Performance Analysis of Schemes in Fixed Two Frequency Reuse Relay Systems

An upsurge of interest in relay-augmented infrastructure-based networks has appeared in recent years. Radio resource management in such relay systems has great influence on the system performance. How to utilize the limited frequency resources efficiently in the system is a hot research topic. In this paper, performance of frequency reuse schemes has been studied in fixed relay systems. A novel scheme is achieved by modifying an existing one. Theoretical model is proposed for the performance analysis of two schemes. Both the theoretical analysis and simulation results show that the modified scheme outperforms the existing one not only in power consumption of mobile stations but also in cell carrier-to-interference ratio coverage.     

Uplink Power Saving Potential of Cellular System with Fixed Relays

This paper presented a scheme of relayed cellular mobile telecommunication network, which only employs fixed digital relays and not more than two-hop relay routes. Power saving potential of the network is deeply studied under the assumption of not occupying additional frequency bands （i. e. relays share the same frequency bands as used by the base stations）. Theoretical analysis and simulation results have both shown that, with the same radio coverage requirement, the necessary effective transmission powers in such a relayed network have greatly decreased compared to conventional cellular network.     

General precoder design for mitigation of intercarrier interference in OFDM mobile systems

For orthogonal frequency-division multiplexing （OFDM） communication systems, the frequency offset in mobile radio channels distorts the orthogonality between sub-carriers, which results in Intercarrier Interference（ICI） and seriously degrades the performance of systems. Based on ICI coefficients analysis, a novel preceder design scheme is proposed for mitigation of ICI. In this technique, preceder matrix is designed by the way of linear counteraction and inserted in the former transmitter signal. Computer simulation results show that this new scheme can effectively reduce ICI and significantly provide the carrier-interference power ratio improvement. Compared with existing ICI mitigation schemes with channel estimation, the proposed scheme has lower computational complexity, and compared with self- cancellation scheme, the bandwidth efficiency can be improved in this proposed scheme. The proposed scheme also has better convergence stability for time-varying frequency selective fading channel.     

全双工中继选择策略的性能研究

为了提高协同通信系统的频谱效率,对全双工中继通信系统进行了研究.首先,介绍了传统的主动机会中继策略和最优的全双工中继选择策略,并在最优全双工中继选择策略的基础上提出了增强型全双工中继选择策略;其次,分析了主动机会中继选择策略应用在全双工中继网络中的中断性能,推导了3种策略中断概率的闭式精确结果和高信噪比(SNR)下的近似逼近结果;最后,通过数值仿真分析验证了理论推导结果的正确性.研究结果表明:在高SNR范围时,最优全双工中继选择策略和主动机会中继选择策略的中断性能趋于平台效应;增强型全双工中继选择策略的中断性能会随着SNR的增大而一直提高,且增强型全双工中继选择策略的中断性能明显最优,主动机会中继选择策略的性能最差.      

Interference and Spectral Efficiency Analysis in Two-hop Cellular Network with Fixed Relays in FDD Mode

IntroductionRelaying is well known for its potential of ex-tending the high data rate coverage of a single basestation and reducing infrastructure deploymentcosts. Moreover, it is efficient in solving the cov-erage problem behind the obstacles and eliminatingblack spots, which even can not be solved by intro-ducing smart antenna technology[1,2]. Some dumbrelays (analog repeaters) have been adopted[1]in2 G and 3 G systems. But in such scenarios, thesignals received are forwarded without any si…     

Random Channel Allocation Scheme for SDMA Systems

A random allocation scheme for SDMA systems is proposed with a goal of more efficient dynamic allocation. Based on theoretical analysis and derivation, the blocking probability of the proposed scheme is calculated and compared with those of the ftrst duplicate （FD） and duplicate last （DL） schemes with different state-independent probabilities （p,） of acquring a dupicate channel suecessfully and 5 resources; moreover, a more realistic performance analysis of the random scheme is made with state-dependent ps in the SDMA/CDMA environment. The results show that the random scheme has a similar allocation pefformace to the FD and DL schemes, but is simpler than them in computation and scheduling.     

