Recursive least squares algorithm for a nonlinear additive system with time delay

This paper proposes a recursive least squares algorithm for a nonlinear additive system with time delay. By the Weierstrass approximation theorem and the key term separation principle, the model can be simplified as an identification model. Based on the identification model, a recursive least squares identification algorithm is used to estimate all the unknown parameters of the time-delayed additive system. An example is provided to show the effectiveness of the proposed algorithm.     

Decomposing and Cluster Refinement Design Method for Application-Specific Network-on-Chips

Along with higher and higher integration of intellectual properties (IPs) on a single chip, traditional bus-based system-on-chips (SoC) meets several design difficulties (such as low scalability, high power consumption, packet latency and clock tree problem). As a promising solution, network-on-chips (NoC) has been proposed and widely studied. In this work, a novel algorithm for NoC topology synthesis, which is decomposing and cluster refinement (DCR) algorithm, has been proposed to minimize the total power consumption of application-specific NoC. This algorithm is composed of two stages: decomposing with cluster generation, and cluster refinement. For partitioning and cluster generation, an initial low-power solution for NoC topology is generated. For cluster refinement, the clustering is optimized by performing floorplan to further reduce power consumption. Meanwhile, a good tradeoff between power consumption and CPU time can be achieved. Experimental results show that the proposed method outperforms the existing work.     

正激变换器的五维可视化优化设计

本文对正激变换器进行了输出本安特性分析,从满足纹波电压指标和最大输出短路放电能量最小的角度,采用五维数据可视化技术,在MATLAB环境下通过程序设计展现全局的值域分布,从而对电感、电容参数进行优化设计,以提高电路的稳定性。     

Full Duplex Communications for Next Generation Cellular Networks: The Capacity Gain

Full duplex communication highly improves spectrum efficiency of a wireless communication link. However, when it is applied to a cellular network, the capacity gain from this technology remains unknown. The reason is that full duplex communication changes the aggregate interference experienced by each communication link in cellular networks. In this paper, the capacity gain from full duplex communication is studied for cellular networks of 4G and beyond, where the same frequency channel is adopted in each cell. A two-layer Poisson point process (PPP) is adopted to model the network topology, and stochastic geometry is employed to derive the coverage probability and the average capacity of typical link in a cellular network. On the basis of these derived parameters, the capacity gain from full duplex communication is determined. Numerical results reveal that without mutual interference cancellation (MIC), the capacity gain is small under various power levels; with perfect MIC at base stations, the capacity gain can exceed 60%; with imperfect MIC at base stations, the capacity gain decreases quickly even with a slight drop of MIC performance.     

KHB型高压油脂润滑泵在汽车底盘集中润滑系统中的应用

主要介绍集中润滑在汽车底盘的重要性,重点分析中高压集中润滑系统在实际使用过程中更加节省油脂,为客户创造更多价值,阐述集中润滑系统的发展趋势,为汽车整车和零部件的研发工作提供参考。     

Modeling and simulation of a counter-rotating turbine system for underwater vehicles

The structure of a counter-rotating turbine of an underwater vehicle is designed by adding the counter-rotating second-stage turbine disk after the conventional single-stage turbine. The available kinetic energy and the absorption power of the auxiliary system are calculated at different working conditions, and the results show that the power of the main engine and auxiliary system at the counter-rotating turbine system matches well with each other. The experimental simulation of the lubricating oil loop, fuel loop, and seawater loop are completed right before the technology scheme of the counter-rotating turbine system is proposed. The simulation results indicate that the hydraulic transmission system can satisfy the requirements for an underwater vehicle running at a steady sailing or variable working conditions.     

无线调车机车信号和监控系统实际应用中无线通信解决方案研究

在配有无线调车机车信号和监控系统(STP)的铁路车站,如果站场存在高建筑物、山体、多隧道、特长隧道等特殊情况,会使车地无线通信出现信号弱或者无信号现象。针对这些特殊站场情况,给出几种无线通信解决方案,并在实际工程项目中有效地解决信号弱或者无信号问题。     

Dynamic Behavior of Two Part Towing Cable System During Turning

An improved numerical method is used to simulate the dynamic behavior of a two part towing cable systems during turnings. In U turns and full turns, periodical heave motions are found both for the towed vehicle and for the depressor. Periodic motions of the subsea units and of the cable surface tension are closely related to the turning parameters, such as turning velocity and turning radius. System parameters, such as length of the second cable and the vehicle hydrodynamics, also damp turning instability.     

反应条件对产物晶型和形貌的影响以二氧化锰为例

本文采用水热法制备了一系列的二氧化锰粉末状晶体。探索了反应温度、氧化剂浓度、压力等因素对二氧化锰晶型、结晶度与形貌的影响及其内在联系。结果表明反应温度、氧化剂浓度、压力对二氧化锰晶型均有影响,氧化剂浓度对其晶型影响尤为明显。温度对形貌影响较为明显。在晶型相同情况下,二氧化锰结晶度正相关于其形貌规整度。