Egg production and associated losses of carbon, nitrogen and fatty acids from maternal biomass in Calanus finmarchicus before the spring bloom

We present concurrent data on ingestion, egg production and the loss of maternal biomass in pre-spring bloom female Calanus finmarchicus incubated under conditions representative of those in situ in the North Atlantic. A balanced metabolic budget was constructed and used to examine the relative importance of ingestion and biomass for fuelling egg production during the incubations. Ingested carbon was not sufficient to meet the observed demands for egg production. More than 80% of the carbon utilised by the females was instead derived from their biomass. Fatty acid analysis demonstrated that the storage reserves, 20:1 (n−9) and 22:1 (n−11), were virtually absent before experimentation began, and therefore could not have been used to supply the carbon required for egg production during the incubations. The C:N mass-specific ratio of the biomass utilised was 4.1, suggesting that the females had instead catabolised protein in order to meet their metabolic demands. These results suggest that C. finmarchicus adopts a sacrificial reproductive strategy when food availability is low.     

The structure of dissipation in the western Irish Sea front

We report on an intensive campaign in the summer of 2006 to observe turbulent energy dissipation in the vicinity of a tidal mixing front which separates well mixed and seasonally stratified regimes in the western Irish Sea. The rate of turbulent dissipation ε was observed on a section across the front by a combination of vertical profiles with the FLY dissipation profiler and horizontal profiles by shear sensors mounted on an AUV (Autosub). Mean flow conditions and stratification were obtained from a bed mounted ADCP and a vertical chain of thermistors on a mooring. During an Autosub mission of 60 h, the vehicle, moving at a speed of ~ 1.2 m s^− 1, completed 10 useable frontal crossings between end points which were allowed to move with the mean flow. The results were combined with parallel measurements of the vertical profile of ε which were made using FLY for periods of up to 13 h at positions along the Autosub track. The two data sets, which show a satisfactory degree of consistency, were combined to elucidate the space–time variation of dissipation in the frontal zone. Using harmonic analysis, the spatial structure of dissipation was separated from the strong time dependent signal at the M₄ tidal frequency to yield a picture of the cross-frontal distribution of energy dissipation. A complementary picture of the frontal velocity field was obtained from a moored ADCP and estimates of the mean velocity derived from the thermal wind using the observed density distribution. which indicated the presence of a strong (0.2 m s^− 1) jet-like flow in the high gradient region of the front. Under neap tidal conditions, mean dissipation varied across the section by 3 orders of magnitude exceeding 10^− 2 W m^− 3 near the seabed in the mixed regime and decreasing to 10^− 5 W m^− 3. in the strongly stratified interior regime. The spatial pattern of dissipation is consistent in general form with the predictions of models of tidal mixing and does not reflect any strong influence by the frontal jet.     

The relevance of international transport costs on food prices: Endogenous and exogenous effects

The paper addresses the problem of transport costs and their influence on food prices for South American imports. While transport does not seem to be in the focus of existing analyses, its impact on food prices might be underestimated and even closely linked to the development of commonly mentioned drivers of food prices. Since transport price formation is a function of demand and supply, drivers of food prices are also expected to impact on transport prices. The authors argue that a number of relevant factors that drive transport costs - and in consequence food prices - can be influenced by policy makers. Based on empirical analysis, the authors explain the functioning of the determinants of transport costs in the segment of international shipping, trying to describe their exogenous and endogenous components. These results are discussed in reference to policy development in the region.     

Unsteady finite-depth effects during resistance tests on a ship model in a towing tank

This paper covers an extension of the study of Doctors et al. (J Ship Res 52(4):263–273, 2008) on oscillations in wave resistance during the constant-velocity phase of a towing-tank resistance test on a ship model to the case of relatively shallow water. We demonstrate here that the unsteady effects are very prominent and that it is essentially impossible to achieve a steady-state resistance curve in a towing tank of typical proportions for a water-depth-to-model-length ratio of 0.25. This statement is particularly true in the speed region near a depth Froude number of unity. However, on the positive side, we show here that an application of unsteady linearized wave-resistance theory provides an excellent prediction of the measured total resistance, when one accounts for the form factor in the usual manner. Finally, a simple application of the results to the planning and analysis of towing-tank tests is presented.     