An Efficient Provable Secure ID-Based Proxy Signature Scheme Based on CDH Assumption

IntroductionMambo, et al.[1]first introduced the conceptof proxy signature. In their scheme, an originalsigner delegates his signing right to a proxy signerin such a way that the proxy signer can sign anymessage on behalf of the original signer and theverifier can verify and distinguish proxy signaturefrom original signature. Proxy signature is of greatuse in such a case that a manager needs to autho-rize his secretary to sign documents on behalf ofhimself before his leaving for a vacation. Du…     

Resource Partitioning and Routing Optimization in Relay Enhanced Cellular Network

A joint routing and resource partitioning scheme were proposed to improve cell capacity and user throughput of cellular network enhanced with two-hop fixed relay nodes (FRNs). Radio resources are partitioned under a reuse partitioning based framework, which guarantees effective and efficient inter-cell interference management. At the same time, each mobile terminal was assigned a channel-dependent route by the routing controller, which tries to maximize the cell capacity under the constraint imposed by reuse partitioning. Intensive computer simulations demonstrate the performance superiority of the FRN enhanced cellular network employing this scheme in comparison with conventional network, as well as the validity of the channel-dependent routing mechanism.     

基于OMAP-L137的铁路配电所馈线保护装置的研制

本文提出了基于OMAP-L137的铁路配电所馈线保护装置的设计方案。该方案采用了TI公司推出的双核数字信号处理器OMAP—L137芯片为核心,在设计中利用了双核处理器的DSP核进行运算以及ARM核进行接口控制,双核芯片的各自优势得到了充分的发挥,保护装置的处理速度和运算精度很大程度上得到了提高。在此基础上介绍了本保护装置的软、硬件结构,保护配置原理及判据。     

10kV供电系统继电保护的选择性应用

综合继电保护在港口10kV供电系统中为保证港口的正常运营起到了举足轻重的作用。结合实际情况,针对港口供电系统的特点,提出相关的保护方式和整定值计算原则,有利于进一步规范港口10kV变电站继电保护的定值计算和管理工作。     

Joint Tomlinson-Harashima source and linear relay precoder design in amplify-and-forward multiple-input multiple-output two-way relay systems

Existing minimum-mean-squared-error (MMSE) transceiver designs in amplified-and-forward (AF) multiple-input multiple-output (MIMO) two-way relay systems all assume a linear precoder at the sources. Nonlinear source precoders in such a system have not been considered yet. In this paper, we study the joint design of source Tomlinson-Harashima precoders (THPs), relay linear precoder and MMSE receivers in two-way relay systems. This joint design problem is a highly nonconvex optimization problem. By dividing the original problem into three sub-problems, we propose an iterative algorithm to optimize precoders and receivers. The convergence of the algorithm is ensured since the updated solution is optimal to each sub-problem. Numerical simulation results show that the proposed iterative algorithm outperforms other algorithms in the high signal-to-noise ratio (SNR) region.     

MODIFIED AUTOMATIC TUNING OF PI/D CONTROLLERS BASED ON PHASE AND AMPLITUDE MARGIN SPECIFICATIONS

ＩｎｔｒｏｄｕｃｔｉｏｎＩｎｐｒｏｃｅｓｓｃｏｎｔｒｏｌ，ｍｏｒｅｔｈａｎ９５％ｏｆｔｈｅｃｏｎｔｒｏｌｌｏｏｐｓａｒｅｏｆＰＩＤｔｙｐｅ［１］．Ｔｈｅｍａｉｎｒｅａｓｏｎｉｓｉｔｓｒｅｌａｔｉｖｅｌｙｓｉｍｐｌｅｓｔｒｕｃｔｕｒｅ，ｗｈｉｃｈｃａｎｂｅｅａｓｉｌｙｕｎｄｅｒｓｔｏｏｄａｎｄｉｍｐｌｅｍｅｎｔｅｄｉｎｐｒａｃｔｉｃｅ，ａｎｄｔｈａｔｍａｎｙｓｏｐｈｉｓｔｉｃａｔｅｄｃｏｎｔｒｏｌｓｔｒａｔｅｇｉｅｓ，ｓｕｃｈａｓｍｏｄｅｌｐｒｅｄｉｃｔｉｖｅｃｏｎｔｒｏｌ，ａｒｅｂａｓｅｄｏｎｉ…     

