Trapped Modes in a Three-Layer Fluid

In this work, trapped mode frequencies are computed for a submerged horizontal circular cylinder with the hydrodynamic set-up involving an infinite depth three-layer incompressible fluid with layer-wise different densities. The impermeable cylinder is fully immersed in either the bottom layer or the upper layer. The effect of surface tension at the surface of separation is neglected. In this set-up, there exist three wave numbers: the lowest one on the free surface and the other two on the internal interfaces. For each wave number, there exist two modes for which trapped waves exist. The existence of these trapped modes is shown by numerical evidence. We investigate the variation of these trapped modes subject to change in the depth of the middle layer as well as the submergence depth. We show numerically that two-layer and single-layer results cannot be recovered in the double and single limiting cases of the density ratios tending to unity. The existence of trapped modes shows that in general, a radiation condition for the waves at infinity is insufficient for the uniqueness of the solution of the scattering problem.     

Numerical Simulation of Float-Over Installation for Offshore Platform

In this paper, a numerical investigation of a float-over installation for an offshore platform is presented to verify the feasibility of the actual installation. The hydrodynamic performance of a T-barge is investigated in the frequency domain, and the coupled motions are analyzed in the time domain. We then compare with those of the model test and determine that the response amplitude operator and the time series agree quite well. The barge exhibits favorable hydrodynamic behavior in the considered sea state, and the equipment loads are allowable. The mooring system and sway fender forces are within the permissible range. Based on these results, we can verify that the actual installation of the offshore platform is feasible. We accurately simulated many important factors and effectively reduced the risk associated with the offshore installation, which is of great importance. As such, we demonstrate that the numerical simulation of the float-over installation for offshore platforms has practical engineering significance.     

Estimating the value of risk reductions for car drivers when pedestrians are involved: a case study in Spain

We estimated the benefits associated with reducing fatal and severe injuries from traffic accidents using a stated choice experiment where choice situations were generated through a statistically efficient design. Specifically, the risk variables were defined as the expected annual number of vehicle car-users that suffered their death or were severely injured in a traffic accident. In addition, and differing from previous research, the number of pedestrians that died or were severely injured in traffic accidents per year was also included as a risk attribute in the choice experiment, to attempt at measuring drivers’ willingness to pay to reduce the risk of hitting pedestrians in a crash. The empirical setting was a choice of route for a particular trip that a sample of car drivers periodically undertakes in Tenerife, Spain. Models were estimated accounting for random taste heterogeneity and pseudo-panel data correlation. The median of the distribution of simulated parameters was used to obtain a representative measure for the monetary valuation of risk reductions. We found that the ratio between the values of reducing the risk of suffering a serious injury and that of reducing a fatality was approximately 18 %. Further, and quite novel, we also found that the value of reducing a pedestrian fatality was 39 % of the value of reducing a car occupant fatality.     

Are we ready to embrace connected and self-driving vehicles? A case study of Texans

While connected, highly automated, and autonomous vehicles (CAVs) will eventually hit the roads, their success and market penetration rates depend largely on public opinions regarding benefits, concerns, and adoption of these technologies. Additionally, the introduction of these technologies is accompanied by uncertainties in their effects on the carsharing market and land use patterns, and raises the need for tolling policies to appease the travel demand induced due to the increased convenience. To these ends, this study surveyed 1088 respondents across Texas to understand their opinions about smart vehicle technologies and related decisions. The key summary statistics indicate that Texans are willing to pay (WTP) $2910, $4607, $7589, and $127 for Level 2, Level 3, and Level 4 automation and connectivity, respectively, on average. Moreover, affordability and equipment failure are Texans’ top two concerns regarding AVs. This study also estimates interval regression and ordered probit models to understand the multivariate correlation between explanatory variables, such as demographics, built-environment attributes, travel patterns, and crash histories, and response variables, including willingness to pay for CAV technologies, adoption rates of shared AVs at different pricing points, home location shift decisions, adoption timing of automation technologies, and opinions about various tolling policies. The practically significant relationships indicate that more experienced licensed drivers and older people associate lower WTP values with all new vehicle technologies. Such parameter estimates help not only in forecasting long-term adoption of CAV technologies, but also help transportation planners in understanding the characteristics of regions with high or low future-year CAV adoption levels, and subsequently, develop smart strategies in respective regions.     

How household transportation expenditures have evolved in Canada: a long term perspective

In recent years, increasing recognition of the challenges associated with global climate change and inequity in developed countries have revived researcher’s interest towards analyzing transportation related expenditure of households. The current research contributes to travel behaviour literature by developing an econometric model of household budgetary allocations with a particular focus on transportation expenditure. Towards this end, we employ the public-use micro-data extracted from the Survey of Household Spending (SHS) for the years 1997–2009. The proposed econometric modeling approach is built on the multiple discrete continuous extreme value model (MDCEV) framework. Specifically, in our analysis, the scaled version of the MDCEV model outperformed its other counterparts. Broadly, the model results indicated that a host of household socio-economic and demographic attributes along with the residential location characteristics affect the apportioning of income to various expenditure categories and savings. We also observed a relatively stable transportation spending behaviour over time. Additionally, a policy analysis exercise is conducted where we observed that with increase in health expenses and reduction in savings results in adjustments in all expenditure categories.     

