Development of engine control using the in-cylinder pressure signal in a high speed direct injection diesel engine

Emission regulations are becoming more stringent and remain a principal issue for vehicle manufacturers. Many engine subsystems and control technologies have been introduced to meet the demands of these regulations. For diesel engines, combustion control is one of the most effective approaches for reducing not only engine exhaust emissions but also cylinder-by-cylinder variation. However, the high cost of pressure sensors and the complex engine head design for additional equipment present difficulties for manufacturers. In this paper, cylinder pressure-based engine control logic is introduced for a multi-cylinder high speed direct injection (HSDI) diesel engine. The time for 50% of the mass fraction to be burned (MFB50) and the IMEP are valuable for determining the combustion status. These two in-cylinder quantities are measured and applied to the engine control logic. Fuel injection timing is controlled to adjust the operating MFB50 to the target MFB50 using PID control logic, and the fuel injection quantity is controlled to adjust the measured IMEP to the desired IMEP. The control logic is demonstrated at steady state and during transient conditions and is applied to an NEDC mode test.     

Dynamic analysis of energy storage unit of the hydraulic hybrid vehicle

A new configuration of hydraulic hybrid vehicle (HHV) was presented, which mainly consists of an engine, high-pressure accumulator, lower-pressure reservoir and hydraulic transformer (HT) connected to common pressure rail (CPR), and the working principle of hydraulic hybrid vehicle has been described to extend its energy-regenerated potential. Moreover, the mathematical models of the instantaneous pressure ratio of HT and the characteristic parameters of parallel and series accumulator (i.e. effective volume, specific energy, and charge-discharge efficiency) based on lumped parameters method were built, respectively. The simulation and experimental tests of dynamic characteristics of HT and accumulator were done, the result shows that the theoretical analysis was the same as the experimental results by comparing them in the curve trend, and the series accumulator was much superior to parallel accumulator in terms of pulsation damping of hydraulic transformer, that is the simulation results reasonably and appropriately.     

Active noise control in a duct system based on a frequency-estimation algorithm and the FX-LMS algorithm

In this paper, an indirect feedback active noise control (ANC) scheme, based on the fundamental frequency-estimation method, is proposed for systems with multiple tonal noises. The engine noise consists of the harmonic components of the rotation of the crankshaft in the engine. When it is difficult to obtain reference signals, which are necessary for a feedforward ANC, conventional ANC algorithms do not work. In this paper, a new method is proposed to generate reference signals with estimated frequencies. The proposed algorithm consists of two parts: the frequency-estimation (FE) algorithm for the estimation of the fundamental frequency of the rotating machinery and then the conventional filtered-x LMS (FX-LMS) algorithm. In the second algorithm, the reference signal is generated using the fundamental frequency as estimated in the first algorithm. The FE algorithm uses a second-order adaptive notch filter, which is insensitive to impulse noise. In addition, the FE algorithm has good tracking capability and a lower variance of frequency-estimation error for a constant sinusoid signal and chirp signal. The performance of the proposed ANC method is verified through simulations and an experiment using a DSP board (DS-1104) inside a short duct.     

Intelligent speed adaptation: Preliminary results of on-road study in Penang,Malaysia

The first field experiment with intelligent speed adaptation (ISA) in Malaysia was held in December 2010 in the State of Penang. Eleven private cars were instrumented with an advisory system. The system used in the present study included a vocal warning message and a visual text message that is activated when the driver attempts to exceed the speed limit. When the driver decreases the speed, the warning stops; otherwise it is continuously repeated. The test drivers drove the vehicles for three months with the installed system, and the speed was continuously logged in all vehicles. The warning was however only activated in the second month of the three month period. The present study aimed to evaluate the effects of an advisory ISA on driving speed, traffic safety, and drivers' attitude, behavior, and acceptance of the system. To examine these effects, both the survey and the logged speed data were analyzed and explored. The results show a significant reduction in the mean, maximum and 85th percentile speed due to the use of the system. However, there was no long-lasting effect on the speed when the system was deactivated. In the post-trial survey, drivers declared that the system helped them well in following the speed limits and that it assisted them in driving more comfortably. Furthermore, the warning method was more accepted compared to a supportive system, such as active accelerator pedal (AAP). After the trial, most drivers were willing to keep an ISA system.     

Sustainable urbanization using high speed rail (HSR) in Karnataka,India

Considering the present trends of urbanization and motorization in India, there is an urgent need for integration, revitalization and renewal of the smaller towns and cities to make urban areas in India more sustainable. Unless our regional space is reorganized to upgrade development of towns and cities and integrate them with each other and the larger cities, the urbanization process in India will become unsustainable. It is argued that High Speed Rail (HSR) can play a role in achieving this more balanced and sustainable development of towns and cities, opening up opportunities for growth across a wider, inter-connected, region, with the benefit of taking the pressure of the larger cities to absorb additional burgeoning populations. This paper will make the case that in the current Indian context, current patterns of mega-city growth are unsustainable, and that HSR can play an important role in providing opportunities for medium and smaller size cities through their interconnections. It begins by highlighting the role that railways have played in India and other countries, noting that merely economic analysis of their costs and benefits generally underestimated their contributions to development. It then provides an introduction to HSR and its potential impact in general, before applying this to the example of the State of Karnataka in South India.     

Productivity change in Nigerian seaports after reform: a Malmquist productivity index decomposition approach

ABSTRACT

During the 1990s, Nigerian seaports were considered inefficient, unsafe due to massive cargo theft (wharf rat phenomenon) and one of the most expensive port systems in the world. This resulted in long turnaround times for ships and increased container dwell times. As a result, port operations were transferred to the private sector through concession contracts. This paper employs a Malmquist productivity index (MPI) technique to benchmark pre-and post-reform total factor productivity growth of the six major Nigeria seaports (Apapa, Calabar, Onne, Port Harcourt, TinCan Island and Warri) for the period 2000–2011 which represents six years before (2000–2005) and six years after (2006–2011) the reform. The results indicate progress in technical efficiency of the ports after reform but deterioration in technological progress. Overall productivity growth was higher in the pre-concession period compared to the post-concession period. The source of pre-concession period productivity growth was technological progress while the change in productivity of the post-concession period is generated by an increase in scale efficiency. This suggests that concessionaires have not brought in the much anticipated investment in modern technology to drive port efficiency. The ports of Calabar and Apapa experienced the highest productivity growth while lowest result was Onne.