汽车用碳纤维复合摩阻材料的摩擦磨损特性研究

在采用正交设计优化碳纤维复合摩阻材料的基础上，针对汽车制动器衬片的实际工况，研究了碳纤维复合摩阻材料的摩擦磨损特性及磨损机制分析了碳纤维含量、强度及表面状态等对磨损机制的影响。研究结果表明，碳纤维复合摩阻材料的磨损性能、工作寿命及抗热衰退性能均明显高于传统的石棉摩阻材料。     

评价重型车用柴油机排放的13工况测试循环和欧洲稳态测试循环的对比

基于同一组增压中冷重型车用柴油机排放试验数据，采用拟合插值的方法得到了13工况循环和欧洲稳态循环两种不同测试循环的比排放数据。利用分担率和加权比排放数据分析了上述两种测试循环的不同点。指出了在实行欧Ⅲ排放法规后对车用柴油机进行排放优化的策略。     

高速公路中央分隔带槽形混凝土护栏的开发研究

简要介绍了高速公路中央分隔带槽形混凝土护栏的开发过程，提出了改进后的中央分隔带混凝土护栏的定型尺寸。研究结果表明，改进后护栏不仅造价降低，同时也改善了车辆碰撞的防护效果。     

风积沙填筑路基施工质量控制

如何利用风积沙填筑路堤(含填高大于10m的路堤)，既达到设计要求．又保证路基稳定，并满足各项技术指标，是工程建设中的一个难题。目前国内尚无成熟的沙漠区路基施工技术规范、施工工艺和方法。文章结合工程实际，阐述了风积沙作为路基填料，其施工质量控制办法。     

汽车正面碰撞法规中乘员保护指标探讨

比较美国、欧洲等国和我国汽车正面碰撞法规中对乘员保护指标的规定,结合人体冲击损伤机理和耐受极限的相关研究,分析我国法规中头部伤害指标HPC的不合理之处。在分析实车碰撞试验数据和模拟计算的基础上,指出我国正面碰撞法规中乘员保护指标的不完备性,并探讨影响伤害指标结果的一些因素。     

高墩大跨径弯连续刚构桥梁空间非线性稳定分析

在高墩大跨弯连续刚构桥梁的设计与施工中,结构稳定性非常重要。本文分别考虑结构的几何非线性和材料非线性力学特征,对高墩大跨弯连续刚构桥梁的结构稳定性进行详细的数值分析,并与线弹性的计算结果进行对比。结果表明:弯连续刚构桥梁的稳定问题已经转化为考虑结构材料屈服强度的极限承载力问题,同时几何非线性对稳定的影响亦不能忽略。     

道路预成形标线带检测技术

对道路预成形标线带检测技术,包括检测标准、产品分类、测试条件和技术要求等,结合国外先进标准进行分析研究。重点介绍在编写其检测标准时,对物理性能、色度性能、逆反射性能、耐水性能、耐碱性能、耐磨性能、粘结性能、抗滑性能等各项技术指标,参考国外先进标准和国内实际情况进行研究确定的过程,指导对国内标线带的产品检测和质量控制。     

鱼雷发动机三组元比例控制器数值模拟

利用计算流体力学软件Pumplinx模拟鱼雷发动机中三组元比例控制器的内部流场,分析计算中不同压差情况下对比例控制器性能的影响,以及叶片与定子间间隙大小对于比例控制器性能的影响,同时对不同叶片数目下性能进行对比。计算结果表明:由于比例控制器为被动旋转马达结构,其转速和流量均随时间呈周期性脉动变化,随着工作压差增大,转速脉动幅度基本保持不变,而流量和扭矩脉动幅值增加;随着间隙增大,泄漏量增大,但流量、扭矩、转速脉动幅值大幅降低,出口流量较为平稳;叶片数目增多后比例控制器转速降低、排量降低。由计算结果推断出目前比例控制器的最优叶片数目为4。本文可为进一步研究比例控制器精度问题提供参考。     

Two degree of freedom flow-induced vibration of cylindrical structures in marine environments: frequency ratio effects

The flow-induced vibration of a cylindrical structure is a very common problem in marine environments such as undersea pipelines, offshore risers, and cables. In this study, the vortex-induced vibration (VIV) of an elastically mounted cylinder at a low Reynolds number is simulated by a transient coupled fluid–structure interaction numerical model. Considering VIV with low damping ratio, the response, hydrodynamic forces, and vortex shedding modes of the cylinder is systematically analyzed and summed up the universal rule under different frequency ratios. On the basis of the analysis, we find that the frequency ratio α is a very important parameter. It decides the locked-in, beat, and phase-switch phenomena of the cylinder, meanwhile, it also influence the vortex mode of the cylinder. The trajectory of the two degrees of freedom (2 DOF) case at different natural frequency ratios is discussed, with most trajectories having a “figure of 8” shape and a few having a “crescent” shape. A fast Fourier transformation technique is used to obtain the frequency characteristics of the vibration of the cylindrical structure. Using the 2 DOF cylinder model in place of the 1 DOF model presents several advantages in simulating the nonlinear characteristics of cylindrical structures, including the capacity to model the crosswise vibration generated by in-line vibration.     

Optimal concession contracts for landlord port authorities with different pursuing goals

This paper investigates how landlord port authorities should offer concession contracts to their terminal operators under two different goals, by building a two-stage game for each goal. If maximizing the weighted sum of fee revenues and throughout benefits is port authorities’ goal, then the optimal concession contract can be any of the two-part tariff, the unit-fee, and the fixed-fee contracts. Accordingly, our special cases include previous works assuming that port authorities maximize either fee revenues or throughput benefits. By contrast, if maximizing the social welfare is the goal, then we find that subsidizing terminal operators, instead of charging them, is port authorities’ best choice. This result is not yet discovered in the literature.