共查询到20条相似文献,搜索用时 140 毫秒
1.
通过有源电力滤波器来抑制柴油电力船系统的系统范围谐波,使有源电力滤波器连接到第二条总线上,通过电流功率检测谐波的方法来获得电路上的谐波,传给有源电力滤波器,使用滞环控制的方法来获取滤波器电流,同时还包含了LCL滤波器的配置,以此来降低两条总线上的谐波,结果表明,这种方法确实可以降低柴油电力船系统的谐波。 相似文献
2.
3.
4.
本文主要介绍了一种基于虚拟仪器技术的通过测量电压电流来测量大容量电容的方法。该方法是通过数据采集卡对外围电路进行数据采集,然后通过计算机进行处理,并用VisualBasic编程通过采集卡的输出端来控制外围电路,从而快速准确的测量大容量电容。 相似文献
5.
6.
从边界积分方程出发,介绍利用边界元素法来进行舰船磁场延拓的方法。通过船模实验验证了该方法的有效性,实验表明该方法具有较强的工程实际意义。 相似文献
7.
8.
9.
10.
11.
水下潜器是一种非常重要的海洋开发装置,具有强耦合、非线性等特点。主要讨论水下无人潜器的自主定深和定位控制技术。文中根据潜器的6自由度运动方程,在充分考虑了水动力因素的基础上,使用Quasi-Lagrange方程建立潜器的数学模型,并将其分解为一系列相互关联的子系统。采用滑模控制方法用于潜器的定深控制,并对其他方向运动进行定位控制。滑模因控制算法简单、鲁棒性好、可靠性高,并且不需要系统整体模型,被广泛应用于运动控制和非线性系统的控制中。通过计算机仿真,验证了该控制算法对水下潜器的运动控制效果良好、准确。 相似文献
12.
为了实现船舶压载水杀菌装置能量的协同管理,针对紫外线与超声波联合处理(UV/US)压载水管理系统,提出一种基于模糊逻辑控制的杀菌装置能量协同管理策略,选取压载水水质浊度和藻类丰度的变化情况作为模糊逻辑控制系统的输入变量,经模糊推理确定UV/US压载水管理系统各杀菌单元的工作模式;根据UV与US在系统运行过程中的权重关系,建立UV杀菌单元的仿真模型,并搭建UV藻类灭活试验平台,验证UV/US模糊逻辑控制策略的可行性。结果表明:UV/US压载水管理系统及其模糊逻辑控制策略在满足压载水排放性能标准的同时,可以实现各杀菌单元能量的最优控制,降低系统的能耗。 相似文献
13.
文章研究了积分变结构控制在自主水下机器人(AUV)航向控制系统中的应用,建立了AUV水平面的非线性模型,并在特定的工作点对模型进行了线性化处理,得到了AUV的控制设计线性模型.根据变结构控制理论设计了积分变结构控制器,并给出了消除抖振的方法.仿真试验验证了该设计方法的有效性. 相似文献
14.
颜料及包覆颜料对光固化涂料耐蚀性能的影响 总被引:7,自引:3,他引:4
研究了光固化涂料中颜料和经过包覆改性后的颜料对涂层耐蚀性能的影响。交流阻抗实验测试结果表明颜料对涂层的耐蚀性有很好地增强作用,并结合扫描电镜分析了颜料对涂层耐蚀性提高的原因。此外,利用硬脂酸和硬脂酸盐对群青表面进行改性,结果表明硬脂酸包覆过的颜料涂层阻抗值最大,涂层耐腐蚀性能最好,并就包覆颜料对涂层的耐蚀机理进行了探讨。 相似文献
15.
为提高有效氯溶液对船舶尾气同时脱硫、脱硝的性能,将紫外光(UV)辐照与有效氯溶液相结合,开展脱硫、脱硝试验。基于UV-鼓泡光催化反应器搭建模拟实验平台,进行UV辐照和无UV辐照环境下氧化溶液脱硫脱硝的对比试验和UV灯的功率、有效氯的浓度等因素对脱除率影响的试验。结果表明:在40℃的气液反应温度下,UV辐照能大幅度提高浓度为250 mg/L[CL2]的有效氯溶液对模拟烟气中NO、NOX和SO2的脱除能力;UV灯的功率从5W增加到16W,NO和NOX的脱除率近乎线性上升;将有效氯的浓度从250 mg/L[CL2]升高至1 500 mg/L[CL2],NO和NOX的脱除率缓慢上升;有效氯溶液对SO2的脱除率始终为100%。此外,对可能的反应机理进行了分析。 相似文献
16.
LIU Jian-cheng LIU Xue-min XU Yu-ruCollege of Shipbuilding Engineering Harbin Engineering University Harbin China 《船舶与海洋工程学报》2002,1(1):21-25
In this paper, maximum-likelihood (ML) and its relaxation algorithm, which are used to identify the mathematicsmodel of an underwater vehicle(UV), arc discussed. With the trial data of zigzag tests, the hydrodynamic derivatives of theUV were estimated, and the relaxation algorithm is confirmed to have better astringency from the contrast between the twomethods.Then a simulation environment based on these parameters is established to verify the validity and effect of these meth-ods. The result shows the model is credible and the methods are very useful for the research of maneuverability and adaptivecontrol of underwater vehicles. 相似文献
17.
18.
19.
20.
A numerical analysis based on the boundary element method (BEM) was presented for the hydrodynamic performance of a high skew propeller (HSP) which is employed by an underwater vehicle (UV). Since UVs operate at two different working conditions (surface and submerged conditions), the design of such a propeller is a cumbersome task. This is primarily due to the fact that the resistance forces as well as the vessel efficiency under these conditions are significantly different. Therefore, some factors are necessary for the design of the optimum propeller to utilize the power at the mentioned conditions. The design objectives of the optimum propeller are to obtain the highest possible thrust, minimum torque, and efficiency. In the current study, a 5-bladed HSP was chosen for running the UV. This propeller operated at the stern of the UV hull where the inflow velocity to the propeller was non-uniform. Some parameters of the propeller were predicted based on the UV geometrical hull and operating conditions. The computed results include the pressure distribution and the hydrodynamic characteristics of the HSP in open water conditions, and comparison of these results with those of the experimental data indicates good agreement. The propeller efficiency for both submerged and surface conditions was found to be 67% and 64%, respectively, which compared to conventional propellers is a significantly higher efficiency. 相似文献