城市轨道交通换乘站布局综合评价方法研究

对城市轨道交通线网交会点是否需要设置为换乘站、换乘站设置对整体线网的优化有何影响、用什么标准衡量和评价换乘站的布局进行深入的研究。根据充分发挥线网整体效率、均衡客流强度、减少乘客无效乘距的指导思想,提出从网络发展水平、居民出行条件改善、运营效果三方面9项指标组成的轨道交通换乘站布局方案综合评价体系,研究指标量化的方法,对城市轨道交通换乘站布局进行多目标模糊综合分析评价。以某市轨道交通线网规划为例,应用评价体系推荐出最优布局方案。     

基于设施属性的城市轨道交通融资模式

以项目区分理论为理论基础,从轨道交通的基本属性入手,按照可经营性和可拆分性对轨道交通基本设施进行分类,对不同属性的设施进行组合.按照所有权和经营权是否转移,将各种适用于轨道交通的融资方式进行分类;并将两者进行匹配,提出了符合轨道交通客观发展规律、可供轨道交通建设发展采用的多元化融资模式及其评价方法.     

杭州湾北岸奉贤段滩涂演变分析

杭州湾北岸奉贤段滩涂资源丰富,解放以来已围垦升发113 km3。但由于水情、工况变化,日前已处于冲刷状态,可围垦利用资源已十分有限。经过详细调查研究,在收集大量数据基础上,该文对近年滩涂演变过程作仔细分析,得出的结论是:由于沿岸泥沙供应量减少、东部深水围垦造成流态变化等原因,奉贤段滩涂的冲刷情况将更趋严重,对海塘防汛能力、沿岸进一步开发利用都构成一定的威胁。必须采取相应的工程、非工程措施,以合理、有序地开发利用奉贤岸段宝贵的滩涂资源。     

如何编写市政工程《施工组织设计》

该文将市政工程《施工组织设计》如何编写的要点,用大纲的形式表现出来,为从事市政工程的同行和项目经理提供参考。同时对《施工组织设计》编写质量与投标活动之间的关系及相互间的影响和重要性也作了简要叙述。     

半柔性路面材料级配设计与性能研究

以体积法设计母体沥青混合料矿料级配,结合马歇尔、谢伦堡析漏和肯塔堡飞散试验确定混合料沥青用量。通过室内试验(车辙试验、浸水马歇尔试验)以及实验段现场性能检测(抗滑性能试验、渗水性能试验)评价其综合路用性能。结果表明,半柔性路面材料具有优良的高温稳定性、水稳定性和抗渗水性,但其抗滑性能稍显不足。     

Virtual prototype simulation on underwater hydraulic impingement shovel

The virtual prototype technology is applied to the design of the hydraulic impingement shovel, which is to increase the reliability of the design. The work principle of hydraulic impingement shovel is expatiated, and its dynamic equations are established. The 3D model of virtual prototype is built by PRO/E. Then the couple between the mechanical body of prototype and the hydraulic system is completed by virtue of ADAMS. Finally, the simulation is made on the virtual prototype. The simulation results show that the design of underwater hydraulic impingement shovel is rational. The virtual prototype technology could lay sound foundation of successful manufacturing of physical prototype for the first time and offer highly effective and feasible means for the design and production of underwater equipments.     

Experimental study on the width of the turbulent area around bridge pier

At present, the method of calculating the turbulent flow width around the bridge pier is not given in the "Standard for Inland River Navigation" (GB50139-2004) in China, and the bridge designer usually increases the bridge span in order to ensure the navigation safety, which increases both of the structural design difficulty and the project investments. Therefore, it is extremely essential to give a research on the turbulent flow width around the bridge pier. Through the experiments of the fixed bed and the mobile bed, the factors influencing the turbulent flow width around the bridge pier have been analyzed, such as the approaching flow speed, the water depth, the angles between the bridge pier and the flow direction, the sizes of bridge pier, the shapes of the bridge pier, and the scouring around the bridge pier, etc. Through applying the dimension analytic method to the measured data, the formula of calculating the turbulent flow width around the bridge pier is then inferred.     

A second order volume of fluid （VOF） scheme for numerical simulation of 2-D breaking waves

Among all environmental forces acting on ocean structures and marine vessels, those resulting from wave impacts are likely to yield the highest loads. Being highly nonlinear, transient and complex, a theoretical analysis of their impact would be impossible without numerical simulations. In this paper, a pressure-split two-stage numerical algorithm is proposed based on Volume Of Fluid (VOF) methodology. The algorithm is characterized by introduction of two pressures at each half and full cycle time step, and thus it is a second-order accurate algorithm in time. A simplified second-order Godunov-type solver is used for the continuity equations. The method is applied to simulation of breaking waves in a 2-D water tank, and a qualitative comparison with experimental photo observations is made. Quite consistent results are observed between simulations and experiments. Commercially available software and Boundary Integral Method (BIM) have also been used to simulate the same problem. The results from present code and BIM are in good agreement with respect to breaking location and timing, while the results obtained from the commercial software which is only first-order accurate in time has clearly showed a temporal and spatial lag, verifying the need to use a higher order numerical scheme.     

Using a SVM to evaluate damage to vibration isolators in an elastic raft system

Predicting damage to vibration isolators in a raft experiencing heavy shock loadings from explosions is an important task when designing a raft system. It is also vital to be able to research the vulnerability of heavily shocked floating rafts unreliable, especially when the allowable values The conventional approach to prediction has been or ultimate values of vibration isolators of supposedly uniform standard in a raft actually have differing and uncertain values due to defective workmanship. A new model for predicting damage to vibration isolators in a shocked floating raft system is presented in this paper. It is based on a support vector machine（SVM）, which uses Artificial Intelligence to characterize complicated nonlinear mapping between the impacting environment and damage to the vibration isolators. The effectiveness of the new method for predicting damage was illustrated by numerical simulations, and shown to be effective when relevant parameters of the model were chosen reasonably. The effect determining parameters, including kernel function and penalty factors, has on prediction results is also discussed. It can be concluded that the SVM will probably become a valid tool to study damage or vulnerability in a shocked raft system.     

动力电池热特性参数研究综述

动力电池的电性能、安全性和循环性能都与电池的工作温度密切相关.在一定的散热条件下,动力电池的温度主要取决于其本征产热和比热容热物性参数特性.上述热物性参数可通过等温量热法(IBC)和绝热量热法(ARC)进行精确的量化测试.主要从测试原理、模拟场景、测试样品尺寸、数据分析过程和测试结果5方面,针对上述2种测试方法的异同进...