编委简介

Andrei Ivanovich DULNEV Andrei Ivanovich DULNEV was born in 1958 in Murmansk.In 1981 he graduated from the Leningrad Shipbuilding Institute in dynamics and strength of machines.Since 1981 he has been with the Krylov Shipbuilding Research     

Performance comparison of multicast routing protocols based on NS-2

The electronic system in a comprehensive shipboard has a extremely wide bandwidth. It supports synchronized and asynchronous data transmission, multimedia correspondence, and videophone conferencing. In order to guarantee the security and correspondent real time of the communication, choosing a multicast routing protocol based on different applications is a key problem in terms of the complexity of the system. A simulation model was first designed for existing multicast routing protocols in NS-2 and analysis was performed on their corresponding application environments. The experiments proved that PIM-DM based on the shortest-path tree protocol is suitable for communication in the field of comprehensive shipboard. Further work that is necessary is also discussed.     

Crack detection using a frequency response function in offshore platforms

Structural cracks can change the frequency response function (FRF) of an offshore platform. Thus, FRF shifts can be used to detect cracks. When a crack at a specific location and magnitude occurs in an offshore structure, changes in the FRF can be measured. In this way, shifts in FRF can be used to detect cracks. An experimental model was constructed to verify the FRF method. The relationship between FRF and cracks was found to be non-linear. The effect of multiple cracks on FRF was analyzed, and the shift due to multiple cracks was found to be much more than the summation of FRF shifts due to each of the cracks. Then the effects of noise and changes in the mass of the jacket on FRF were evaluated. The results show that significant damage to a beam can be detected by dramatic changes in the FRF, even when 10% random noise exists. FRF can also be used to approximately locate the breakage, but it can neither be efficiently used to predict the location of breakage nor the existence of small hairline cracks. The FRF shift caused by a 7% mass change is much less than the FRF shift caused by the breakage of any beam, but is larger than that caused by any early cracks.     

Application of large eddy simulation in the performance study of wave blocker

The configuration and aerodynamic performance of the inlet system are important aspects in the process of installing a gas turbine on a naval vessel. Under the requirements, large eddy simulation （LES） is used to simulate the three-dimensional fluid flow in the wave blocker of a marine inlet filter. The Smagorinsky-Lilly sub-grid model was used to model motions of small-scale structures. During numerical simulation, the SIMPLE algorithm was applied. The central-differencing spatial discretization scheme and the second order accuracy finite difference for the temporal discretization were used. Simulation gives satisfactory distribution of the vorticity fields and turbulent kinetic energy. Compared with the k-ε turbulent model, the results of LES are better for the distribution of parameters. The results of experimental study in a small-scale wind tunnel indicate that numerical calculation has higher accuracy. Therefore, the methods used are worthy of reference and introduction for the design of an inlet system.     

LEGISLATION IN CHINA

China＇s largest project of land reclama- tion from sea established in Tinajin With an investment of 60b Yuan RMB by Tianjin Port Group, the project, which is located in Binhai new district including 30 square km in Dongjiang port area, 13 square km in Nanjiang port area and 120 square km in Lingang industrial zone, will be finished in five years.     

2012海事技术国际会议(英文)

25-28 June 2012,Harbin,Heilongjiang,China In order to improve environmental sustainability,a greater understanding of the way maritime activities affect the marine environment is needed. This will in turn support the development of technologies in marine design,construction,operation,     

The Current Situation of the Study on Twisted Tape Inserts in Pipe Exchangers

Heat transfer enhancement is used in many applications including heat exchangers, air conditioning, and refrigeration systems; hence many researchers have conducted experimental and numerical researches on heat transfer enhancement and have developed various techniques and methods. As a passive heat transfer technique, twisted tapes are widely used in various industries for their cost savings, lower maintenance requirements and the fact that they are easily set up. This paper introduces the principle of heat transfer enhancement of twisted tapes and reviews some of the experimental works done by researchers on this technique in recent years. The variously modified twisted tape inserts are widely researched and used to enhance heat transfer efficiency for heat exchangers. Twisted tapes perform better in low Re conditions and in square tubes. However, they could also cause higher pressure drops. Twisted tapes have great potential and profound implications if they can be used in traditional heat exchangers. Besides this, some correlations between the Nusselt number and friction factors are presented in this paper.     

Lubrication and tribology in seawater hydraulic piston pump

Water hydraulic systems have provoked major interest because of the human friendly and environmental safety aspects. Piston pump is one of the most frequently used hydraulic units in recent engineering technique. In water hydraulic piston pump, poor lubrication is more likely to happen than in oil hydraulic one because of difference in properties between water and oil. So there are some key problems such as corrosive wear and erosion, which are investigated briefly. Many new materials have been developed, which give longer life expectancies with water without corrosion and erosion. A new type of seawater hydraulic piston pumps with better suction characteristics had been developed at HUST. Much of this research has concentrated on new materials, structure and experiments, which are also specially introduced.     

Improving longitudinal motion prediction of hybrid monohulls with the viscous effect

A new method improves prediction of the motion of a hybrid monohull in regular waves. Stem section hydrodynamic coefficients of a hybrid monohull with harmonic oscillation were computed using the Reynolds Averaged Navier-Stokes Equations (RANSE). The governing equations were solved using the finite volume method. The VOF method was used for free surface treatment, and RNGК-ε turbulence model was employed in viscous flow calculation. The whole computational domain was divided into many blocks each with structured grids, and the dynamic process was treated with moving grids. Using a 2-D strip method and 2.5D theory with the correction hydrodynamic coefficients allows consideration of the viscous effect when predicting longitudinal motion of a hybrid monohull in regular waves. The method is effective at predicting motion of a hybrid monohull, showing that the viscous effect on a semi-submerged body cannot be ignored.     

Sensitivity analysis and dynamic modification of modal parameter in mechanical transmission system

Sensitivity analysis is one of the effective methods in the dynamic modification. The sensitivity of the modal parameters such as the natural frequencies and mode shapes in undamped free vibration of mechanical transmission system is analyzed in this paper. In particular,the sensitivities of the modal parameters to physical parameters of shaft system such as the inertia and stiffness are given. A calculation formula for dynamic modification is presented based on the analysis of modal parameter. With a mechanical transmission system as an example, the sensitivities of natural frequencies and modes shape are calculated and analyzed. Furthermore, the dynamic modification is also carried out and a good result is obtained.