共查询到20条相似文献,搜索用时 62 毫秒
1.
2.
采用改进的主骨料空隙体积填充法进行了超薄磨耗层SMA-5沥青混合料的配合比设计,经室内试验验证SMA-5沥青混合料路面具有良好的路用性能.试验路检测结果表明,与密级配沥青混凝土路面相比,超薄磨耗层SMA-5沥青路面的表面构造深度提高38%,摩擦系数提高14%,路面噪音降低3~4 dB,具有构造深度大、抗滑性能好、降噪效果明显的特点. 相似文献
3.
为了改善传统热拌沥青混合料隧道路面铺装施工环境,降低车辆行驶过程中的噪音,提高隧道路面的抗滑性能,采用沥青复合改性技术和级配优化,研发了环保安全型TSEM-13沥青混合料,并在惠清高速公路TJ5标长山埔1号隧道(右洞)铺筑了试验段。通过综合检测手段对该新型隧道路面进行施工环境监测和路用性能评价,结果表明:与传统的热拌沥青混合料路面相比,该新型沥青路面可降低沥青烟浓度85mg/m3,平均提高能见度265m,行车噪音降低1~3dB,改善了施工和车辆运行环境。此外,该新型隧道路面横向力系数整体平均值为74.4,具有优良的抗滑性能。 相似文献
4.
5.
通过对比分析不同空隙率的降噪沥青混合料的力学性能,并对其降噪效果进行了测试,表明空隙率的增加将降低沥青混合料的路用性能,但空隙从20%增加到23%时噪音的降低并不明显。而与低空隙的SMA路面(4%左右空隙)相比,大空隙排水降噪路面可以有效地降低车辆行驶噪音,最大可降低6.4d B(A),对环境的影响较为敏感。 相似文献
6.
排水沥青路面是一种排水降噪的功能型路面,其骨架空隙的结构使其具有与密级配沥青混合料不同的性能特点。现研究了排水沥青路面性能的影响因素,评价了空隙率、压实度、分块施工对-13排水沥青混合料肯塔堡飞散损失、动稳定度、扭转飞散等性能指标的影响。研究表明,空隙率偏大和压实度不足,都会降低排水沥青混合料的抗飞散和抗车辙性能,分块施工造成的冷接缝不利于排水沥青混合料的抗扭转破坏性能。因此,应加强排水沥青路面的空隙率设计和压实度控制,尽量减少施工冷接缝。 相似文献
7.
排水沥青路面(PA)具有良好的排水和降噪性能,但相对于密级配沥青混合料,其抗车辙能力、抗疲劳与抗水损害等性能较差。为评价橡胶颗粒(CR)对排水沥青路面性能的影响,以普通排水沥青混合料与5%SBS改性排水沥青混合料为对照组,研究了CR掺量为10%、15%、20%橡胶改性排水沥青混合料的抗车辙、抗析漏、抗滑与水稳定性等性能。结果表明:CR和SBS既降低了排水沥青路面的渗透性,也显著提高了抗车辙能力。同时CR还可以提高混合料的初期回弹模量、抗滑性和抗水损害能力,但CR掺量过大会对路面性能产生不利影响。 相似文献
8.
9.
《公路》2020,(2)
为了满足沥青路面的抗裂需求,结合汶马高速公路建设,进行了应力吸收层沥青混合料设计及性能研究。以SBS改性沥青AC-10和CAM-10两种沥青混合料为研究对象,对比分析了两个级配马歇尔设计指标随油石比的变化,分析了目标空隙率控制分别为2%和4%下的混合料高低温性能及水稳定性。基于四点弯曲试验和Overlay test试验,分析了应力吸收层沥青混合料的抗疲劳性能和抗反射裂缝性能。研究结果表明,在不考虑抗车辙性能时,应力吸收层宜采用目标空隙率为2%的CAM-10沥青混合料,其抗疲劳和抗反射裂缝性能最优;在考虑抗车辙性能时,应力吸收层宜采用目标空隙率为4%的AC-10沥青混合料;在需要兼顾抗车辙性能和抗疲劳性能时,应力吸收层宜采用目标空隙率为4%的CAM-10沥青混合料。 相似文献
10.
11.
12.
