共查询到20条相似文献,搜索用时 109 毫秒
1.
3.
发动机进气道积炭对现代汽车发动机影响很大,会使汽车的动力性下降、经济性变差、排放超标、可靠性变差,影响汽车的正常运行。本文通过对进气道积炭的形成机理以及积炭的存在部位和形式进行分析,并在此基础上分析进气道积炭对汽车发动机性能的影响,从而说明了汽车电控发动机进气道积炭防治的必要性,并提出了预防及清除的方法。 相似文献
4.
5.
6.
7.
进气门积炭影响行驶性能和排放,能否通过观察发动机传感器的数据来判断进气门是否有积炭呢? 相似文献
8.
积炭产生的原因电喷发动机易产生积炭的部位主要有气门、燃烧室和进气管,这是由电喷发动机工作特点决定的。首先,电喷发动机汽缸每次工作时都是先喷油再点火,在熄灭发动机的一瞬间,点火被马上切断,致使部分汽缸本次工作循环所喷入的汽油无法燃烧, 相似文献
9.
现象: 一辆三菱吉普车,发动机为4G54,冷车时,起动立即着火,当水温升到85℃左右时熄火后,发动机热车则很难着火。 可能原因: 1.活塞顶部积炭过多,使发动机散热不良,因为发动机温度升高后,炽热的积炭形成明火点,提前将混合气点燃,从而破坏整个点火正时,使发动机难于起动。 相似文献
10.
从分析发动机高温沉积物积炭和漆膜的化学成份入手,详细阐述了其形成机理,影响因素以及危害和评定方法,最后给出了清除积炭和漆膜的手段。 相似文献
11.
12.
13.
介绍了柴油机积碳的成因,分析了积碳产生的危害,提出了积碳预防及清除的6种方法。指出积碳不仅阻碍了燃烧室和活塞的散热,而且缩小了燃烧室容积,使柴油机动力性下降;所以,在使用中,注意保养以延长柴油机的使用寿命。 相似文献
14.
Xiaoyu Pu Yixi Cai Yunxi Shi Jing Wang Linbo Gu Jing Tian Runlin Fan 《International Journal of Automotive Technology》2018,19(3):421-432
In order to investigate the influence of initial regeneration temperatures on diesel particulate filter (DPF) regeneration, an experimental study of DPF regeneration was implemented using a dielectric barrier discharge (DBD) reactor, aided by exhaust waste heat after engine flameout. DPF trapping characteristics and carbon deposit mass were discussed to facilitate further data analysis and calculation. DPF regeneration was then investigated by comparison analysis of deposit removal mass, backpressure drop, and internal temperature change. The results revealed that a large amount of particulate matter (PM) was deposited in DPF with a high filtration efficiency of about 90 %. The deposit removal rate and percentage drop of the backpressure both maximized at the initial temperature of 100 °C. During DPF regeneration, the sharp rise of internal temperature indicated vigorous PM incineration and high CO2 emission. The results successfully demonstrated DPF regeneration using non-thermal plasma injection during engine flameout, and prominent heat durability was achieved in this method. 相似文献
15.
国产摩托车的点火方式经历了从最初的机械式有触点点火到电子式无触点点火,从模拟点火到计算机数字点火的漫长发展历程。传统的有触点点火,由于点火能量受限制、触点故障多、寿命短、火花塞易积碳等缺点,已不适应现代高转速、高压缩比摩托车的发展,无触点电子点火从根本上克服了传统有触点点火方式的缺陷,是今后的发展方向,我国国产摩托车中95%以上的车型均使用电容放电式CDI电子点火器。 相似文献
16.
17.
18.
《JSAE Review》2002,23(4):415-421
Adhesion of deposit on the combustion chamber walls affects the state of the heat loss into combustion chamber wall surfaces in the internal combustion engine. In this study, as the first step, the instantaneous surface temperature and the instantaneous heat flux were measured by thin film thermocouples on piston surfaces in the D.I. diesel engine with the adhesion of deposit in order to clarify the effects of deposit. As a result, it is found that the instantaneous surface temperature and heat flux strongly depend on the amount of deposit adhered to the combustion chamber wall surfaces. 相似文献
19.
20.
柴油机颗粒排放物中可溶性有机物的成分分析 总被引:2,自引:0,他引:2
通过微孔均匀沉积冲击器对柴油机不同负荷工况下排气中的颗粒物进行取样,采用索氏萃取法对颗粒物样品中的可溶性有机物有效提取,并结合气相色谱‐质谱联用仪对可溶性有机物的成分进行分析。结果表明:在柴油机不同工况条件下,可溶性有机物主要由烷烃类、酚类、酯类及酸类等成分组成。随着负荷的增加,各成分所占比例发生明显变化,在部分工况下,有少量的芳香烃及其衍生物(萘、菲等)出现;可溶性有机物成分中的碳原子数大致分布在C10~C35,其中C14,C16和C19所占比例较高。在高负荷工况下,可溶性有机物成分中出现了高碳链烷烃,主要来自未完全燃烧的机油或燃油添加剂。 相似文献