Multiaxial stress creep rupture mechanisms of AZ31 magnesium alloy

The maximum principal stresses, von Mises effective stresses and principal facet stresses at the time of creep rupture were compared in uniaxial, biaxial, and triaxial stress states for AZ31 magnesium alloy. The creep rupture of this alloy was experimentally controlled by cavitation, which was the result of a low damage tolerance, λ. Creep deformation could be correlated with the von Mises effective stress parameter. The failure-mechanism control parameter governing the stress state coincided with the experimental results of the rupture of the materials under multiaxial stress states. Finally, the theoretical prediction based on constrained cavity growth and continuous nucleation agreed with the experimental rupture data to within a factor of three.     

Correcting injection pressure maladjustments to reduce NOX emissions by marine diesel engines

Emissions from the exhausts of marine diesel engines comprises several different gases including NO_X. These are currently regulated at the international level under Regulation 13 of ANNEX VI of MARPOL 73/78, but this regulation only applies to new engines and is based on bench tests, for only a single engine designated the “parent engine”. Here, the need to take measurements from across their whole range and once in operation on board a vessel is examined. This would not only improve assessment of new equipment against the current regulation, but would also detect defects in the functioning of the engine.     

Automation of paratransit reservation,routing, and scheduling

Santa Clara County, California experienced a sharp growth in demand‐responsive paratransit ridership for individuals with disabilities, as a result of the passage of the 1990 Americans With Disabilities Act (ADA). This paper describes an automated paratransit system for the ADA‐type paratransit operation implemented in Santa Clara County. It automated paratransit reservation, scheduling, and routing functions. The key components of this system were a digital geographic database (DGD) and an automated trip scheduling system (ATSS). Empirical evidence after one year of operation indicates numerous benefits of this automation. There were significant reductions in the paratransit operating costs and an increase in the percent shared rides. The savings in operating costs far exceeded the annualized capital cost of automation. A user survey indicates that these improvements were achieved without degradation to service quality such as vehicle on‐time performance, invehicle travel times, vehicle response to open return, and ride comfort.     

Transport economics: A personal view

The field of transportation attracts individuals from diverse backgrounds, seeking to make contributions to policy, planning, operations and strategy. Economists are one of the more visible subsets of players, who bring a specific focus to the transport problem. The key theme of this paper is economic efficiency and ways that transport economics seeks to achieve efficient outcomes in the presence of markets and institutions that to varying degrees distort the potential to fulfil this primary goal. We review some of the recent contributions to the literatures on institutional and market reform, travel choice and demand. As we enter the next century, there is a sense of promoting ‘back to basics’ (and redefinition of what skills transport specialists will require) in seeking a better understanding of the role of markets and institutions in guiding the destiny of the transport sector.     

Intermodal and international freight network modeling

The authors describe the development and application of a single, integrated digital representation of a multimodal and transcontinental freight transportation network. The network was constructed to support the simulation of some five million origin to destination freight shipments reported as part of the 1997 United States Commodity Flow Survey. The paper focuses on the routing of the tens of thousands of intermodal freight movements reported in this survey. Routings involve different combinations of truck, rail and water transportation. Geographic information systems (GIS) technology was invaluable in the cost-effective construction and maintenance of this network and in the subsequent validation of mode sequences and route selections. However, computationally efficient routing of intermodal freight shipments was found to be most efficiently accomplished outside the GIS. Selection of appropriate intermodal routes required procedures for linking freight origins and destinations to the transportation network, procedures for modeling intermodal terminal transfers and inter-carrier interlining practices, and a procedure for generating multimodal impedance functions to reflect the relative costs of alternative, survey reported mode sequences.     

Effect of rear slant angle on vehicle crosswind stability simulation on a simplified car model

It is important to know the effect of the aerodynamic forces and moments on driving stability because it is responsible for the excitation and influences the response of the vehicle. The purpose of this paper is to study the effect of rear slant angle of a surface vehicle on crosswind sensitivity for stability analysis. The vehicle mathematical model used to conduct a dynamic simulation was based on a simple reduced order lateral dynamics of sideslip and yaw rate motion coupled with aerodynamics model. The intention here is to compare the effect of rear slant angles response to crosswind and to rank the crosswind sensitivity ratings. The aerodynamic loads are defined as the function of the aerodynamic derivatives from the static wind tunnel tests. Result shows a 20° rear slant angle demonstrates the highest rating of crosswind sensitivity, while zero degree slant exhibits the least.     

Propagating buckles in corroded pipelines

Rigid–plastic solutions for the steady-state, quasi-static buckle propagation pressure in corroded pipelines are derived and compared to finite element predictions (ABAQUS). The corroded pipeline is modeled as an infinitely long, cylindrical shell with a section of reduced thickness that is used to describe the corrosion. A five plastic hinge mechanism is used to describe plastic collapse of the corroded pipeline. Closed-form expressions are given for the buckle propagation pressure as a function of the amount of corrosion in an X77 steel pipeline. Buckles that propagate down the pipeline are caused by either global or snap-through buckling, depending on the amount of corrosion. Global buckling occurs when the angular extent of the corrosion is greater than 90°. When the angular extent is less than 90° and the corrosion is severe, snap-through buckling takes place. The buckle propagation pressure and the corresponding collapse modes also compare well to finite element predictions.     

Activity patterns,time use,and travel of millennials: a generation in transition?

Millennials, defined in this study as those born between 1979 and 2000, became the largest population segment in the United States in 2015. Compared to recent previous generations, they have been found to travel less, own fewer cars, have lower driver’s licensure rates, and use alternative modes more. But to what extent will these differences in behaviour persist as millennials move through various phases of the lifecycle? To address this question, this paper presents the results of a longitudinal analysis of the 2003–2013 American Time Use Survey data series. In early adulthood, younger millennials (born 1988–1994) are found to spend significantly more time in-home than older millennials (born 1979–1985), which indicates that there are substantial differences in activity-time use patterns across generations in early adulthood. Older millennials are, however, showing activity-time use patterns similar to their prior generation counterparts as they age, although some differences – particularly in time spent as a car driver – persist. Millennials appear to exhibit a lag in adopting the activity patterns of predecessor generations due to delayed lifecycle milestones (e.g. completing their education, getting jobs, marrying, and having children) and lingering effects of the economic recession, suggesting that travel demand will resume growth in the future.