《Vehicle System Dynamics: International Journal of Vehicle Mechanics and Mobility》2012,50(4):573-596
An existing driver–vehicle model with neuromuscular dynamics is improved in the areas of cognitive delay, intrinsic muscle dynamics and alpha–gamma co-activation. The model is used to investigate the influence of steering torque feedback and neuromuscular dynamics on the vehicle response to lateral force disturbances. When steering torque feedback is present, it is found that the longitudinal position of the lateral disturbance has a significant influence on whether the driver’s reflex response reinforces or attenuates the effect of the disturbance. The response to angle and torque overlay inputs to the steering system is also investigated. The presence of the steering torque feedback reduced the disturbing effect of torque overlay and angle overlay inputs. Reflex action reduced the disturbing effect of a torque overlay input, but increased the disturbing effect of an angle overlay input. Experiments on a driving simulator showed that measured handwheel angle response to an angle overlay input was consistent with the response predicted by the model with reflex action. However, there was significant intra- and inter-subject variability. The results highlight the significance of a driver’s neuromuscular dynamics in determining the vehicle response to disturbances. 相似文献
13.
预应力曲线箱梁和异形箱梁的研究 总被引:7,自引:0,他引:7
近年来 ,国内外学者对曲线箱梁和异形箱梁的静力分析理论和计算方法作过大量的研究 ,但这些理论和方法在某种程度上都存在着一定的局限性 ,特别是在实际设计工作中 ,运用起来不能得心应手。为此本文在综合前人已取得经验下 ,针对桥梁结构设计中分析曲线箱梁、异形箱梁 ,经常遇到的难题进行了研究 ,建立一个较为完善的理论和方法 ,编制了等参元空间分析程序。在实际工程中进行实桥试验 ,验证了本文理论和方法的正确性。本文的研究工作更准确描述了箱梁的荷载响应 ,为设计人员提供直观的设计依据。对曲线箱梁和异形箱梁受力特性有了更一步的理解 ,并提出了新的见解 相似文献
14.
混凝土的推广使用已有一个世纪,目前在现代工程建设中仍占有重要的地位。而在今天,混凝土的裂缝较为普遍,在桥梁工程中裂缝几乎无所不在,尽管我们在施工中采取各种各样的措施,但收效甚微,裂缝仍然时有出现。该文指出,究其原因,人们对混凝土温度变化所产生的应力注意不够是其中之一,尤其是大体积混凝土。对此,温度应力与温度控制具有重要的意义。 相似文献
15.
J. R. Serrano F. J. Arnau V. Dolz A. Tiseira M. Lejeune N. Auffret 《International Journal of Automotive Technology》2008,9(3):277-288
This article presents a two-stage turbocharged heavy-duty diesel (HDD) engine designed to fulfil the US2007 anti-pollution
directive. This directive imposes very restrictive limits on the NOx and particle emissions of HDD engines. In this work,
the possibility of combining particle traps in the exhaust line to reduce soot emissions with very high EGR rates to reduce
NOx emissions is considered. This new generation engine implements two-stage turbocharging in order to improve the bsfc when
the engine is working on steady conditions as well as to optimize the engine transient response. After carrying out the tests,
the results were analyzed and the engine settings were adjusted to maximise its behaviour and minimise pollutant emissions.
NOx and soot emission peaks were also analyzed at engine transient conditions in order to keep them under certain levels,
and thus maintain the overall pollutant emissions to a level that is as low as possible. In summary, a double-stage turbocharging
configuration can greatly improve engine driveability (between 23% and 36% depending on engine speed), while reducing NOx
emissions during transient evolution without increasing opacity peaks beyond the stated limits. 相似文献
16.
17.
该文从研究超薄磨耗层的级配的选择入手,简单分析了超薄磨耗层的结构特点和强度形成机理,给出了几种国内外常用的超薄磨耗层级配范围,并提出了将SAC-10做为其研究的设计级配。在研究超薄磨耗层沥青混合料配合比设计的基础上,通过对SAC-10沥青混合料的马歇尔试验,确定了该沥青混合料的矿料级配和最佳沥青含量。最后采用车辙试验、浸水马歇尔和冻融劈裂试验及小梁弯曲试验等一系列试验,检测超薄磨耗层沥青混合料的各项路用性能,为在实际工程中的应用提供理论依据。 相似文献
18.
19.
公路工程监理人员市场供需模型研究 总被引:2,自引:0,他引:2
提出了建立监理人员需求和供给模型的方法,推导了计算公式。根据公路建设发展的历史数据,对历年公路建设监理人员需求和供给进行了计算和比较。 相似文献
20.
本文提出一种有效路形测量的新方法,研究轮胎的位移包容性。提出以轮胎包容参数为变量把真实路面功率谱变换为有效路面功率谱的新方法。该研究是道路激励模拟的基础研究。 相似文献