Correlates of bicycling trip flows in Hamilton,Ontario: fastest,quietest, or balanced routes?

Transportation - Bicycling is an increasingly popular mode of travel in Canadian urban areas, like the Greater Toronto and Hamilton Area (GTHA). While trip origins and destinations can be inferred...     

The continental shelf and the exclusive economic zone: the problem of delimitation at UNCLOS III

If the Third United Nations Conference on the Law of the Sea succeeds in adopting a new Caracas Convention on the Law of the Sea, it is likely to embody detailed provisions on the delimitation of both the continental shelf and the new zone, the exclusive economic zone. In this paper, the most recent draft of these rules—contained in the Revised Single Negotiating Text—is subjected to a detailed and critical scrutiny which leads to the conclusion that the Sixth Session of the Conference still has a great deal of work to do before agreement can be reached on a satisfactory set of rules.     

Nanoparticle emission characteristics and reduction strategies by boost pressure control and injection strategies in a passenger diesel engine

This research attempted to analyze nanoparticles and other harmful exhaust emissions in accordance with injection strategies and air-fuel ratio (AFR) changes for small diesel engines. The emission characteristics were analyzed in the medium-speed condition, which is the main driving range of a diesel engine. In the case of particulate matter (PM), the number of particles was measured, analyzed, and compared to identify the correlation and emission characteristics of nanoparticles by using a dilution device and condensation particle counter (CPC), which are international standards for particle measurement recommended by the Particulate Measurement Programme (PMP). The engine torque tended to be reduced as pilot injections were added, and the torque was increased by the increased boost pressure, but reduced by the exhaust pressure increase in a part of the low-load range. The number of nanoparticles was not influenced greatly by the change in AFR, but the reduction effect on the PM weight was great depending on the boost pressure increase. In addition, the number of nanoparticles tended to increase as the fuel injection timing became closer to TDC in all conditions, and its difference became larger with an increase in AFR. In addition, in the case of the pilot injection, nanoparticle emission showed similar characteristics depending on the main injection timing, but it was increased by advanced injection timing when performing the main injection only, and the number of the nanoparticles increased as pilot injections were added. Last, the optimal conditions for EMS calibration were analyzed by selecting the conditions of torque reduction and NOx increase within 5 % from all of the engine operating conditions; optimized conditions are presented.     

地面注汽管线表面散热损失影响因素分析

文中采用Fluent模拟与理论计算结合比较的方法,研究了不同因素对蒸汽管道散热损失的影响规律,并分析了理论计算模型的相对误差.发现增加注汽管线距地面高度,对其散热损失影响较弱;空气温度升高,注汽管道表面散热损失降低;风速和表面发射率对注汽管线表面热损失影响较大;数值模拟结果与理论计算数据相对误差较大.     

CFD Analysis of Ship-to-Ship Hydrodynamic Interaction

A numerical study of ship-to-ship interaction forces is performed using a commercial CFD code, and the results are compared with experimental data and with the results of a panel method analysis. Two ship models have been used in the interaction forces analysis: a tug and a tanker, advancing parallel to each other with different lateral distances and two different values of the fluid depth. Computations are carried out with four different flow models: inviscid and viscous flow with the free surface modeled as a rigid wall and inviscid and viscous flow with the deformable free surface. A fair agreement was obtained with available experimental data and results obtained by panel method. The influence of viscosity in the computations is found to be comparatively weak, while the wavemaking effects may be important, at small magnitude of the horizontal clearance.     

Robust network pricing and system optimization under combined long-term stochasticity and elasticity of travel demand

Network pricing serves as an instrument for congestion management, however, agencies and planners often encounter problems of estimating appropriate toll prices. Tolls are commonly estimated for a single-point deterministic travel demand, which may lead to imperfect policy decisions due to inherent uncertainties in future travel demand. Previous research has addressed the issue of demand uncertainty in the pricing context, but the elastic nature of demand along with its uncertainty has not been explicitly considered. Similarly, interactions between elasticity and uncertainty of demand have not been characterized. This study addresses these gaps and proposes a framework to estimate nearest optimal first-best tolls under long-term stochasticity in elastic demand. We show first that the optimal tolls under the deterministic-elastic and stochastic-elastic demand cases coincide when cost and demand functions are linear, and the set of equilibrium paths is constant. These assumptions are restrictive, so three larger networks are considered numerically, and the subsequent pricing decisions are assessed. The results of the numerical experiments suggest that in many cases, optimal pricing decisions under the combined stochastic-elastic demand scenario resemble those when demand is known exactly. The applications in this study thus suggest that inclusion of demand elasticity offsets the need of considering future demand uncertainties for first-best congestion pricing frameworks.     

单向复合材料高应变率下材料特性的研究(英文)

在船舶领域,复合材料及夹芯复合材料板梁结构已大量应用在舰船结构中,尤其游艇及复合材料高速艇上.在运行过程中,这些结构有时很可能会受到如砰击、碰撞等动态载荷或高速冲击载荷.然而到目前为止,大多数的结构设计所用到的材料特性仍基于低应变率情况下的准静态测试结果.该文研究了高速艇等结构中的纤维增强复合材料高应变率情况下的材料特性,通过引入一种粘弹性模型来模拟并分析研究对象.并在世界先进的INSTRON高应变率材料试验机上设计并完成了相关试验,验证了该枯弹性模型、确定了模型中的材料参数.该粘弹性模型然后被用来研究分析应变率对单向复合材料机械特性的影响.     

