共查询到20条相似文献,搜索用时 93 毫秒
1.
2.
准确判断船舶走锚方法 总被引:1,自引:0,他引:1
监测锚位,判断本船是否走锚是每一锚泊船值锚泊班驾驶员的主要工作之一.因本船走锚而导致的触礁、搁浅、碰撞等事故不胜枚举,研究一种能准确判断船舶走锚的简单可行方法迫在眉睫,这一直是航海人员研究的重要课题.尤其是在锚泊船密度大,锚泊水域受限,锚泊水域风、流、浪条件恶劣,锚地底质不良等的不利条件下,准确判断本船是否走锚尤为重要.提出了一种简单可行的准确判断本船是否走锚的方法,以便航海人员及时采取相应的措施控制走锚,确保船舶锚泊安全. 相似文献
3.
4.
杨盐生 《大连海运学院学报》1994,20(2):11-16
在给出一种走锚最小距离计算方法的基础上,提出利用GPS接收机来进行描位监视的一种新方法,并对目前GPS接收机锚位监视功能提出了改进方法,这对保证船舶泊安全是十分有价值的。 相似文献
5.
为解决舰船抛锚作业时锚位点决策受限于海图有限信息,人工选址方式主观性过强而间接增大走锚风险的问题,提出基于VCF(Vector Chart Format)格式数字海图数据,采用地理信息系统(Geographic Information System,GIS)的方法分析影响锚泊安全的海洋环境要素、区域界限、碍航物、周边船舶态势和助航标志通视情况,定量给出各要素的适宜度、影响范围以及基于方位位置线网的定点抛锚方法,并将各步骤的分析结果可视化。该模型的实际使用情况表明:有利于航海人员准确把握锚泊海区的整体态势,辅助其得到结合自身需求的优化锚位点决策,降低舰船走锚风险,提升锚泊安全性。 相似文献
7.
1.抛锚及锚泊时发生事故的原因
船舶在港内急流水域抛锚或锚泊时发生走锚、断链、碰撞等情况比较多,尤其是走锚现象更为普遍,在我们海门港就发生多件.如2000年8月初来我港的某巴拿马籍外轮,在内锚地抛锚卸货期间,由于船长对港口水流水深等情况不熟悉,当发现他船有走锚现象时,即匆匆起锚以调整自己的锚位避免与走锚船舶发生碰撞.当第二次抛锚后自己却发生了走锚,与他船发生碰撞,并轻度搁浅.又如同年8月底某外轮在港内锚泊,因考虑到当时正值大潮水流比较急,加上船舶重载吃水大等客观因素,采用了抛"一点锚"(即平衡锚)的办法,并松双锚5节落水以防船舶走锚.但在港内低潮后转流时却发生了走锚,与另一船舶尾首相"接触",而后在拖轮的协助下才得以重新安全抛锚. 相似文献
8.
船舶锚泊中抗台能及时准确地掌握船位(锚位)的变化情况以及锚链的受力情况是至关重要的。在抗强台风中通常都要动车配合舵以缓解锚链的张力以防止走锚。但在抗台中用车不当不但无益反而有害,如用车 相似文献
9.
现有M/M/S排队论模型在用于计算港口锚位数量时采用的公式较为复杂。本文对基于排队论的港口锚位数量计算方法进行了探讨,给出了快速确定锚位数量的图表方法。 相似文献
10.
为预测河道中锚泊船舶因风、流等环境因素影响发生走锚后撞击上下游桥梁的风险,基于AASHTO船桥碰撞模型,提出一种锚泊船舶走锚撞桥概率计算模型.该模型相比AASHTO模型,添加走锚概率、停船概率的概念,重新定义几何概率.根据桥梁安全风险事件发生概率的等级判断标准,设计走锚船舶撞桥概率计算与风险等级判断方法,利用该模型对某... 相似文献
11.
介绍了我国港口资源的整合现状,指出港口整合可以提升港口的形象和地位,也为区域经济和城市的发展注入强大的动力。最后指出在港口资源整合中要避免的几个问题。 相似文献
12.
13.
广州集装箱码头的轮胎式场桥小车制动器使用10多年后,出现了许多问题,故进行了改造.分析了轮胎式集装箱龙门起重机小车制动器的主要故障现象,提出了改造方案,并加以实施. 相似文献
14.
本文对现有的选定球面轴承的三种工程方法进行了分析比较.引入了“合力系数”,并给出了合力方向上投影面积的精确解. 相似文献
15.
16.
17.
18.
分析柴油机故障中常见的机体裂纹故障原因,认为由于设计缺陷和管理及操作不当,易造成船舶柴油机缸体上的裂纹多发生在气缸套凸肩处。如不及时处理这些裂纹和故障,就会造成缸套的裂纹直至出现缸套漏水等严重后果,针对NANTAIQUEEN轮柴油机对该类型故障的检修提出具体措施。 相似文献
19.
The hydrophysical and hydrochemical structure of the Sea of Azov, with developed bottom anoxia, was studied during the RV “Akvanavt” cruise from July 31 to August 03, 2001. The anoxic zone with a thickness from 0.5 to 4 m above the bottom was found in all deep regions of the Sea. Concentrations of hydrochemical parameters were similar to the pronounced anoxic conditions (about 90 mmol m− 3 of hydrogen sulfide, 17 mmol m− 3 of ammonia, 6 mmol m− 3 of phosphate, 7 mmol m− 3 of total manganese). The hydrophysical structure was characterized by the uniform distribution of temperature in the upper 6–7 m mixed layer (UML). Below this a thin (0.4–0.8 m) thermocline layer was observed, just above the anoxic waters. Formation of this phenomenon was connected with that summer weather conditions. Intensive rains led to increased influx of river waters in June. That resulted in large input of allochtonous organic matter (OM) and inorganic nutrients; the latter were consumed on the additional autochthonous organic matter production. In July the weather was characterized by a significant rise in the daily averaged air temperature and large oscillations of temperature during the day. In this period a wind of constant direction was absent, but wind bursts were observed. The completed analyses showed that the formation of such a structure could be connected with the following factors: (i) positive growth trends of the daily averaged temperature and the daily oscillations of temperature, (ii) presence of wind bursts. The joint action of these factors resulted in the formation of the UML. The amplitude of wind bursts determined the depth of UML, and the value of trend determined the value of the temperature change in the thermocline. An initial presence of bottom halocline (caused by the Black Sea water influx to the bottom of the Sea of Azov) prevented the heating of the bottom layer and therefore led to an increase of vertical gradient of temperature in the thermocline. The spatial distribution of the turbulent exchange coefficient confirmed the existence of a “stagnation” area located above the anoxia zone, which is also, apparently, the reason for its occurrence. 相似文献
20.