On the axial force induced on a duct by a propulsor

The axial force induced on a duct (duct thrust) which surrounds a propulsor is, by means of an energy conservation argument, expressed in terms of the thrust and power of the propulsor and the kinetic energy losses per unit of time of the propulsor and the duct. Emphasis is put on the linear theory of an axisymmetric ducted actuator disk, where it is shown that the work done by the duct thrust is equal to the extra work done by the actuator disk when it is surrounded by the duct. This simplified model gives more insight into the interaction between the propeller and the duct and on the limits of linearization.     

Wave impact on a horizontal elastic plate

The objective is to find slamming-induced local stresses in the steel or aluminum wetdeck of a multihull vessel. This is studied theoretically by representing the wetdeck as a beam model and accounting for dynamic hydroelastic effects. Two numerical methods are used, one being a simplified asymptotic solution. Satisfactory agreement between the two methods is reported. Experimental drop tests of horizontal elastic plates of steel and aluminum are also reported, and the results from the experiments agree well with the numerical computations. This study reveals, both numerically and experimentally, that slamming-induced local stresses are strongly influenced by dynamic hydroelastic effects. The maximum bending stresses are insensitive to where waves hit, the curvature of the waves, and maximum pressures. Measured maximum pressures are very sensitive to external conditions, and cannot be used as a measure of maximum local bending stresses. A simple procedure for local design stresses due to wetdeck slamming is outlined.     

Pb and Pu in the Northeast Water Polynya, Greenland: particle dynamics and sediment mixing rates

Distributions of the radionuclides ²¹⁰Pb and ^239,240Pu in sediment cores from the Northeast Water Polynya, Greenland, showed that these nuclides reached depths of 5–15 cm by particle mixing and sediment accumulation. End-member average values of the particle mixing coefficient and sediment accumulation rate were 0.13 cm² y⁻¹ and 0.06 cm y⁻¹, obtained from the ²¹⁰Pb profiles by assuming that each process is dominant relative to the other. Both ²¹⁰Pb and ^239,240Pu were measured on four cores; using the Pu data to constrain mixing rates produced corrected sediment accumulation rates that were 20–80% of the values calculated by neglecting mixing. Organic carbon burial in the polynya sediments was ≤0.4 mmol m⁻² d⁻¹, based on measured POC values at depth in the sediments and sediment accumulation rates corrected for mixing. This value is about 1% of the independently measured POC flux leaving the euphotic zone and compares with benthic carbon remineralization rates of 7% calculated by others from O₂ uptake in the sediments.The inventories of excess ²¹⁰Pb in the sediments ranged from 6 to 28 dpm cm⁻². Relative to the atmospheric input of ²¹⁰Pb and in situ production from decay of ²²⁶Ra, approximately 5 dpm cm⁻² of ²¹⁰Pb was being removed from the water column. The difference between the removal from the water column and sediment inventories suggests a net import of ²¹⁰Pb to the polynya. This may occur by input of dissolved ²¹⁰Pb from offshore waters or by input of ²¹⁰Pb carried by sea ice. Particulate matter in land-derived fast ice adjacent to the polynya contained 330 ± 14 dpm of excess ²¹⁰Pb g⁻¹. If particles transported in sea ice are comparable to those extracted from fast ice, then sea ice transport into the polynya followed by melting may be an important source of excess ²¹⁰Pb to the area. Fast ice also may contribute ²¹⁰Pb if portions break off and melt within the polynya, as occurred in 1993.     

Acceleration noise and level of service of urban roads - A case study

Capacity measurement of roads under mixed traffic conditions as prevailing in India is ambiguous as it varies with time, composition of traffic and roadway encroachments. High incidence of slow moving vehicles and tricycles adds to the problem. Volume - capacity ratio appears to be an inadequate measure of defining level of service under mixed traffic situations. An attempt is made in this paper to explore the possibility of presenting unconventional parameters like standard deviation of speed, co-efficient of variation of speed and acceleration noise as possible measures of level of service. Tentative ranges of acceleration noise are proposed in association with flow and speed to explain level of service of urban roads catering to mixed traffic. The results are based on a study conducted in Madras, a major metropolitan city of India.     

Effect of capacity concentration on highway corridor performance

This paper investigates, through use of analytical models, the effects of capacity concentration on highway corridor performance. It concludes that when highways operate at a fixed total capacity, decreasing the highway spacing can increase the average travel time because highways will become more congested. When highways operate below capacity, decreasing the spacing is usually beneficial as it tends to reduce trip length when accessing highways, and allows a greater percentage of travel to be completed on highways instead of arterials.     

Subsidy and public transit performance: A factor analytic approach

The need to measure and evaluate transit system performance has led to the development of numerous performance indicators. However, depending upon the indicator, we oftentimes reach different conclusions regarding transit system performance. The research reported in this paper uses factor analytic methods to generate a set of underlying attributes (factors) that capture the performance of public transit systems in Indiana. Similar to what is reported in the literature, this study finds three attributes that best describe transit system performance: efficiency, effectiveness, and overall performance. Based upon systemsÕ factor scores, the study finds that systems scoring highly on one attribute generally perform well on the remaining attributes. Further, there is an inverse relationship between system performance and subsidies, a finding that supports performance based subsidy allocations.     

客运专线先张法预应力混凝土箱梁制梁台座的设计

客运专线先张法预应力混凝土箱梁的制梁台座是大吨位先张法制梁工艺的关键设备，需要承受高达51000kN的巨大张拉力。提供了制梁台座的实用设计，为大吨位先张梁的制造提供了必要的技术支持。     

提高牵引变电所故障测距装置精确度的对策

指出牵引变电所故障测距装置的精确度是动态变化的,应根据接触网、变电所设备及装置运行情况的变化及时调整故障测距整定值,以提高其精确度,提出电气化铁道复线并联供电时避免线路互感影响牵引变电所故障测距装置精确度的简便方法即复线单线化。     

对桥梁养护与管理工作的几点体会

如何养护管理好现有桥梁,保持桥梁的完好工作状态,延长其使用寿命,这一新的课题已摆在各级公路管理部门的面前。通过几年来的工作,浅谈以下几点看法。