���߽�ͨ���ź��Ż�����:�ع���ǰհ

概括地回顾了一些关于离线(或脱机)交通信号灯优化设计的方法.其中包括用于在孤立交叉口的单点和区域性的联动控制系统.离线方法在设计时一般利用已有调查出来的交通数据作为固定的输入资料，这个跟实时设计方法所要求的从感应器即时检浏出来的情况作为设计依据是有本质上的区别.但一般沿用的信号配时设计方法都需要依靠已刻在行车线道上(允许通行)的方向指示标志为设计基础，但这个方向指示在确定后在整个优化过程中是维持不变的，这就限制了交通流量在线道上的分布，从而大大减低配时的灵活性，在这样情况下优化出来的结果肯定不会是最好的.直至近期，以行车线道为基本单位的配时设计方法(英文名称为Lane-based method;中文可称为线道法)发展起来.这个方法是由传统的Phase-based method(相位法)所演变出来的.线道法不但包含所有相位法的特点，而且更能为原本受约束的线道和配时设计进行全面优化.线道法可在单点交叉口和区域性的联动控制系统上应用.文末提出一些未来研究发展的新方向.     

Application of genetic algorithms for joint optimization of signal setting parameters and dynamic traffic assignment for the real network data

This paper presents the joint optimization of signal setting parameters and dynamic user equilibrium (DUE) traffic assignment for the congested urban road network. The simulation-based approach is employed to obtain the DUE condition for the case of multiple-origin multiple-destination traffic flows. The dynamic traffic assignment simulation program (DTASP), developed in C language is used to assign the traffic dynamically on the road network, whereas method of successive averages (MSA) is modified and used to arrive at the DUE condition. The artificial intelligence technique of genetic algorithms (GAs) is applied to obtain the optimal signal setting parameters and path flow distribution factor for DUE condition. The methodology developed in such a way that joint optimization of signal setting parameters with DUE is obtained. The proposed method is applied to the real network data of Fort Area of Mumbai city comprising of 17 nodes and 56 unidirectional links with 72 Origin–Destination pairs, where all the 17 nodes are signalized intersections. The traffic flow condition for the optimized signal setting parameters is considerably improved compared to the existing signal settings. The results prove that the GA is an effective technique to solve the joint optimization problem for the real network data.     

Effect of proposed CO2 emission reduction scenarios on capital expenditure

The International Maritime Organisation is currently working on establishing regulations for international shipping regarding greenhouse gas emissions, and a cost-effectiveness approach has been suggested as one method for determining the necessary reductions in emissions from shipping. Previous studies have investigated the CO₂ emission reduction potential for the world shipping fleet up to 2030 and the associated marginal abatement cost levels. To analyse the cost implications of different emission reduction scenarios, this study has calculated the emission reduction potential and additional capital expenditure for 25 CO₂ emission reduction measures applied to 59 ship segments. The expected fleet development over time, keeping track of new ships built from 2010 to 2030 and Existing ships built prior to 2010 and still in operation by 2030, have been modelled. Two alternative approaches to find the cost-effective potential in the world shipping fleet have been applied. One approach is to implement only measures which in themselves are cost-effective (measure-by-measure), and another approach is to implement measures as long as the net savings from cost-effective measures balance the costs of non-cost-effective measures (set of measures). The results demonstrate that by 2030, the majority (93%) of the reduction potential will be related to new ships. Our results show that the measure-by-measure approach would decrease the CO₂ emissions by 30% for new ships while the set-of-measures approach with 53% (of the 2030 baseline emissions of 1316?Mt). The implication of achieving such emission reduction is an increase in the capital expenditure on New ships by 6% (USD 183 billion) and 27% (USD 761 billion), respectively, in the period 2010 to 2030 compared to a business-as-usual scenario. The measure-by-measure approach yields a 5% decrease in CO₂ emission per 1% increase in capital expenditure, while the set-of-measures approach yields a 2% decrease per 1% increase. This is due to the significant variation in capital intensity of the different measures, ranging from almost zero to USD 200 per tonne of CO₂ averted. The results of this study are useful for the shipping industry to assess the economic burden that must be shouldered in order to implement abatement measures under different CO₂ emission reduction scenarios.     

Generation of cyclonic eddies in the Eastern Gotland Basin of the Baltic Sea following dense water inflows: numerical experiments

A sigma (σ)-coordinate ocean model by Blumberg and Mellor (POM) is applied to study the formation processes of mesoscale cyclones observed in the Eastern Gotland Basin following the dense water inflows. The initial conditions simulate a situation when the Arkona and Bornholm basins and partially the Slupsk Furrow are already filled with the inflow water of the North Sea origin, while the Eastern Gotland and Gdansk basins still contain the old water of pre-inflow stratification. Model runs with constant and time-dependent winds, changing the buoyancy forcing, grid geometry and bottom topography display the following. Entering the Eastern Gotland Basin from the Slupsk Furrow, the bottom intrusion of saline inflow water splits in two: one goes northeast towards the Gotland Deep, and second moves southeast towards the Gulf of Gdansk. An intensive mesoscale cyclonic eddy carrying the inflow water is generated just east of the Slupsk Furrow with the inflow pulse. A number of smaller cyclones with boluses of the inflow water are formed in the permanent halocline along the saline intrusion pathway to the Gotland Deep. Following Spall and Price [J. Phys. Oceanogr. 28 (1998) 1598], the cyclones are suggested to form by the adjustment of the high potential vorticity inflow water column to a low potential vorticity environment.     

