港口供电系统改进

目前港口供电系统存在体积大、结构设置不合理和不适应环境等问题,经研究提出了减小体积、优化系统配置、提高箱变安全性和环境适应性等相应对策,在研究的基础上设计了一种新型箱式变电站,解决了目前港口供电系统存在的不足.     

Effect of nozzle orifice diameter on diesel spray tip penetration according to various spray models for CFD simulation with widely varying back pressure

CFD simulations of spray tip penetration with the standard KIVA3V, ‘original gas jet’ and ‘Normal gas jet profile with breakup length formula’ (NGJBL) spray models were performed to investigate the effects of nozzle orifice size and ambient gas density combinations on the spray penetration. The accuracy of the CFD simulation results was estimated by comparing them with available experimental data. The ambient gas density was varied in 12 kg/m³ intervals from 12 to 69 kg/m³ for each nozzle orifice diameter. The nozzle orifice diameters used were 119, 140, 183 and 206 mm. A total of 20 cases in the CFD simulations were considered with combinations of the 4 nozzle orifice diameters and 5 ambient gas densities. CFD simulations with the NGJBL spray model were more accurate than those with either the standard KIVA3V or gas jet spray models as the nozzle orifice diameter and ambient gas density was increased. The NGJBL and original gas jet model is more effective in predicting the spray tip penetration near the nozzle tip region.     

Nanoparticle emission characteristics and reduction strategies by boost pressure control and injection strategies in a passenger diesel engine

This research attempted to analyze nanoparticles and other harmful exhaust emissions in accordance with injection strategies and air-fuel ratio (AFR) changes for small diesel engines. The emission characteristics were analyzed in the medium-speed condition, which is the main driving range of a diesel engine. In the case of particulate matter (PM), the number of particles was measured, analyzed, and compared to identify the correlation and emission characteristics of nanoparticles by using a dilution device and condensation particle counter (CPC), which are international standards for particle measurement recommended by the Particulate Measurement Programme (PMP). The engine torque tended to be reduced as pilot injections were added, and the torque was increased by the increased boost pressure, but reduced by the exhaust pressure increase in a part of the low-load range. The number of nanoparticles was not influenced greatly by the change in AFR, but the reduction effect on the PM weight was great depending on the boost pressure increase. In addition, the number of nanoparticles tended to increase as the fuel injection timing became closer to TDC in all conditions, and its difference became larger with an increase in AFR. In addition, in the case of the pilot injection, nanoparticle emission showed similar characteristics depending on the main injection timing, but it was increased by advanced injection timing when performing the main injection only, and the number of the nanoparticles increased as pilot injections were added. Last, the optimal conditions for EMS calibration were analyzed by selecting the conditions of torque reduction and NOx increase within 5 % from all of the engine operating conditions; optimized conditions are presented.     

Vibration reduction of H/Shaft using an electromagnetic damper with mode change

The objective of this study is to develop a damper that can reduce the amplitude of vibration in various frequency ranges. Previous H/Shaft vibration reduction methods work in a passive way. A dynamic damper reduces the amplitude of vibration at its first mode, but vibration still appears at the second mode. A mass damper or hollow shaft can shift the natural frequency to a lower or higher region. The fixed operating frequency prevents vibration from being reduced outside the operating frequency range. The proposed damper uses electromagnets as either masses or actuators to change the damper mode between dynamic damper mode and mass damper mode. The electromagnetic damper (EMD) can change its mode to respond to the vibration excitation at both low and high frequencies. The vibration reduction performance was evaluated by FRF tests in laboratory and vehicle conditions. The results were compared with those of a dynamic damper and indicate that the amplitude of vibration is reduced by 95.6 % when the EMD is implemented on an H/Shaft, whereas only 61.9 % vibration reduction is achieved by the dynamic damper.     

降钙素基因相关肽与内皮素受体A在兔实验性蛛网膜下腔出血后基底动脉的表达

目的探讨蛛网膜下腔出血(SAH)后脑血管内皮细胞降钙素基因相关肽(CGRP)及内皮素受体A(ETRA)的表达与迟发性脑血管痉挛(DCVS)之间的关系。方法日本大耳白家兔60只,随机分为SAH模型组25只,盐水组25只,穿刺组5只,正常组5只。采用枕大池二次注血法制作SAH模型,灌注处死后取基底动脉制成切片。进行CGRP及ETRA的免疫组化和HE染色,观察CGRP与ETRA的免疫表达和病理结构变化,并用图像分析方法测量血管周长,使用方差分析进行统计学检验。结果基底动脉周长在SAH后均发生明显缩窄,其中在5d时缩小最强烈。CGRP与ETRA免疫阳性标记颗粒在SAH组的基底动脉组织中均有表达,其动态变化规律为CGRP的表达在1h时最明显,在3、5d依次表达减少,5d达到最低点,7d后开始逐渐升高,10d时表达相对比较明显,但未能达到正常水平,CGRP在穿刺组、正常对照组和盐水组也有散在不规则表达。在正常组、穿刺组和盐水组的基底动脉内ETRA有表达;SAH组基底动脉内ETRA在3d组和5d组表现为高表达,以3d组为强,而其中血管内皮细胞表达最强烈,平滑肌也有表达,10d组的表达仍然较强。结论在SAH后脑血管内皮细胞CGRP和ETRA的表达呈现明显的动态改变,但二者的变化趋势并不同步;CGRP和ETRA在DCVS的发生发展中起重要的作用。     

Effect of ABCA1-V771M polymorphism on plasma lipid levels and its relationship with coronary atherosclerotic heart disease

