共查询到20条相似文献,搜索用时 78 毫秒
1.
介绍了基于有限元解法的宽支承轨道梁计算系统的开发,并对宽支承轨道梁和点支承轨道梁计算结果进行比较和分析。 相似文献
2.
通过ANSYS软件对轨道梁的弹性点支承、刚性点支承、分布弹性支承以及空间模型进行有限元模拟,得出不同模型下的连续梁内力以及支座反力,并对不同模型的计算结果进行比较分析。计算结果表明,弹性点支承与刚性点支承模型在计算宽支座梁支座负弯矩时与分布弹性支承模型及空间模型差异较大,在支座边缘处采用弹性点支承模型计算弯矩削峰的方法已不再适用,同时得到宽支座梁支座反力、剪力等分布规律,可供大桩帽连续梁设计参考。 相似文献
3.
用宽支承方式计算高桩梁板式码头上的轨道梁 总被引:1,自引:1,他引:1
文章提出了轨道梁的“宽支承”概念及其计算基本原理;计算中考虑施工过程对恒载作用效应的方法;对不同支承条件下的计算结果作了比较;对《高桩码头设计与施工规范》(JTJ291-98)中的纵梁计算跨度提出了修改建议。 相似文献
4.
5.
6.
推导了弹性支承梁的横向自由振动模态的特征方程.计算了几种不同弹性支承梁的前几阶反映固有频率的无量纲特征值,有的还列出了特征值随弹性刚度系数变化而变化的表格.将弹性支承梁的方法应用于平面刚架的弯曲振动模态分析,取得了比较好的结果. 相似文献
7.
设置桩支承的起重机轨道梁的扶壁码头结构形式,抗倾稳定性影响分析中应该考虑截桩力的稳定力矩。探讨了截桩力的产生机理和计算方法,结合工程对截桩力产生的稳定力矩的影响进行分析,结果表明,考虑截桩力稳定力矩具有一定的经济意义。 相似文献
8.
弹性支承梁的模态分析及应用 总被引:1,自引:0,他引:1
推导了弹性支承梁的横向自由振动模态的特征方程。计算了几种不同弹性支承梁的前几阶反映固有频率的无量纲特征值,有的还列出了特征值随弹性刚度系数变化而变化的表格。将弹性支承梁的方法应用于平面刚架的弯曲振动模态分析,取得了比较好的结果。 相似文献
9.
在软土地基上设计桩基轨道梁,桩基的长度和间距直接影响轨道梁的安全和工程造价。如何获得既满足轨道梁沉降控制要求又经济合理的桩基长度,成为该类工程的主要技术问题。考虑轨道梁刚度和桩基刚度共同作用,研究桩基未进入坚硬持力层的桩基式轨道梁受力模式,采用明德林桩基沉降计算方法,分析不均匀沉降对软土桩基式轨道梁受力的影响,提出切实可行的不均匀软土地基上轨道梁沉降控制的设计方法。 相似文献
10.
介绍在砂质海岸上建造的京唐港1.5万T级码头(7号和8号泊位),首次采用现浇地下连续墙结构,轨道梁采用钻孔灌注桩支承等所取得的施工经验。 相似文献
11.
12.
介绍了我国港口资源的整合现状,指出港口整合可以提升港口的形象和地位,也为区域经济和城市的发展注入强大的动力。最后指出在港口资源整合中要避免的几个问题。 相似文献
13.
广州集装箱码头的轮胎式场桥小车制动器使用10多年后,出现了许多问题,故进行了改造.分析了轮胎式集装箱龙门起重机小车制动器的主要故障现象,提出了改造方案,并加以实施. 相似文献
14.
本文对现有的选定球面轴承的三种工程方法进行了分析比较.引入了“合力系数”,并给出了合力方向上投影面积的精确解. 相似文献
15.
16.
17.
18.
分析柴油机故障中常见的机体裂纹故障原因,认为由于设计缺陷和管理及操作不当,易造成船舶柴油机缸体上的裂纹多发生在气缸套凸肩处。如不及时处理这些裂纹和故障,就会造成缸套的裂纹直至出现缸套漏水等严重后果,针对NANTAIQUEEN轮柴油机对该类型故障的检修提出具体措施。 相似文献
19.
The hydrophysical and hydrochemical structure of the Sea of Azov, with developed bottom anoxia, was studied during the RV “Akvanavt” cruise from July 31 to August 03, 2001. The anoxic zone with a thickness from 0.5 to 4 m above the bottom was found in all deep regions of the Sea. Concentrations of hydrochemical parameters were similar to the pronounced anoxic conditions (about 90 mmol m− 3 of hydrogen sulfide, 17 mmol m− 3 of ammonia, 6 mmol m− 3 of phosphate, 7 mmol m− 3 of total manganese). The hydrophysical structure was characterized by the uniform distribution of temperature in the upper 6–7 m mixed layer (UML). Below this a thin (0.4–0.8 m) thermocline layer was observed, just above the anoxic waters. Formation of this phenomenon was connected with that summer weather conditions. Intensive rains led to increased influx of river waters in June. That resulted in large input of allochtonous organic matter (OM) and inorganic nutrients; the latter were consumed on the additional autochthonous organic matter production. In July the weather was characterized by a significant rise in the daily averaged air temperature and large oscillations of temperature during the day. In this period a wind of constant direction was absent, but wind bursts were observed. The completed analyses showed that the formation of such a structure could be connected with the following factors: (i) positive growth trends of the daily averaged temperature and the daily oscillations of temperature, (ii) presence of wind bursts. The joint action of these factors resulted in the formation of the UML. The amplitude of wind bursts determined the depth of UML, and the value of trend determined the value of the temperature change in the thermocline. An initial presence of bottom halocline (caused by the Black Sea water influx to the bottom of the Sea of Azov) prevented the heating of the bottom layer and therefore led to an increase of vertical gradient of temperature in the thermocline. The spatial distribution of the turbulent exchange coefficient confirmed the existence of a “stagnation” area located above the anoxia zone, which is also, apparently, the reason for its occurrence. 相似文献
20.