试析荻生徂徕关于汉语教育的理论与实践

荻生徂徕是日本江户时代最名的思想、学家和古辞家，同时还是一位出色的汉语教育家。他分析了汉语和日语语言系统的差别，提出从汉语语音教育着手，逐渐增加词汇量，通过大量阅读汉原的实践，最后能够如中国人一样阅读汉书籍。     

多平台信息源的JDBC解决方案

作者阐述了利用JDBC技术解决查询多平台信息源的方法,通过对实验室模拟环境下探索性开发的探讨,提出了使用Servlet与Applet相结合的解决方案。     

高速公路路堤和路面软基病害检测及加固处理

某高速公路 K1 0 4 2 0 0～K1 0 6 5 0 0段穿过鱼塘 ,路堤采用钢渣水中挤淤法施工 ,通车后路面出现了严重的纵向裂缝、车辙、沉陷 ,影响了路面的使用性能 ,同时路堤存在滑动的隐患 ,必须进行加固处理。为此 ,首先通过系统检测 ,分析路面裂缝产生的原因 ,然后提出针对性的加固处理方案 ,最终实施加固处理施工 ,所取得的成果对其它高速公路的维修加固具有参考价值     

基于VBA的沥青最佳用量数据处理系统

沥青最佳用量是提高公路路面质量的前提之一。本研究的目的是开发出一个数据处理系统，它建立在最小二乘法基础上，能对热拌沥青混合料的马歇尔试验数据进行自动处理，得出最佳沥青用量OAC1和OAC2，并自动生成试验报告，便于施工现场管理。     

Performance Evaluation of Hybrid-Drive Buses and Potential Fuel Savings in Brazilian Urban Transit

Transporting more than 55 million passengers per day, buses are the main transit mode in Brazil. Most of these vehicles use diesel oil and this situation causes dependence on oil, extensive greenhouse gas emissions and increasing air pollution in urban areas. In order to improve this situation the options for Brazilian cities include the use of alternative fuels and new propulsion technologies, such as hybrid vehicles. This article proposes a procedure for evaluating the performance of a recently developed Brazilian hybrid-drive technology. A simple procedure is presented to compare hybrid-drive buses with conventional diesel buses in urban operation focusing on fuel economy and the potential for reducing diesel oil consumption through the use of hybrid-drive buses. Field tests carried out by the authors indicate that fuel consumption improvement through the use of hybrid-drive buses would certainly exceed 20%, resulting in lower fuel costs and reduced carbon dioxide (CO₂) emissions.     

Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

Causes and effects of FDI by the Norwegian maritime industry

A theory of replacement in the context of ocean going vessels is discussed. The approach is based upon costs rather than profits, and while there appear to be many difficulties in applying replacement theory to ships it is shown that there are some segments where the theory can still usefully be applied. The effect on replacement resulting from varying important cost parameters is shown and it is found that while fiscal measures have very little effect, capital cost and operating cost profiles have the most important influence. It is concluded that shipowners need to keep themselves fully informed of changes in cost and improvements in technology that may indicate replacement of a vessel somewhat sooner than normal replacement age.     

Numerical study on active wave devouring propulsion

The possibility of extracting energy from gravity waves for marine propulsion was numerically studied by a two-dimensional oscillating hydrofoil in this study. The commercially available computational fluid dynamics software FLUENT was used for the unstructured grid based on the Reynolds-average Navier?CStokes equation. The free surface waves and motion of the flapping foil were implemented by customizing the FLUENT solver using a user-defined function technique. In addition, dynamic mesh technology and post processing capabilities were fully utilized. The validation of the model was carried out using experimental data for an oscillation hydrofoil under the waves. The results of the simulation were investigated in detail in order to explain the increase of propeller efficiency in gravity waves. Eight design parameters were identified and it was found that some of them greatly affected the performance of wave energy extraction by the active oscillating hydrofoil. Finally, the overall results suggested that when the design parameters are correctly maintained, the present approach can increase the performance of the oscillating hydrofoil by absorbing energy from sea waves.     

沥青搅拌设备燃烧系统的使用维护及故障排查研究

随着我国公路建设的快速发展，越来越多的施工技术应用于公路的建设中，因此施工设备面临着很大的挑战。针对施工中沥青搅拌设备燃烧系统发生的开启风门较大、设备内部阀芯被杂质或者油品堵塞以及无法点火等问题进行了细致的探讨，分析故障排查方法，以保障路面施工不受影响。     

The Geometrical Contact between Track and Wheelset

In previous publications the author has described a so-called first-order theory for the motion of a railway vehicle wheelset on a tangent track. In the present report the geometrical aspect of this theory is further evaluated and a method for solving the constraint equations between the coordinates of the wheelset is indicated.