间歇式沥青混凝土搅拌设备验收方法的确定

沥青搅拌设备整机验收一般应针对主要作业性能指标进行。科学合理地确定验收项目及验收依据是验收工作的关键，根据实践经验，提出了一套切实有效的验收方法。     

Evasive manoeuvres with a steering robot

In the pursuit of an objective rating on vehicle stability performance, it is always desirable to reduce disturbances and inconsistencies during experimental evaluations, especially the ones introduced by human drivers. This paper presents the development of a steering robot designed for closed-loop steering tasks during evasive manoeuvres. It describes the controller structure and discusses experimental results, in addition to simulation/vehicle model verifications and theoretical control analysis.     

Wheel-rail contact models for vehicle system dynamics including multi-point contact

Advanced modelling of rail vehicle dynamics requires realistic solutions of contact problems for wheels and rails that are able to describe contact singularities, encountered for wheels and rails. The basic singularities demonstrate themselves as double and multiple contact patches. The solutions of the contact problems have to be known practically in each step of the numerical integration of the differential equations of the model. The existing fast, approximate methods of solution to achieve this goal have been outlined. One way to do this is to replace a multi-point contact by a set of ellipses. The other methods are based on so-called virtual penetration. They allow calculating the non-elliptical, multiple contact patches and creep forces online, during integration of the model. This allows nearly real-time simulations. The methods are valid and applicable for so-called quasi-Hertzian cases, when the contact conditions do not deviate much from the assumptions of the Hertz theory. It is believed that it is worthwhile to use them in other cases too.     

Fuzzy-logic applied to yaw moment control for vehicle stability

In this paper, we propose a new yaw moment control based on fuzzy logic to improve vehicle handling and stability. The advantages of fuzzy methods are their simplicity and their good performance in controlling non-linear systems. The developed controller generates the suitable yaw moment which is obtained from the difference of the brake forces between the front wheels so that the vehicle follows the target values of the yaw rate and the sideslip angle. The simulation results show the effectiveness of the proposed control method when the vehicle is subjected to different cornering steering manoeuvres such as change line and J-turn under different driving conditions (dry road and snow-covered).     

Neuro-Fuzzy Control of a Tracked Vehicle Featuring Semi-Active Electro-Rheological Suspension Units

This paper presents vibration control of a tracked vehicle installed with electro-rheological suspension units (ERSU). As a first step, an in-arm type ERSU is designed, and its spring and damping characteristics are evaluated with respect to the intensity of electric fields. Subsequently, a 16 degree-of-freedom model for a tracked vehicle equipped with the proposed ERSU is established followed by the formulation of a neuro-fuzzy controller. This controller takes account for both ride quality and steering stability by adopting a weighting parameter between two performance requirements. The parameter is appropriately determined by employing a fuzzy algorithm associated with two fuzzy variables: the vertical speed of the body and the rotational angular speed of the wheel. Control performances to isolate unwanted vibration from bump and random road excitations are evaluated through computer simulations. In addition, maximum speed of the vehicle with 6 Watt power absorption is investigated with respect to the road roughness.     

Dynamics of Tracked Vehicles

This paper provides a brief review of the state-of-the-art of tracked vehicle dynamics, including mobility over soft terrain, ride dynamics over rough surfaces and manoeuvrability. It is found that considerable progress has been made in the development of analytical frameworks for evaluating and predicting tracked vehicle mobility over soft terrain, taking into account the characteristics of terrain response to normal and shear loading. Certain computer simulation models for tracked vehicle mobility have been gaining increasingly wide acceptance by industry and governmental agencies in product development and in procurement. It is also found that most of the research on tracked vehicle ride dynamics and manoeuvrability is confined to operations on rigid surfaces. To achieve a realistic evaluation and prediction of the dynamic behaviour of tracked vehicles in the field, the key is to have a better understanding of terrain response to dynamic vehicular loading, including its dynamic stiffness and damping. Challenges that face vehicle dynamicists in this emerging field are identified.     

Increasing the capacity of signalized intersections with separate left turn phases

A separate turn phase is often used on the approach leg to an intersections with heavy left turns. This wastes capacity on the approach because some of its lanes cannot discharge during its green phases. The paper shows that the problem can be eliminated by reorganizing traffic on all the lanes upstream of an intersection using a mid-block pre-signal. If drivers behave deterministically, the capacity that can be achieved is the same as if there were no left turns. However, if the reorganization is too drastic, it may be counterintuitive to drivers. This can be remedied by reorganizing traffic on just some of the available lanes. It is shown that such partial reorganization still increases capacity significantly, even if drivers behave randomly and only one lane is reorganized. The paper shows how to optimize the design of a pre-signal system for a generic intersection. It also identifies both, the potential benefits of the proposed system for a broad class of intersections, and the domain of application where the benefits are most significant.     

Experimental design influences on stated choice outputs: An empirical study in air travel choice

Discrete choice experiments are conducted in the transport field to obtain data for investigating travel behaviour and derived measures such as the value of travel time savings. The multinomial logit (MNL) and other more advanced discrete choice models (e.g., the mixed MNL model) have often been estimated on data from stated choice experiments and applied for planning and policy purposes. Determining efficient underlying experimental designs for these studies has become an increasingly important stream of research, in which the objective is to generate stated choice tasks that maximize the collected information, yielding more reliable parameter estimates. These theoretical advances have not been rigorously tested in practice, such that claims on whether the theoretical efficiency gains translate into practice cannot be made. Using an extensive empirical study of air travel choice behaviour, this paper presents for the first time results of different stated choice experimental design approaches, in which respective estimation results are compared. We show that D-efficient designs keep their promise in lowering standard errors in estimating, thereby requiring smaller sample sizes, ceteris paribus, compared to a more traditional orthogonal design. The parameter estimates found using an orthogonal design or an efficient design turn out to be statistically different in several cases, mainly attributed to more or less dominant alternatives existing in the orthogonal design. Furthermore, we found that small designs with a limited number of choice tasks performs just as good (or even better) than a large design. Finally, we show that theoretically predicted sample sizes using the so-called S-estimates provide a good lower bound. This paper will enable practitioners in better understanding the potential benefits of efficient designs, and enables policy makers to make decisions based on more reliable parameter estimates.