Traffic noise abatement: How different pavements, vehicle speeds and traffic densities affect annoyance levels

In this paper, annoyance ratings from traffic noise recorded on cobblestones, dense asphalt, and open asphalt rubber pavements are assessed with regard to car speeds and traffic densities. It was found that cobblestones pavements are the most annoying; also while open asphalt rubber pavement imposes less annoyance than dense asphalt it is not significantly different. Higher car speeds always lead to greater annoyance, as does higher traffic densities. LAeq and LAmax correlate well with annoyance, but loudness is the best predictor. Roughness and sharpness exhibit inconsistent interactions.     

Back-Calculation of Ground Stress Field and Rockburst Analysis for Wunvfeng Tunnel北大核心CSCD

Studying the in-situ stress distribution at a tunnel site is very important to determine surrounding rock characteristics, the engineering design and the construction scheme. By using the multiple linear regression method based on the least square algorithm, the initial geostress field is analyzed and the corresponding regression coefficients are obtained. The ground stress obtained from the proposed back analysis is reasonable and can meet the demands of the engineering applications. From the rockburst risk level distribution diagram, it is speculated that the Wunvfeng tunnel is in the high filed stress area. Field monitoring should be strengthened and emergency plans should be made to cope with the rockburst risks during the construction process. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Property Evolution of Sulphoaluminate Grouting Material under Pressure Circulation北大核心CSCD

Water-sealed underground oil tank projects are quite different from traditional underground projects since the water-sealing conditions are very strict and the difficulties caused by the geological specificity, structural specificity and construction specificity are key factors affecting the project. In light of the significant early initial setting time and rapid temperature increase of sulphoaluminate cement-based grouting material for a large domestic water-sealed underground oil tank with pressurized cyclic grouting, a laboratory grouting simulation is conducted. It is found that the properties of the sulphoaluminate cement-based grouting material are quite different under different pressure cycles, the hydration exothermic peak time gets shorter with an increase of circulation time, the compressive strength decreases with an increase of circulation time, and the longer the circulation time the more obvious the de-crease of compressive strength. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Analysis on the Characteristics and Development Trends of the Support Technology of High Ground Stress Tunnels in China北大核心CSCD

Combining the present situation and development trend of different tunnel support technologies at home and abroad, this paper analyzes the problems of rockburst in hard rock tunnels and large deformation in soft rock tunnels caused by high ground stress. It is concluded that: 1) regarding the rockburst problem, the current support technology is mainly influenced by the rock burst mechanism which is dominated by static factors, and so the used support components are generally of smaller deformation performance and "passive support" properties; 2) as the rockburst is the result of dynamic-static stress coupling, and only the anchor bolt has the "active support" attribute in the current "shotcrete+anchor bolt+wire net" support system, so the best support system should have the two functions of active support and energy release in terms of the rockburst problem, and the key focus of the research and development is anchorage members; 3) there are three main support types for large deformation in soft rock tunnels, e.g. the heavy support, layered support and yielding support. Among them, the heavy support system in underground cavern with large deformation is easy to induce excessive surrounding rock pressure, and so the applicable conditions are limited. The layered support system is still not the best choice due to its immature theoretical study, difficult determination of the thickness value and the installation time of each support layer and the interference to construction progress. With the characteristics of timely support and yielding while supporting, the yielding support system can give full play to the performance values of surrounding rocks and supporting materials, and make both of them reach the optimal state, so it is the best choice for supporting the soft rock tunnels with large deformations. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

A Study of Prevention Techniques for Tunnel Lining Defects北大核心CSCD

Defects of tunnel lining, such as inadequate thickness, voids, cracks, rock falling and water leakage etc., endanger the safety of railway tunnel operation. Based on the site construction, an analysis of the reasons for lining defects was conducted; technical measures against lining defects were proposed and tests were carried out at site. The results show that these measures are reliable and effective, and the purposes of prevention and treatment are re⁃ alized. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Analysis on the Effects of Overloading on the Mechanical Properties of Tunnel Structures in the Silty Ground --A Case Study of Sutong River-crossing GIL Utility Tunnel北大核心CSCD

