旧水泥混凝土路面注浆技术研究与实践

在水泥混凝土路面基础上加铺沥青混凝土路面时 ,对现有板块破损的处理十分关键 ,而其中又以板块的脱空处治为最。板底注浆是处理板块脱空常用且有效的方法 ,本文就注浆技术的原理、材料的选择、配比试验及施工实践等作了较详尽的介绍     

排气动力效应在二冲程摩托车上的应用

排气动力效应对于二冲程摩托车的性能有很大影响，特别体现在排气净化消声器的结构设计中，设计得合理，将会在保证排放控制的前提下，动力性和经济性比原车都有所改善，已经通过模拟计算及实践获得了证明。     

Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

列车运行图可调整度评价系统研究

在详细分析了列车运行图缓冲时间的大小及其分布规律对列车晚点传播影响的基础上，通过建立列车运行图调整系统，对给定晚点程度的列车进行模拟调整，从而计算出列车晚点恢复率，晚点传播区大小，连带晚点时间和关键列车运行线等。指标来达到对列车运行图可高速程度优劣评判的目的。     

Hub location with flow economies of scale

A characteristic feature of hub and spoke networks is the bundling of flows on the interhub links. This agglomeration of flows leads to reduced travel costs across the interhub links. Current models of hub location do not adequately model the scale economies of flow that accrue due to the agglomeration of flows. This paper shows that current hub location models, by assuming flow-independent costs, not only miscalculate total network cost, but may also erroneously select optimal hub locations and allocations. The model presented in this paper more explicitly models the scale economies that are generated on the interhub links and in doing so provides a more reliable model representation of the reality of hub and spoke networks.     

An Optimal Self-Tuning Controller for an Active Suspension

An optimal self-tuning control algorithm is presented for vehicle suspension design. The controller, incorporating a weighting controller, state observer and parameter estimator, is designed according to linear optimal control (LQG) theory. Based on the updated estimates of vehicle parameters and states, and the adapted weighting parameters, the LQG controller provides the optimal set of gains over different operating conditions. The feasibility and effectiveness of the proposed self-tuning system was investigated and proved by simulation studies.     

接地面部分溶化条件下冰面轮胎摩擦力的研究

综合运用流体动力润滑理论的能量守恒定律，提出了接地面部分溶化条件下冰面上汽车轮胎的摩擦力或牵引力的理论计算模型。证明了正常工作条件下，接地面上冰产生溶化的可能。对不同制动和驱动条件下轮胎摩擦力进行了计算，取得了同试验数据吻合很好的预测结果。并同已有预测模型进行了比较，比较结果表明：本文依据严格的润滑理论所推导出的冰面轮胎牵引力模型比其它已有理论模型更接近试验结果。     

Worst-Case Vehicle Evaluation Methodology - Examples on Truck Rollover/Jackknifing and Active Yaw Control Systems

A worst-case vehicle evaluation methodology is presented in this paper. This evaluation method identifies worst-case excitation signals so that the vehicle performance under extreme conditions can be assessed. Two case study examples are presented to illustrate the design procedure and potential benefits of this method: the rollover and jackknifing of an articulated truck, and the evaluation of an active yaw control system. In both cases, the worst-case method was able to produce unstable results at very modest steering/braking levels.     

我国汽车金融业的发展现状及趋势展望

首先分析了国内外汽车金融业的发展状况，并从当前我国汽车金融业存在的问题入手，着重从内部和外部环境2个方面进行了分析，从而有针对性地提出了我国汽车金融服务的改革思路和解决相关问题的政策建议，并对未来发展趋势作出理性预测和判断，制度设计上更趋于合理、完善；服务质量和水平逐步与国际接轨；竞争推动下的具有中国特色的金融创新渐趋活跃。在此基础上笔者设想了一种银行一体化的营销模式，权当为未来银行汽车金融业务的开展作一有益尝试。     

跟驰过程中驾驶员认知结构模型的建立

在道路交通4要素中(人、车、路、环境),人以其主动性和智慧性起着支配作用,是其中的主体要素。基于认知心理学的有关知识,论文采用因子分析法对五轮仪实验系统观测到的车辆跟驰数据进行分析,确定了对车辆跟驰信息提取过程有独立作用的4个因素,相应地将驾驶员认知过程划分为4个阶段,建立了车辆跟驰过程的驾驶员认知结构模型。为驾驶行为研究和车辆跟驰模型的建立提供了理论基础。