共查询到20条相似文献,搜索用时 78 毫秒
1.
2.
浮泥特性研究进展 总被引:4,自引:1,他引:3
<正> 1 前言浮泥(fluid mud)是淤泥质海岸河口地区特有的一种泥沙运动形态,早在五十年代,我国在天津新港回淤研究中就有所发现,以后在黄河口、长江口、连云港及其他淤泥质海岸河口地区也相继发现。在国外,浮泥现象也屡见报导,如法国的纪龙德河口、芦瓦尔河口、维伦河口(Vilaine)、赛夫勒河口(Sevre)、英国的泰晤士河口、美国的密西西比河口、泰国的渭南河口以及维塞河口(Weser)、波勒特河口(Perrett)、勃列斯托尔河口和一些淤泥质海岸均发现浮泥。由于浮泥与航道港口淤积、海岸河口演变、航行水深利用等许多实际问题有关,因而引起了广大科技人员的重视,开展了多方面的研究,并在实际应用中取得了一定的成果。 相似文献
3.
Silas和Densitune系统在航道工程中的应用 总被引:3,自引:0,他引:3
以连云港港15万t级航道疏浚工程施T期浮泥观测为例,介绍Densitune音叉振动密度仪、Silas适航水深测量系统和悬移质取样器的特性,并根据实测的浮泥层厚度及其分布情况,剖析Silas和Densitune系统在实际工程应用中遇到的问题,供丁程设计和运营管理参考. 相似文献
4.
γ密度仪测定杭州湾浮泥和淤泥重度简介 总被引:2,自引:0,他引:2
简要介绍用γ射线密度仪对所测上海港杭州湾深水航道东试挖槽浮泥和淤泥重度资料进行整理分析,结果表明,竣工四个月来已回淤2.4M厚的细颗粒泥沙,浮泥层平均淤厚为40CM,回淤量达37万M^3。 相似文献
5.
介绍盐田港三期工程及扩建工程,在泥塘区插塑料排水板施工过程中所遇到的难题以及解决办法。主要内容包括:在浮泥面层上插板,由于土体强度过低导致插板机械无法施工;在厚层吹填砂条件下插板频繁断带的问题;以及按工程重要程度及使用要求,规范塑料排水板材质的建议。 相似文献
6.
水下基槽回淤沉积物厚度过大时会增大沉降,甚至可能导致地基失稳事故。相关规范对水下基槽回淤沉积物厚度检测没有规定具体检测方法,工程实践中采用的回淤沉积物厚度检测方法五花八门,有些检测方法存在较多偏差甚至是错误方法。在分析浮泥和回淤沉积物差别的基础上,对回淤沉积物泥厚度检测方法进行分类、介绍和评价,最后通过一个工程实例说明区分浮泥与回淤沉积物、合理选择回淤沉积物厚度检测方法的重要性。 相似文献
7.
浮泥发育时双频回声测深误差及其对适航水深监测的影响 总被引:1,自引:1,他引:0
基于Odem Echotrac MKIII双频测深仪现场测深记录和同步Stema Densitune音叉密度计现场测量结果探讨了浮泥发育时双频回声测深误差及其对适航水深监测的影响。结果表明:1)初始发育阶段非典型浮泥工况下,双频测深仪的高频数字化水深有可能包含少部分上层浮泥层厚度,而低频数字化水深则可代表硬底床位置,高低频水深差明显小于浮泥层厚度;2)发育阶段典型浮泥工况下,双频测深仪的高频数字化水深代表浮泥上层位置,而低频数字化水深则可能未到达硬底床位置,高低频水深差≤浮泥层厚度;3)固结消亡阶段浮泥工况下,双频测深仪的高频数字化水深代表浮泥上层位置,而低频数字化水深则位于靠近浮泥层上边界的密度梯度突变位置,高低频水深差明显小于浮泥层厚度;4)在浮泥固结消亡阶段以及少部分充分发育阶段,简单地采用双频回声测深仪测深结果来快速确定航道适航水深会造成实际适航水深利用程度下降。 相似文献
8.
9.
10.
11.
12.
介绍了我国港口资源的整合现状,指出港口整合可以提升港口的形象和地位,也为区域经济和城市的发展注入强大的动力。最后指出在港口资源整合中要避免的几个问题。 相似文献
13.
广州集装箱码头的轮胎式场桥小车制动器使用10多年后,出现了许多问题,故进行了改造.分析了轮胎式集装箱龙门起重机小车制动器的主要故障现象,提出了改造方案,并加以实施. 相似文献
14.
本文对现有的选定球面轴承的三种工程方法进行了分析比较.引入了“合力系数”,并给出了合力方向上投影面积的精确解. 相似文献
15.
16.
17.
18.
分析柴油机故障中常见的机体裂纹故障原因,认为由于设计缺陷和管理及操作不当,易造成船舶柴油机缸体上的裂纹多发生在气缸套凸肩处。如不及时处理这些裂纹和故障,就会造成缸套的裂纹直至出现缸套漏水等严重后果,针对NANTAIQUEEN轮柴油机对该类型故障的检修提出具体措施。 相似文献
19.
The hydrophysical and hydrochemical structure of the Sea of Azov, with developed bottom anoxia, was studied during the RV “Akvanavt” cruise from July 31 to August 03, 2001. The anoxic zone with a thickness from 0.5 to 4 m above the bottom was found in all deep regions of the Sea. Concentrations of hydrochemical parameters were similar to the pronounced anoxic conditions (about 90 mmol m− 3 of hydrogen sulfide, 17 mmol m− 3 of ammonia, 6 mmol m− 3 of phosphate, 7 mmol m− 3 of total manganese). The hydrophysical structure was characterized by the uniform distribution of temperature in the upper 6–7 m mixed layer (UML). Below this a thin (0.4–0.8 m) thermocline layer was observed, just above the anoxic waters. Formation of this phenomenon was connected with that summer weather conditions. Intensive rains led to increased influx of river waters in June. That resulted in large input of allochtonous organic matter (OM) and inorganic nutrients; the latter were consumed on the additional autochthonous organic matter production. In July the weather was characterized by a significant rise in the daily averaged air temperature and large oscillations of temperature during the day. In this period a wind of constant direction was absent, but wind bursts were observed. The completed analyses showed that the formation of such a structure could be connected with the following factors: (i) positive growth trends of the daily averaged temperature and the daily oscillations of temperature, (ii) presence of wind bursts. The joint action of these factors resulted in the formation of the UML. The amplitude of wind bursts determined the depth of UML, and the value of trend determined the value of the temperature change in the thermocline. An initial presence of bottom halocline (caused by the Black Sea water influx to the bottom of the Sea of Azov) prevented the heating of the bottom layer and therefore led to an increase of vertical gradient of temperature in the thermocline. The spatial distribution of the turbulent exchange coefficient confirmed the existence of a “stagnation” area located above the anoxia zone, which is also, apparently, the reason for its occurrence. 相似文献
20.