Comments on enhanced yoking proof protocols for radio frequency identification tags and tag groups

A radio frequency identification (RFID) yoking proof scheme can generate proofs of simultaneous presence of two tags in the range of a specified reader so that an off-line verifier can verify the proofs later. This proof has found several interesting applications. However, many existing RFID yoking schemes are vulnerable to replay attacks. To overcome the weaknesses, Cho et al. proposed a new RFID yoking proof protocol and a new grouping protocol. Unfortunately, Cho et al.’s schemes are still vulnerable to replay attacks. In this paper, in addition to demonstrating weaknesses, we further discuss the rationale behind these weaknesses to provide a guide line for designing secure RFID yoking schemes. Based on the guide line, we propose a new RFID yoking scheme and a new RFID grouping scheme. Performance evaluation shows that our scheme outperforms its counterparts.     

Admission control scheme for handover service in high-speed train communication system

Admission control in high-speed train communication system is quite different from admission control in traditional cellular networks. Conventional admission control strategies cannot be directly applied to this special communication scenario. In this paper, the problem of admission control for handover service is investigated in high-speed train communication environment. An admission control scheme considering bit error rate(BER)and bandwidth borrowing strategy is proposed. On the basis of admission control decision rule taking BER into account, a part of bandwidth obtained by compressing variable rate service in the networks is provided for handover services. The admission control scheme can admit handover services as more as possible while it guarantees the lowest data rate of different services in the networks. Simulation results show that the proposed admission control scheme has a better performance than existing admission control schemes.     

邢临高速微机继电保护的常见故障及处理措施

继电保护装置是供电系统安全正常运行的重要保证。针对继电保护装置容易发生的故障,分析并提出抗干扰的措施以及继电保护工作注意事项,以供同行参考。     

路侧交通流量雷达系统分析与设计

根据实际提出了车流量检测雷达系统的性能技术参数要求,确定了系统实际的工作频段和工作体制,并进行了方案论证。提出了一套基于ARM和DSP双处理器的路侧雷达交通流量监控系统,给出了系统软、硬件结构设计方案,为交通流量雷达系统设计提供完整的理论指导和参考。     

Computer-aided detection for CT colonography

CT colonography （CTC） is a non-invasive screening technique for the detection of eolorectal polyps, as an alternative to optical colonoscopy in clinical practice. Computer-aided detection （CAD） for CTC refers to a scheme which automatically detects colorectal polyps and masses in CT images of the colon. It has the potential to increase radiologists＇ detection performance and greatly shorten the detection time. Over the years, technical developments have advanced CAD for CTC substantially. In this paper, key techniques used in CAD for polyp detection are reviewed. Illustrations about the performance of existing CAD schemes show their relatively high sensitivity and low false positive rate. However, these CAD schemes are still suffering from technical or clinical problems. Some existing challenges faced by CAD are also pointed out at the end of this paper.     

高速铁路自然过分相方案

在深入研究机车带负荷过分相产生电弧机理的基础上,提出了自然过分相技术方案.该方案的基本原理是在车载变压器高压侧和牵引供电臂末端分别并联一个电容,当机车过分相时,牵引网和车载电气传动系统实现等电位分离,避免了机车过分相时产生电弧.自然过分相方案和现在使用的3种方案相比,具有过分相断电时间短,结构简单,投资少,运行维护量小等优点.自然过分相方案还能大幅度降低机车运行时离线电弧的强度.     

郑州市科学大道-西三环互通式立交工程方案选型设计探讨

从预测交通量分析出发,结合互通式立交功能、既有构造物等建设条件,对互通式立交型式进行方案综合比选,从而推荐出功能完善、与既有构造物衔接良好、造价较低的互通方案。     

Joint dirty paper coding and linear receiver design for multiuser MIMO broadcast channels

A multiuser multiple input multiple output （MIMO） broadcast scheme was proposed through applying dirty paper coding （DPC） at the transmitter and linear equalization at the receiver. Assuming single data stream communication for each user, joint transmitter and linear receiver design were done to enhance the system performance. Furthermore, a multiuser scheduling algorithm was presented to exploit multiuser diversity when the number of the users is larger than that of transmit antennas. The proposed system achieves the sum rate close to the Sato bound and is superior to some of the existing schemes.