Objective To explore the risk association of ABCA1-V771M polymorphism with coronary heart disease (CHD) in Hart nationality in Northwest of China. Methods With case-control study, ABCA1-V771M polymorphism was detected in 204 unrelated Hart nationality people in Northwest of China, and all the subjects by coronary angiography were grouped into 106 cases and 98 controls. The genotypes and alleles frequency distribution of ABCA1-V771M polymorphisms were analyzed by PCR-RFLP analysis, and the clinical statistics of serum lipids were compared and its effects of ABCA1-V771M polymorphism on the plasma lipid levels and coronary atherosclerotic heart disease were analyzed. Results The genotypic frequencies of ABCA1-V771M polymorphism matched well under Hardy-Weinberg equilibrium (P>0.05), V and M allelic frequencies were 33.3% and 66.7%. In comparison with VV VM genotype carriers, MM genotypes carriers had much lower plasma levels of HDL-C (P<0. 001) and much higher plasma levels of TG (P<0. 05). M allelic frequency in CHD group was significantly higher than V allelic frequency (P<0. 05). M allele was related with more severity of atherosclerosis in the coronary artery than V allele (P<0.05). However, there was no obvious difference in the incidence of AMI among carriers with three genotypes of ABCA1-V771M polymorphism (P>0.05). Conclusion ABCA1-V771M polymorphism was not only associated with the plasma levels of HDL-C and TG, but also related to the susceptibility and severity of coronary atheroselerotic heart disease. Moreover, M771 allele appeared to be atherogenie among Han population in Northwest of China.     

脑弥漫性轴索损伤实验装置的研制及动物模型的建立

目的 自制一种脑弥漫性轴索损伤(DAI)装置并成功建立DAI动物模型.方法 自制头颅瞬间旋转损伤装置,使大鼠头颅在瞬间(<3ms)旋转90°造成剪切损伤.观察损伤后大鼠的生命体征及行为学改变;于伤后2、6、12、24、36、72h及10d分别处死损伤组动物,制备脑石蜡切片,行镀银及HE染色,光镜下观察神经轴索变化.结果 伤后大鼠均即刻出现原发昏迷,其中2只于损伤后20min内死亡,余持续时间1-30min不等;伤后大鼠呼吸节律紊乱,瞳孔对光反射减弱或消失,醒后均有程度不等的反应性下降,肢体活动迟缓;肉眼可见广泛蛛网膜下腔出血或脑室出血;光镜下可见皮髓交界区、胼胝体区、脑干、小脑白质等部位的神经轴索有不同程度的肿胀、断裂、轴索球形成,后期有小胶质细胞增生,局部呈巢样聚集.结论 本装置能造成大鼠脑DAI,且具有简便、可控、确切的特点,适合进行中、小型动物DAI模型的实验研究.     

5-羟色胺转运体基因多态性和抑郁症的发病、性别、严重程度及自杀行为的相关性

目的探讨中国汉族人群5-羟色胺转运体启动区(5-HTTLPR)基因多态性和抑郁症的发病、性别、严重程度及自杀是否相关。方法应用聚合酶链式反应(PCR)扩增技术测定150例抑郁症患者和150例正常对照者的5-HT-TLPR基因型和等位基因,分别验证各种基因型与中、重度抑郁症发病、性别及自杀行为的相关性。结果病例组SS、LS基因型及S等位基因频率均高于对照组(26.0% vs.20.0%;52.7% vs.46.0%;52.3% vs.43.0%;P均<0.05);两组性别分层比较,女性S等位基因频率高于对照组(55.3% vs.43.6%,P<0.05);病例组严重程度分层比较差异无统计学意义(P>0.05);病例组有无自杀行为分层比较,有自杀行为患者SS基因型频率(37.3% vs.20.2%)及S等位基因频率(61.8% vs.47.5%)均高于无自杀行为患者(P<0.05);抑郁自杀组性别分层比较未显示显著性差异(P>0.05);抑郁自杀组病情程度分层比较,重度抑郁自杀者SS基因型频率(42.5% vs.18.2%)及S等位基因频率(68.7% vs.36.4%)均高于中度抑郁自杀者(P<0.05)。结论在中国汉族人群中,5-HTTLPR多态性和抑郁症相关。S等位基因可能是抑郁症的易感基因,特别是女性,SS型可能是抑郁症易感基因型;S等位基因可能是抑郁症患者自杀的危险基因,SS基因型人群可能是抑郁症患者自杀的危险人群,特别是携带S等位基因的重度抑郁症患者更易自杀。     

城市混合交通控制设计理念与方法

针对我国城市特有的混合交通特性,在分析城市路网特征和交通流运行特征的基础上,确立了混合交通控制系统设计的基本理念。基于混合交通流理论,建立了城市交通控制的方法体系,包括匝道控制、单点控制、干线协调控制、区域协调控制以及公交优先控制。运用此设计理念与方法开发出的混合交通控制系统（HiCON）,在北京、青岛、福州三地的应用表明：车辆平均延误减少10％～20％,平均行程时间降低5%-10％。     

爆炸荷载作用下柔性支承钢筋混凝土梁动力响应分析

钢筋混凝土结构在爆炸荷载下的承载能力可以通过设置柔性支承提高。理想的刚性支承在实际结构中很难实现,通常都是柔性支承。通过在梁两端设置弹簧和阻尼器,建立了柔性支承条件下的钢筋混凝土梁的数值计算模型。运用LS-DYNA有限元分析程序对所建立的柔性支承梁有限元模型进行了计算。研究表明:与理想刚性支承相比,柔性支承对钢筋混凝土梁的变形有很大阻碍作用。梁的变形随着弹性支承刚度的减小而减小,并且结构的振动周期会随之增大。梁的挠度随着阻尼支承系数的增大而减小。因此,设置合理的弹性支承和阻尼支承可以提高钢筋混凝土结构的抗力。