Dynamic demand estimation and microscopic traffic simulation of a university campus transportation network

Abstract

This article documents the authors' experience with the modeling, simulation, and analysis of a university transportation system, using the TRansportation ANalysis and SIMulation System (TRANSIMS). The processes of data preparation and network coding are described, followed by the algorithm developed to estimate the dynamic 24-hour demand, which includes a procedure for estimating the ‘desirability’ of the different parking lots from readily available data. The dynamic demand estimation algorithm is validated by comparing estimated and observed parking lot occupancies, where it is shown that the algorithm is capable of replicating observed results. Finally, an example is included to demonstrate how the developed model can be used in campus transportation planning. Besides serving as a first case study for using TRANSIMS to model a university campus, the study's contributions include the development of a procedure for parking lot desirability ranking and a practical procedure for estimating dynamic demand on university campuses.     

俄罗斯船用及工业燃气轮机的发展和应用现状

综述并分析俄罗斯船用及工业燃气轮机设计、研制、生产和应用的现状及发展状况。指出,俄罗斯小功率发电用燃气轮机的发展现状良好,拥有一些性能优良的机组,但是中等功率和大功率发电用机组却是弱项,距离世界先进水平还有很大差距。机械驱动用燃气轮机始终是俄罗斯工业燃气轮机中的强项,设计、研制和应用均处于世界领先水平。曾经是其强项的船用燃气轮机,由于苏联的解体,却成了俄罗斯燃气轮机工业中的缺项。     

Flexible feeder transit route design to enhance service accessibility in urban area

To improve the accessibility of transit system in urban areas, this paper presents a flexible feeder transit routing model that can serve irregular‐shaped networks. By integrating the cost efficiency of fixed‐route transit system and the flexibility of demand responsive transit system, the proposed model is capable of letting operating feeder busses temporarily deviate from their current route so as to serve the reported demand locations. With an objective of minimizing total bus travel time, a new operational mode is then proposed to allow busses to serve passengers on both street sides. In addition, when multiple feeder busses are operating in the target service area, the proposed model can provide an optimal plan to locate the nearest one to response to the demands. A three‐stage solution algorithm is also developed to yield meta‐optimal solutions to the problem in a reasonable amount of time by transforming the problem into a traveling salesman problem. Numerical studies have demonstrated the effectiveness of the proposed model as well as the heuristic solution approach. Copyright © 2015 John Wiley & Sons, Ltd.     

澜沧江特大桥钢管拱二次竖转的计算与分析

以大瑞线澜沧江特大桥为例,选取梁单元模拟主拱,对拱肋二次竖转施工过程进行模拟,对结构进行计算及分析,给出了计算结果及总体评价意见。     

绿色船舶固定式灭火系统的分析及选用研究

通过对目前船舶几种灭火系统的原理比较,分析绿色船舶上消防系统的选用,主要对高倍泡沫灭火系统及压力水雾灭火系统的设计进行阐述。提供设计人员在新型绿色船舶设计中选用更安全、更环保、更高效、更经济的灭火系统。     

危险品装载符合证明的有效期问题

危险品装载符合证明(Form CFD)是一份证明文件,它是设备安全证书的一个附件,并非像有的人认为的那样是一份证书. 有些同志在FC中建议将CFD的有效期给到5年.原因一是认为CFD是一份证书,应按证书的要求执行,与船级的检验协调起来;二是知道它是设备安全证书的附件,认为应与SE证书的有效期一致.本人认为后一种想法在一定程度上是合理的,但在具体的操作上并不完善,存在管理上的漏洞.     

SBR法在天津港污水处理中心化学污水处理工程中的应用

介绍天津港化学污水处理工程的污水水源、水质及为实现处理方案而作的试验室试验情况，最后采用SBR法处理化学污水，主要指标达到国家三废排放标准。     

一种平行相交深孔加工新工艺的研究

针对平行相交孔难加工的工艺特点,提出一种径向力分段平衡的钻尖轮廓形式,并用于扳体零件的加工,取得了良好效果.此方法对该类工艺问题具有普遍意义.     

步履式顶推跨铁路钢箱梁施工技术

结合沈阳绕城高速公路后丁香大桥钢箱梁的施工,对步履式顶推法施工中的钢箱梁拼装平台的搭设、钢箱梁的拼装、临时墩设置、导梁拼装、顶推设备布设、顶推步骤及落梁作了简单叙述,并对顶推施工中的注意事项、控制措施、控制的重难点等进行了详细介绍,可为今后同类型桥梁的施工提供参考。     

浅谈地铁车辆段洗车线接口

车辆段洗车线接口适用于计算机联锁车站和洗车线之间的联系。按照洗车线长度是否满足一列列车车长的要求,分别对车辆段洗车线接口进行了分析,从而保证洗车作业的安全和正常运营。