共查询到20条相似文献,搜索用时 78 毫秒
1.
2.
再论最低通航设计水位计算方法的研究 总被引:3,自引:3,他引:0
简要地介绍保证率—率法的由来,从理论上分析了保证率法与保证率—频率法的关系,并以实测资料验证,最后,提出《通航水位标准》的修改意见。 相似文献
3.
以实例为基础,解释了保证率法、频率法和保证率-频率法的具体做法和概念,并在相互比较的基础上说明只要采取不同的保证率值和频率值,任一方法均可获得同一最低设计通航水位,最后推荐采用国内外得到广泛应用的保证率法。 相似文献
4.
污水处理厂恶臭污染物控制技术 总被引:4,自引:0,他引:4
介绍了城市污水处理厂臭气来源、成分及性质。针对目前国内外除臭技术的研究和发展情况,介绍了除臭系统的5种工艺:土壤法、生物滤池法、植物提取液喷淋法、离子法和化学法,分析了这些除臭方法的技术原理和特点。 相似文献
5.
桥梁抗震分析方法对比研究 总被引:1,自引:0,他引:1
实际桥梁工程结构复杂多样,在进行抗震分析时选用一种最佳的分析方法对设计和研究人员非常重要。本文对现有的主要抗震方法,如反应谱法、动力时程法、功率谱法、Push-over法等进行了分析,介绍了各种分析方法的特点和进展。 相似文献
6.
巴拿马Amador邮轮码头项目场地存在深厚软黏土地层。为了评估地基剩余沉降,基于恒载期间观测数据,采用双曲线法、三点法、Asaoka法预测沉降。针对三点法中3个等间距沉降点难以确定的问题,以最小曲率半径入手,合理定义了3个沉降点。选取5个典型的时间-沉降曲线,对观测点的地基沉降开展了对比分析。得出如下结论:1)双曲线法预测的沉降通常会偏大,随着沉降观测时间的增加,沉降预测的准确度会随之提高。2)Asaoka法预测沉降值与稳定值相近,但小于最终稳定值,显然会使地基沉降偏不安全。3)三点法沉降预测结果大于Asaoka法且低于双曲线法,更接近于稳定值。4)3种沉降预测方法均具有简单、实用的特点,预测的剩余沉降均小于150 mm,满足项目沉降设计要求。 相似文献
7.
介绍了三种常用的软土地基最终沉降量推算方法:三点法、双曲线法和Asaoka法,并通过工程实例对上述方法进行比较分析,讨论了各种方法的优缺点及适用性,另外,还重点讨论了三点法中时间间隔△t的选取问题.在此基础上,建议采用传统的双曲线法推算软土地基最终沉降量的同时,可运用Asaoka法进行校核. 相似文献
8.
舰船实船抗冲击试验中,试验爆距的精确控制与获取对于保证试验效果和试验结果分析至关重要。论文针对某型舰试验特点,对适用于水面舰艇抗冲击试验爆源定位的机械定位法、冲击波零时法、G PS定位法、水声与G PS联测法的工作原理、应用特点、适用条件进行了分析研究,重点对机械定位法进行了理论分析和计算,得出机械定位法并加以优化的方法是适用于该型舰抗冲击试验爆源定位的最佳方法。 相似文献
9.
10.
11.
12.
介绍了我国港口资源的整合现状,指出港口整合可以提升港口的形象和地位,也为区域经济和城市的发展注入强大的动力。最后指出在港口资源整合中要避免的几个问题。 相似文献
13.
广州集装箱码头的轮胎式场桥小车制动器使用10多年后,出现了许多问题,故进行了改造.分析了轮胎式集装箱龙门起重机小车制动器的主要故障现象,提出了改造方案,并加以实施. 相似文献
14.
本文对现有的选定球面轴承的三种工程方法进行了分析比较.引入了“合力系数”,并给出了合力方向上投影面积的精确解. 相似文献
15.
16.
17.
18.
分析柴油机故障中常见的机体裂纹故障原因,认为由于设计缺陷和管理及操作不当,易造成船舶柴油机缸体上的裂纹多发生在气缸套凸肩处。如不及时处理这些裂纹和故障,就会造成缸套的裂纹直至出现缸套漏水等严重后果,针对NANTAIQUEEN轮柴油机对该类型故障的检修提出具体措施。 相似文献
19.
The hydrophysical and hydrochemical structure of the Sea of Azov, with developed bottom anoxia, was studied during the RV “Akvanavt” cruise from July 31 to August 03, 2001. The anoxic zone with a thickness from 0.5 to 4 m above the bottom was found in all deep regions of the Sea. Concentrations of hydrochemical parameters were similar to the pronounced anoxic conditions (about 90 mmol m− 3 of hydrogen sulfide, 17 mmol m− 3 of ammonia, 6 mmol m− 3 of phosphate, 7 mmol m− 3 of total manganese). The hydrophysical structure was characterized by the uniform distribution of temperature in the upper 6–7 m mixed layer (UML). Below this a thin (0.4–0.8 m) thermocline layer was observed, just above the anoxic waters. Formation of this phenomenon was connected with that summer weather conditions. Intensive rains led to increased influx of river waters in June. That resulted in large input of allochtonous organic matter (OM) and inorganic nutrients; the latter were consumed on the additional autochthonous organic matter production. In July the weather was characterized by a significant rise in the daily averaged air temperature and large oscillations of temperature during the day. In this period a wind of constant direction was absent, but wind bursts were observed. The completed analyses showed that the formation of such a structure could be connected with the following factors: (i) positive growth trends of the daily averaged temperature and the daily oscillations of temperature, (ii) presence of wind bursts. The joint action of these factors resulted in the formation of the UML. The amplitude of wind bursts determined the depth of UML, and the value of trend determined the value of the temperature change in the thermocline. An initial presence of bottom halocline (caused by the Black Sea water influx to the bottom of the Sea of Azov) prevented the heating of the bottom layer and therefore led to an increase of vertical gradient of temperature in the thermocline. The spatial distribution of the turbulent exchange coefficient confirmed the existence of a “stagnation” area located above the anoxia zone, which is also, apparently, the reason for its occurrence. 相似文献
20.