓名:李振霞  陈渊召  周建彬  孙爽  刘津源  李政辰  王琪琛
作者单位:1. 华北水利水电大学土木与交通学院, 河南郑州 450045;2. 中铁工程设计咨询集团有限公司 郑州设计院, 河南郑州 450001;3. 河南师范大学新联学院土木建筑工程学院, 河南郑州 450018;4. 南阳市第一中学, 河南南阳 473001;5. 爱荷华大学土木与环境工程系, 爱荷华爱荷华城 IA52242
基金项目:河南省重点研发与推广专项科技攻关项目(182102210061,182102310028);郑州市环境友好型高性能道桥材料重点实验室开放基金项目(郑科[2018]100号)
摘    要:为分析玉米秸秆纤维沥青混合料路用性能及纤维作用机理,首先采用高速剪切法对"除芯"的饱水玉米秸秆破碎处理,通过提取比例及吸油倍数指标优选得到纤维最佳制备工艺,并对其基本技术性能进行分析;然后分别评价无纤维、木质素纤维和玉米秸秆纤维沥青混合料的高温稳定性、水稳定性、低温抗裂性及高温抗剪性;最后应用红外光谱分析纤维与混合料的键合作用,利用扫描电镜从微观角度揭示两者之间的作用机理。结果表明:玉米秸秆纤维最佳制备工艺为长度10±2 mm秸秆皮浸泡4 h后,在29 000 r·min-1转速下破碎2 min;玉米秸秆纤维、木质素纤维沥青混合料动稳定度均提升20%左右、弯拉应变均增加3.5%左右;木质素纤维、玉米秸秆纤维沥青混合料光谱图为纤维分别与沥青混合料光谱图的叠加,加入纤维后并没有产生表征新化合物出现的波峰,纤维与混合料主要依靠物理黏结作用结合在一起;玉米秸秆纤维表面更加粗糙、长径比更大、更容易分散均决定了其改善效果优于木质素纤维,纤维对沥青的吸附作用能够降低混合料的温度敏感性,纤维的无规则分布在混合料内形成三维网状结构,具有串联骨架功能,在沥青混合料初始开裂时起到拉伸作用,阻止裂缝进一步扩展。

关 键 词:道路工程  作用机理  试验研究  玉米秸秆纤维沥青混合料  微观分析  
收稿时间:2018-02-04

Analysis of Road Performance and Fiber Mechanism for Corn Stalk Fiber Asphalt Mixture
LI Zhen-xia,CHEN Yuan-zhao,ZHOU Jian-bin,SUN Shuang,LIU Jin-yuan,LI Zheng-chen,WANG Qi-chen. Analysis of Road Performance and Fiber Mechanism for Corn Stalk Fiber Asphalt Mixture[J]. China Journal of Highway and Transport, 2019, 32(2): 47-58
Authors:LI Zhen-xia  CHEN Yuan-zhao  ZHOU Jian-bin  SUN Shuang  LIU Jin-yuan  LI Zheng-chen  WANG Qi-chen
Abstract:To analyze the road performance and fiber mechanism of a corn straw fiber asphalt mixture, water-saturated and decored corn straw were broken using the high-speed shearing method. The optimum preparation process of the fiber was determined according to the extraction ratio and oil absorption, and its basic technical performance was analyzed. The high-temperature stability, water stability, low-temperature crack resistance, and high temperature shear resistance of asphalt, lignin fiber asphalt, and corn straw fiber asphalt mixtures were evaluated. Finally, the bonding action between the fiber and asphalt mixture was analyzed using infrared spectroscopy and the bonding mechanism determined from the microcosmic angle. The optimum preparation process of corn straw fiber was as follows:10±2 mm long straw skin soaked for 4 h, then broken for 2 min at 29 000 rpm. The dynamic stability of the corn straw fiber asphalt and lignin fiber asphalt mixtures increased by 20% and their flexural strains decreased by 3.5%. The spectral images of the lignin fiber asphalt and corn straw fiber asphalt mixtures are superpositions of the spectra of the two kinds of fibers and asphalt mixtures. After adding fiber, no wave peaks originating from newly generated compounds were observed. The fiber and asphalt stick together due to physical bonding. The improvement of the corn straw fiber properties was more significant than that of the lignin fiber, due to its rough surface, larger diameter ratio, and easier dispersion. The temperature sensitivity of the mixture was decreased by adsorption of the fiber on asphalt and the random fiber distribution formed a three-dimensional network structure in the mixture. The series of frameworks and their associated tensile effect prevented cracks from expanding further when initial cracking of asphalt mixture occurred.
Keywords:road engineering  action mechanism  experimental research  corn straw fiber bitumen mixture  microanalysis  
本文献已被 CNKI 等数据库收录!
点击此处可从《中国公路学报》浏览原始摘要信息
点击此处可从《中国公路学报》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号