Based on the Sutong GIL utility tunnel project, which is constructed by the shield machine under the river, and as for the overloading problem at the river bank slope during operating period, the refined threedimensional finite element model was established to study the deformation and cracking characteristics of the tunnel segment structure under different forms of overloading. The evolution laws of section convergence, joint opening and structural stress were analyzed, and the structure damage mechanisms were revealed under conditions of large area loading and local loading. The surface-surcharge control standard was proposed. For the big diameter shield tunneling crossing the silty clay, the research results show that: (1) the deformation failure process is divided into three stages under large area loading condition, taking the design load and compressive yield of rebars inside haunch as the critical points respectively. The first stage is characterized by the elastic stress, the second stage is in plastic state with fracture, and the third stage is accelerating deformation and instability stage. The vertical convergence is 110.5 mm with no opening of joints when rebars are yielded; (2)the deformation failure process under local loading condition is also divided into elasticity, plasticity and instability stages, taking the design load and tensile yield of rebars outside haunch as the critical points respectively. The vertical convergence is 152.6 mm with joint opening of 4.36 mm; (3) the early-warning values of additional stress on the ground under conditions of large area loading and local loading are 110 kPa and 70 kPa respectively. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Structural Optimization and Strength Analysis of the Lifting Arm of a Wet Shotcrete Spraying Unit北大核心CSCD

Wet shotcrete spraying units are widely used in underground engineering, for railways, highways, water conservancy and hydropower stations, municipal works, mining and military and other industries. Structural analysis and mechanical behavior optimization are conducted regarding the lifting arm of a TKJ series shotcrete spraying unit, and optimization of the hinge point position and working scope of the lifting arm is realized. The optimal layout scheme for the hinge force is given based on the Monte Carlo method, the hinge force of the lifting arm is improved for the mean and maximum values, and the maximum and average hinge force of the lifting cylinder decrease by 23.14% and 7.70%, respectively, compared with that of the original scheme. The static strength is checked using Ansys-Workbench for the optimized scheme, and the results show that the optimized scheme has a larger safety re-serve and that the structural design is more reasonable than the original scheme. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Equilibria of bilateral taxi–customer searching and meeting on networks

This paper proposes an equilibrium model to characterize the bilateral searching and meeting between customers and taxis on road networks. A taxi driver searches or waits for a customer by considering both the expected searching or waiting time cost and ride revenue, and a customer seeks a taxi ride to minimize full trip price. We suppose that the bilateral taxi–customer searching and meeting occurs anywhere in residential and commercial zones or at prescribed taxi stands, such as an airport or a railway station. We propose a meeting function to spell out the search and meeting frictions that arise endogenously as a result of the distinct spatial feature of the area and the taxi–customer moving decisions. With the proposed meeting function and the assumptions underlying taxi–customer search behaviors, the stationary competitive equilibrium achieved at fixed fare prices is determined when the demand of the customers matches the supply of taxis or there is market clearing at the prevailing searching and waiting times in every meeting location. We establish the existence of such an equilibrium by virtue of Brouwer’s fixed-point theorem and demonstrate its principal operational characteristics with a numerical example.     

Evaluating locational accessibility to the US air transportation system

Although there are hundreds of airports that support commercial air passenger traffic in the United States (US), not all areas are equivalently served by the commercial air transportation system. Locations in the US differ with respect to their level of access to the commercial air network and their overall accessibility within the system. Given the complexity of the domestic commercial air passenger network and supporting infrastructure, past research has only been able to provide a limited assessment of locational accessibility within the United States. To address these complexities, this paper proposes a new metric that incorporates measures of access to air transport as well as accessibility within air transportation networks. Using a comprehensive dataset on scheduled airline service, the developed approach is then applied to the US domestic commercial passenger air transportation network to explore geographic differentials in accessibility. Results suggest marked differences between core-based statistical areas throughout the US.     

Route choice of cyclists in Zurich

This paper presents the first route choice model for bicyclists estimated from a large sample of GPS observations and overcomes the limitations inherent in the generally employed stated preference approach. It employs an improved mode detection algorithm for GPS post-processing to determine trips made by bicycle, which are map matched to an enriched street network. The alternatives are generated as a random sample from an exhaustive, but constrained search. Accounting for the similarity between the alternatives with the path-size factor the MNL estimates show that the elasticity with regards to trip length is nearly four times larger than that with respect to the share of bike paths. The elasticity with respect to the product of length and maximum gradient of the route is small. No other variable describing the routes had an impact. The heterogeneity of the cyclists is captured through interaction terms formulated on their average behaviour.