Modelling and Analysis of Turning Motion of a Subsurface Mapping AUV with Split-Hull Design

There is much need for autonomous underwater vehicles (AUVs) for inspection and mapping purposes. Most conventional AUVs use torpedo-shaped single-rigid hull, b...     

On the observability of the fortnightly cycle of the Tagus estuary turbid plume using MODIS ocean colour images

Using three years (2003 to 2005) of MODIS-Aqua normalized water-leaving radiance at 551 nm this paper shows a fortnightly cycle in the Tagus estuary turbid plume. The Tagus estuary is one of the largest estuaries of the west coast of Europe and is located in the most populated area of Portugal, including the capital Lisbon. The turbid plume has been detected by the backscattering characteristics of the surface waters in the vicinity of the estuary mouth. In fortnightly scales, the turbid plume has smaller dimensions during and after neap tides and higher dimensions during and after spring tides. This is most probably associated with the fortnightly spring–neap tidal cycle and the consequent increase in turbidity inside the estuary during spring tides. During the summer weak spring tides (tidal amplitude approximately 2.5 m) no turbid plume is observed for an entire fortnightly cycle. Outside the summer months, precipitation, river discharge and winds, were found to increase the turbid area, but the fortnightly cycle appears to be superimposed on the large time-scale variability, and present throughout the year.     

A line impedance stabilization network for pulse current injection北大核心CSCD

［Objective］Aiming at the deficiency of the existing line impedance stability network (LISN) in the electromagnetic pulse protection capability, a LISN suitable for the pulse current injection (PCI) test of electrical and electronic equipment is proposed. ［Methods］Aiming at the characteristics of high peak value and fast rise of the pulse current in PCI testing, the circuit structure and physical structure of the LISN are improved on the existing basis through PSpice time-domain and frequency-domain simulation combined with engineering design requirements, thereby giving it good nanosecond pulse protection performance and impedance stability at the same time. Pulse current protection performance test and impedance curve test experiments are then designed and carried out.［Results］The experimental results show that the improved LISN can attenuate the injected pulse current by 60 times, while the error of its impedance curve is less than 5% compared with the Type 5 µH LISN in GJB 151B-2013. ［Conclusions］The proposed LISN has good impedance stability and decoupling ability, and can be used in the PCI testing of electrical and electronic equipment in order to protect the power supply and improve the repeatability of testing. © 2023 Chinese Journal of Ship Research. All rights reserved.     

Combustion development of a Bi-Fuel engine

Environmental improvement and energy issues are increasingly becoming more important as worldwide concerns. Natural gas is a good alternative fuel that can help to improve these issues because of its large quantity and clean burning characteristics. This paper provides the experimental performance results of a Bi-Fuel engine that uses Compressed Natural Gas as its Primary fuel and gasoline as its secondary fuel. This engine is a modification of the basic 1.4-liter gasoline engine. Generally, on the unmodified base engine, torque and power for CNG fuel are considerably lower than gasoline fuel. In this paper, the influence of fuels on wall temperature, performance and emissions are investigated.     

Multiaxial stress creep rupture mechanisms of AZ31 magnesium alloy

The maximum principal stresses, von Mises effective stresses and principal facet stresses at the time of creep rupture were compared in uniaxial, biaxial, and triaxial stress states for AZ31 magnesium alloy. The creep rupture of this alloy was experimentally controlled by cavitation, which was the result of a low damage tolerance, λ. Creep deformation could be correlated with the von Mises effective stress parameter. The failure-mechanism control parameter governing the stress state coincided with the experimental results of the rupture of the materials under multiaxial stress states. Finally, the theoretical prediction based on constrained cavity growth and continuous nucleation agreed with the experimental rupture data to within a factor of three.     

Short-term Hourly Traffic Forecasts using Hong Kong Annual Traffic Census

The need for acquiring the current-year traffic data is a problem for transport planners since such data may not be available for on-going transport studies. A method is proposed in this paper to predict hourly traffic flows up to and into the near future, using historical data collected from the Hong Kong Annual Traffic Census (ATC). Two parametric and two non-parametric models have been employed and evaluated in this study. The results show that the non-parametric models (Non-Parametric Regression (NPR) and Gaussian Maximum Likelihood (GML)) were more promising for predicting hourly traffic flows at the selected ATC station. Further analysis encompassing 87 ATC stations revealed that the NPR is likely to react to unexpected changes more effectively than the GML method, while the GML model performs better under steady traffic flows. Taking into consideration the dynamic nature of the common traffic patterns in Hong Kong and the advantages/disadvantages of the various models, the NPR model is recommended for predicting the hourly traffic flows in that region.