Performance indicators for transit management

Transit performance can be evaluated through quantitative indicators. As the provision of efficient and effective transit service are appropriate goals to be encouraged by federal and state governments, these goals are used to develop performance indicators.Three efficiency and four effectiveness indicators are described, together with two overall indicators. These nine indicators are analyzed for comparability utilizing operating and financial data collected from public transit agencies in California.Performance indicators selected for this study should not be viewed as final. Twenty-one performance indicators proposed by previous studies were reviewed. Theoretical considerations and unavailability or unreliability of data caused omission of several useful measures like passenger-miles. Circumstances such as improved data, emphasis upon goals other than efficiency and effectiveness, and local conditions might warrant the inclusion of indicators deleted from this research.This paper is based on work conducted for the Urban Mass Transportation Administration under University Research and Training Grant CA-11-0014, Development of Performance Indicators for Transit. The views expressed herein are those of the authors and not necessarily those of the University of California or the United States Government. We are indebted to John Feren for assistance with the statistical processing and data gathering.     

CA498柴油机冷却水流LDV测量

为验证柴油机冷却水套CFD计算结果的准确性，利用LDV测速系统测量了CA498柴油机缸盖及缸体内流场12个关键点处的速度，并将试验结果与CFD计算结果进行了比较一结果表明，除了缸体上3个点的实际测量结果与CFD计算结果有较大偏差以外，其他各点试验测得的数据与CFD计算结果有较好的一致性。分析了造成偏差的主要原因。     

高速公路路堤和路面软基病害检测及加固处理

某高速公路 K1 0 4 2 0 0～K1 0 6 5 0 0段穿过鱼塘 ,路堤采用钢渣水中挤淤法施工 ,通车后路面出现了严重的纵向裂缝、车辙、沉陷 ,影响了路面的使用性能 ,同时路堤存在滑动的隐患 ,必须进行加固处理。为此 ,首先通过系统检测 ,分析路面裂缝产生的原因 ,然后提出针对性的加固处理方案 ,最终实施加固处理施工 ,所取得的成果对其它高速公路的维修加固具有参考价值     

Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

Hub location with flow economies of scale

A characteristic feature of hub and spoke networks is the bundling of flows on the interhub links. This agglomeration of flows leads to reduced travel costs across the interhub links. Current models of hub location do not adequately model the scale economies of flow that accrue due to the agglomeration of flows. This paper shows that current hub location models, by assuming flow-independent costs, not only miscalculate total network cost, but may also erroneously select optimal hub locations and allocations. The model presented in this paper more explicitly models the scale economies that are generated on the interhub links and in doing so provides a more reliable model representation of the reality of hub and spoke networks.     

Fuzzy Logic Active and Semi-Active Control of Off-Road Vehicle Suspensions

For off-road vehicles, minimizing the absorbed power is the main objective of suspension control. The primary cause of increase in the absorbed power in off-road vehicles driven at high speeds on harsh courses is the exhaustion of the suspension travel. Fuzzy-logic approach to active and semi-active off-road vehicle suspension control, with the goal of improving the speed of the vehicle over rough terrains are developed. The ride metric used for quantifying improvements is the absorbed power of the sprung mass. Particular attention is paid to the proper modeling of the suspension using both the full kinematic constraints and the more convenient two degree of freedom linear model of the quarter vehicle suspension. The nonlinearities due to the kinematic constraints on motion are accounted for by modifying the stiffness and damping coefficients of the suspension spring and dashpot in the linear model. The control laws are developed using the less complex model and demonstrated in the fully constrained environment. Nonlinearities of the suspension, including tire stiffness/damping and bumpstops are included at all stages of controller development.     

回收粉在环氧沥青混凝土中的应用研究

大跨径钢桥面铺装用环氧沥青混凝土对集料有很高的要求。通过室内试验和实际生产验证。分析环氧沥青混凝土生产中使用回收粉的可行性，并结合具体工程给出使用量。     

基于合作教学法的过程性评价实践与反思

基于合作教学法在课堂教学改革中取得实效的背景下,结合教学实践,以"英语精读"课程为例,探讨过程性评价的实践做法,即明确过程性评价标准并尝试提供一套切实可行的过程性评价考核方式,最终实现课程考核对教学的正反拨作用,并对过程性评价在实践中的局限进行反思。     

铁路路基动态变形模量的数值模拟分析

介绍铁路路基动态变形模量理论计算公式的推导及动态变形模量的测试原理,采用有限元软件模拟动态变形模量的测试过程,分析承载板与土体接触压力、路基动态变形模量的影响因素,并计算动态变形模量的有效测试深度.结果表明:在承载板中心一定范围内,接触压力模拟结果较理论计算值大;土体的动弹性模量对接触压力影响很小,可以忽略;路基动态变形模量测试冲击荷载作用下,土体只发生弹性变形;动态变形模量与土体动弹性模量呈线性关系,路基动态变形模量的模拟结果大于理论计算值;土体的泊松比对动态变形模量影响较小;动态变形模量有效测试深度建议取0.5~0.6 m.     

A hedonic test of the effects of the Alternative Motor Fuels Act

Under the Alternative Motor Fuels Act (AMFA), vehicles that run on ethanol, methanol, or natural gas get extra credits in the calculation of Corporate Average Fuel Economy (CAFE). This paper uses hedonic techniques to examine the effect of production of alternative-fuel vehicles (AFVs) on the implicit price of fuel economy. This study finds that, after AFVs came to market, the marginal value of fuel economy from companies producing them decreased. This finding suggests that manufacturers who produced AFVs were willing to offer a lower price for fuel economy, because automakers had an additional way to achieve fuel economy standards beyond improving the fuel efficiency of conventional cars. These findings bolster the argument that a major role of the AMFA credit for AFVs is to allow automakers to increase their production of fuel-inefficient vehicles.