The structure of dissipation in the western Irish Sea front

We report on an intensive campaign in the summer of 2006 to observe turbulent energy dissipation in the vicinity of a tidal mixing front which separates well mixed and seasonally stratified regimes in the western Irish Sea. The rate of turbulent dissipation ε was observed on a section across the front by a combination of vertical profiles with the FLY dissipation profiler and horizontal profiles by shear sensors mounted on an AUV (Autosub). Mean flow conditions and stratification were obtained from a bed mounted ADCP and a vertical chain of thermistors on a mooring. During an Autosub mission of 60 h, the vehicle, moving at a speed of ~ 1.2 m s^− 1, completed 10 useable frontal crossings between end points which were allowed to move with the mean flow. The results were combined with parallel measurements of the vertical profile of ε which were made using FLY for periods of up to 13 h at positions along the Autosub track. The two data sets, which show a satisfactory degree of consistency, were combined to elucidate the space–time variation of dissipation in the frontal zone. Using harmonic analysis, the spatial structure of dissipation was separated from the strong time dependent signal at the M₄ tidal frequency to yield a picture of the cross-frontal distribution of energy dissipation. A complementary picture of the frontal velocity field was obtained from a moored ADCP and estimates of the mean velocity derived from the thermal wind using the observed density distribution. which indicated the presence of a strong (0.2 m s^− 1) jet-like flow in the high gradient region of the front. Under neap tidal conditions, mean dissipation varied across the section by 3 orders of magnitude exceeding 10^− 2 W m^− 3 near the seabed in the mixed regime and decreasing to 10^− 5 W m^− 3. in the strongly stratified interior regime. The spatial pattern of dissipation is consistent in general form with the predictions of models of tidal mixing and does not reflect any strong influence by the frontal jet.     

Quasi-two-dimensional flow on the polar β-plane: Laboratory experiments

Geophysical turbulence is strongly affected by the variation of the Coriolis parameter with latitude. This variation results in the so-called β-effect, which forces energy from small-scales to be transferred preferentially into zonal motions. This effect results in the formation of narrow jet-like zonal flows that dominate the dynamics and act as transport barriers. Here, laboratory experiments are used to reproduce this effect in decaying turbulent flows. An electromagnetic cell is used to generate an initial field of vorticity in a rotating tank. Under conditions of quasi-geostrophic flow, the β-effect is produced by depth variation of the flow instead of variation of the Coriolis parameter. The effects of changing the container geometry and the overall fluid depth on the production of jets are investigated. The results suggest that this laboratory configuration can be used to model jet formation in the oceans and that increasing fluid depth is a practical way to decrease viscous effects.     

The importance of oceanographic fronts to marine birds and mammals of the southern oceans

During the last 30 years, at-sea studies of seabirds and marine mammals in the oceans south of the Subtropical Front have described an association with major frontal areas. More recently, the advancement in microtechnology has allowed the tracking of individuals and investigations into how these marine predators actually use the frontal zones. In this review, we examine 1) the relative importance to apex predators of the different frontal zones in terms of spatial distribution and carbon flux; 2) the processes that determine their preferential use; and 3) how the mesoscale dynamics of frontal structures drive at-sea foraging strategies of these predators. We review published results from southern waters and place them in a broader context with respect to what has been learned about the importance of fronts in oceans farther north.Some fronts constitute important boundaries for seabird communities in southern waters. At a mesoscale the maximum values of seabird diversity and abundance correspond to the location of the main fronts. At-sea surveys show a strong curvilinear correlation between seabird abundance and sea surface temperatures. High mean species richness and diversity for whales and seabirds are consistently associated with the southern water mass boundary of the Antarctic Circumpolar Current, the Subtropical Front and the Subantarctic Front; in the case of the Polar Front mean seabird densities are more variable. At small-scales, variation in seabird occurrence has been directly related to the processes at fronts in a limited number of cases. A significant positive relation was found between some plankton feeding species and frontal temperature gradient–phytoplankton variables.Telemetric studies have revealed that several apex predators (penguins, albatrosses, seals) perform long, directed foraging trips either to the Subtropical front or Polar Front, depending on locality. Seabirds with low flight costs, such as albatrosses, are able to reach fronts at long distances from colonies, showing variable foraging strategies as a function of the distances involved. Diving birds such as King penguins, that travel at a higher cost and lower speed, rely on the predictable spatial distribution of mesopelagic fish found close to the Polar Front. They may use the currents associated with eddies as oceanographic cues in the active search for frontal zones. Once in these areas they dive preferentially in and below the depth of the thermocline where catches per unit effort are high. Elephant seals concentrate foraging activity principally inside or at the boundary of cyclonic eddies. These mesoscale features appear to offer exceptional productivity favourable for foraging by various diving top predators.The connection between biophysical parameters at fronts and predators is likely to be made through biological enhancement. Top predators appear to forage at locations where prey are advected by physical processes and others where prey are produced locally. Long-term research on at-sea distributions and demographic parameters of top predators are essential to assess the consequences of potential shift in front distributions in relation to global warming. Such environmental changes would add to the impact of fish extraction by the industrial fisheries on the southern food webs.