Robust network pricing and system optimization under combined long-term stochasticity and elasticity of travel demand

Network pricing serves as an instrument for congestion management, however, agencies and planners often encounter problems of estimating appropriate toll prices. Tolls are commonly estimated for a single-point deterministic travel demand, which may lead to imperfect policy decisions due to inherent uncertainties in future travel demand. Previous research has addressed the issue of demand uncertainty in the pricing context, but the elastic nature of demand along with its uncertainty has not been explicitly considered. Similarly, interactions between elasticity and uncertainty of demand have not been characterized. This study addresses these gaps and proposes a framework to estimate nearest optimal first-best tolls under long-term stochasticity in elastic demand. We show first that the optimal tolls under the deterministic-elastic and stochastic-elastic demand cases coincide when cost and demand functions are linear, and the set of equilibrium paths is constant. These assumptions are restrictive, so three larger networks are considered numerically, and the subsequent pricing decisions are assessed. The results of the numerical experiments suggest that in many cases, optimal pricing decisions under the combined stochastic-elastic demand scenario resemble those when demand is known exactly. The applications in this study thus suggest that inclusion of demand elasticity offsets the need of considering future demand uncertainties for first-best congestion pricing frameworks.     

A mixed Bayesian network for two-dimensional decision modeling of departure time and mode choice

The modeling of travel decision making has been a popular topic in transportation planning. Previous studies focused on random-utility discrete choice models and machine learning methods. This paper proposes a new modeling approach that utilizes a mixed Bayesian network (BN) for travel decision inference. The authors use a predetermined BN structure and calculate priori and posterior probability distributions of the decision alternatives based on the observed explanatory variables. As a “utility-free” decision inference method, the BN model releases the linear structure in the utility function but assumes the traffic level of service variables follow multivariate Gaussian distribution conditional on the choice variable. A real-world case study is conducted by using the regional travel survey data for a two-dimensional decision modeling of both departure time choice and travel mode choice. The results indicate that a two-dimensional mixed BN provides better accuracy than decision tree models and nested logit models. In addition, one can derive continuous elasticity with respect to each continuous explanatory variable for sensitivity analysis. This new approach addresses a research gap in probabilistic travel decision making modeling as well as two-dimensional travel decision modeling.     

Simultaneous internalization of traffic congestion and noise exposure costs

This study elaborates on the interrelation of external effects, in particular road traffic congestion and noise. An agent-based simulation framework is used to compute and internalize user-specific external congestion effects and noise exposures. The resulting user equilibrium corresponds to an approximation of the system optimum. For traffic congestion and noise, single objective optimization is compared with multiple objective optimization. The simulation-based optimization approach is applied to the real-world case study of the Greater Berlin area. The results reveal a negative correlation between congestion and noise. Nevertheless, the multiple objective optimization yields a simultaneous reduction in congestion and noise. During peak times, congestion is the more relevant external effect, whereas, during the evening, night and morning, noise is the more relevant externality. Thus, a key element for policy making is to follow a dynamic approach, i.e. to temporally change the incentives. During off-peak times, noise should be reduced by concentrating traffic flows along main roads, i.e. inner-city motorways. In contrast, during peak times, congestion is reduced by shifting transport users from the inner-city motorway to smaller roads which, however, may have an effect on other externalities.     

Activity involvement and time spent on computers for leisure: an econometric analysis on the American Time Use Survey dataset

Internet is capturing more and more of our time each day, and the increasing levels of engagement are mainly due to the use of social media. Time spent on social media is observed in the American Time Use Survey and recorded as leisure time on Personal Computer (PC). In this paper, we extend the traditional analysis of leisure activity participation by including leisure activities that require the use of a PC. We study the substitution effects with both in-home and out-of-home leisure activities and the time budget allocated to each of them. The modeling framework that includes both discrete alternatives and continuous decision variables allow for full correlation across the utility of the alternatives that are all of leisure type and the regressions that model the time allocated to each activity. Results show that there is little substitution effect between leisure with PC and the relative time spent on it, with in-home and out-of-home leisure episodes. Households with more children and full-time workers are more likely to engage in in-home and PC related leisure activities (especially during weekends). Increments in the travel time of social trips result in significant reductions in leisure time during weekdays.     

Factors associated with home-based e-working and e-shopping in Nanjing,China

The widespread adoption of information and communication technology has facilitated frequent e-activities in people’s daily life. From the perspective of individual’s time use on e-working and e-shopping at home, this paper aims to enhance our understanding of the function of home beyond a living space for family life. Using a household survey of 608 full-time paid employees who conducted e-activities at home in Nanjing, China, we investigated the characteristics and patterns of home-based e-working and e-shopping. Only 7.9% of the respondents neither e-shopped nor e-worked at home. We find that the socio-demographic context, Internet use habits, attitudes towards e-working/e-shopping, and geographical accessibility have influenced the patterns of home-based e-working and e-shopping. The results indicate that the rich e-activities taking place at home have changed the time use at home and reinforced the function of home as a multifunctional hub.