Integrated reliability and sizing optimization of a large composite structure

In this paper, we present the application of probabilistic design modeling and reliability-based design optimization (RBDO) methodology to the sizing optimization of a composite advanced submarine sail structure under parametric uncertainty. With the help of probabilistic sensitivity analysis, the influence of individual random variables on each structural failure mode is examined, and the critical modes are treated as probabilistic design constraints under consistent lower bounds on the corresponding reliability indices. Whereas the failure modes are evaluated for structural components in the solution of the RBDO problem, the overall system reliability is also evaluated as a post-optimization step. The results indicate that in comparison to a deterministic-optimum design, the structural mass of the probabilistic optimum design is slightly higher when consistent probabilistic constraints are imposed, and the overall structural stiffness is found to be more critical than individual component laminate ply thicknesses in meeting the specified design constraints. Moreover, the post-optimality analysis shows that the overall system failure probability of the probabilistic optimum design is more than 50% lower than that of the deterministic optimal design with less than 5% penalty in structural mass.     

Influence of the slice position on chloride migration tests for concrete in marine conditions

Chloride migration tests are used to measure the concrete capacity to inhibit chloride attack. Many researchers carry out this test in a slice of concrete extracted from the central part of cylindrical specimens, discarding about 75% of the concrete used to mold the specimens. This fact generated the question: would it be possible to extract more slices from a same specimen without losing the confidence in the results? The main purpose of this work is to answer this question. Moreover, another aim of this study was to show the difference of chloride penetration between finished faces and the formwork surfaces of concrete beams and slabs. The results indicated that it is possible to use more slices of a single specimen for a chloride migration test. Moreover, it was demonstrated that there is a significant difference of chloride penetration between the finished surface and the formwork surface of the specimens.     

A study of vibration and vibration control of ship structures

This paper examines the vibration characteristics and vibration control of complex ship structures. It is shown that input mobilities of a ship structure at engine supports, due to out-of-plane force or bending moment excitations, are governed by the flexural stiffness of the engine supports. The frequency averaged input mobilities of the ship structure, due to such excitations, can be represented by those of the corresponding infinite beam. The torsional moment input mobility at the engine support can be estimated from the torsional response of the engine bed section under direct excitation. It is found that the inclusion of ship hull and deck plates in the ship structure model has little effect on the frequency-averaged response of the ship structure. This study also shows that vibration propagation in complex ship structures at low frequencies can be attenuated by imposing irregularities to the ring frame locations in ships. Vibration responses of ship structures due to machinery excitations at higher frequencies can be controlled by structural modifications of the local supporting structures such as engine beds in ships.     

Home-to-work commuting,urban form and potential energy savings: A local scale approach to regional statistics

The link between transport energy consumption and land use patterns has been the focus of a considerable amount of academic works over the past decades. While many empirical researches are backed up with solid statistical techniques, most of them do not fully consider the influence of scale underlying empirical quantitative investigations. Using fine-scale home-to-work commuting data for Wallonia (Belgium), this paper re-evaluates Breheny’s (1995) assertion that urban structure should hold the characteristics of major cities if substantial energy savings are to be achieved. A local scale approach highlights efficient settlements in terms of transport energy consumption not only within major towns, but also within remote rural areas. Furthermore, results suggest that influencing the urban form following local energy efficient examples rather than regional ones could also yield significant gains, without an extreme policy stance of re-urbanisation in major cities.     

Sub‐optimal decision‐making and the transportation problem

A modification to the transportation problem is outlined that aims to improve the quality of predictions of trip matrices, and at the same time, allow some behavioural and economic insights. A framework is suggested within which this modification may be made and a suitable statistic and iterative process are described. A simple example demonstrates the validity of the modification and suggests some areas of difficulty with the approach.     

Some Difficulties inherent in applying Congestion Theory to Marine Problems

This paper sets out to evaluate the main areas of focus within maritime sociology and to link more closely than hitherto the various substantive discussions with general theoretical and conceptual approaches. More specifically, it suggests directions in which maritime sociology may be advanced at both empirical and conceptual levels in the future.