Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

Spatial Dynamics of Multibody Tracked Vehicles Part II: Contact Forces and Simulation Results

In this part of the paper, three dimensional computational capabilities, that includes significant details, are developed for the nonlinear dynamic analysis of large scale spatial tracked vehicles. Three dimensional nonlinear contact force models that describe the interaction between the track links and the vehicle components such as the rollers, sprockets, and idlers as well as the interaction between the track links and the ground are developed and used to define the generalized contact forces associated with the vehicle generalized coordinates. Tangential friction and contact forces are developed in order to maintain the stability of the track motion and avoid the slippage of the track or its rotation as a rigid body. Body and surface coordinate systems are introduced in order to define the spatial contact conditions. The nonlinear equations of motion of the tracked vehicle are solved using the velocity transformation procedure developed in the first part of this paper. This procedure is used in order to obtain a minimum set of differential equations, and avoid the use of the iterative Newton-Raphson algorithm. A computer simulation of a tracked vehicle that consists of one hundred and six bodies and has one hundred and sixteen degrees of freedom is presented in order to demonstrate the use of the formulations presented in this study.     

Spatial Dynamics of Multibody Tracked Vehicles Part I: Spatial Equations of Motion

In this paper, the nonlinear dynamic equations of motion of the three dimensional multibody tracked vehicle systems are developed, taking into consideration the degrees of freedom of the track chains. To avoid the solution of a system of differential and algebraic equations, the recursive kinematic equations of the vehicle are expressed in terms of the independent joint coordinates. In order to take advantage of sparse matrix algorithms, the independent differential equations of the three dimensional tracked vehicles are obtained using the velocity transformation method. The Newton-Euler equations of the vehicle components are defined and used to obtain a sparse matrix structure for the system dynamic equations which are represented in terms of a set of redundant coordinates and the joint forces. The acceleration solution obtained by solving this system of equations is used to define the independent joint accelerations. The use of the recursive equations eliminates the need of using the iterative Newton-Raphson algorithm currently used in the augmented multibody formulations. The numerical difficulties that result from the use of such augmented formulations in the dynamic simulations of complex tracked vehicles are demonstrated. In this investigation, the tracked vehicle system is assumed to consist of three kinematically decoupled subsystems. The first subsystem consists of the chassis, the rollers, the sprockets, and the idlers, while the second and third subsystems consist of the tracks which are modeled as closed kinematic chains that consist of rigid links connected by revolute joints. The singular configurations of the closed kinematic chains of the tracks are also avoided by using a penalty function approach that defines the constraint forces at selected secondary joints of the tracks. The kinematic relationships of the rollers, idlers, and sprockets are expressed in terms of the coordinates of the chassis and the independent joint degrees of freedom, while the kinematic equations of the track links of a track chain are expressed in terms of the coordinates of a selected base link on the chain as well as the independent joint degrees of freedom. Singularities of the transformations of the base bodies are avoided by using Euler parameters. The nonlinear three dimensional contact forces that describe the interaction between the vehicle components as well as the results of the numerical simulations are presented in the second part of this paper.     

大跨径连续刚构桥的温度效应分析

以魏家洲特大桥为例,按照我国公路桥涵设计规范、英国BS5400规范、新西兰规范确定不同的计算模式,对大跨径连续刚构桥进行温度效应分析,得出：温度应力在大跨径连续刚构桥整个桥梁设计中占有很大的比重,且采用不同的温度梯度计算模式,所得到的梁内温度应力值相差较大,甚至出现异号的温度应力.     

Dynamics of inorganic nutrient species in the Bohai seawaters

Within the frame of a Sino-German Joint Research Program, two cruises of “R/V Dong Fang Hong 2” were carried out in September–October 1998 and April–May 1999, respectively, to understand the dynamics of nutrients in the Bohai. Nutrient species (NO₃⁻, NO₂⁻, NH₄⁺, PO₄³⁻ and SiO₃²⁻) are determined colorimetrically on board for five anchor and 30 grid stations. In situ incubation experiments are performed to determine planktonic nutrient uptake and benthic exchange flux. Nutrient concentrations display short-term variability and seasonal change in the Bohai, with higher levels in shallow coastal waters than in the Central Bohai. The influence of riverine discharge on nutrient levels can be seen from salinity isopleths, nutrient distribution and species ratios. Near-bottom (nb) waters have similar nutrient concentrations as to the surface waters in the Central Bohai, whereas stratification takes place in the Bohai Strait and North Yellow Sea. In situ incubation experiments provide evidence that the uptake ratio (i.e. N, P) by phytoplankton is proportional to the ratios among nutrient species in ambient waters. Based on the data of this study and previously publications, a preliminary estimate of nutrient budgets via riverine input and atmospheric deposition is established. The results indicate that atmospheric deposition gains importance over rivers in delivering nutrients into the Bohai and sustain the new production, following recent decrease in riverine inflow caused by drought periods in North China and damming practices. A historical review of nutrient data indicates that concentrations of nitrogen increase and phosphorus and silica decrease in the Central Bohai over last 40 years. This potentially has an important influence on the health of ecosystem in Bohai (e.g. food web and community structure), though further study is needed to examine the scenario in more detail.     

T��l��phoner au volant : impact sur la conduite et risque d��accident, une revue de la litt��rature

This paper gives a literature review from experimental, epidemiological and naturalistic studies, having tried to measure on the one hand, the impact of mobile phone use on driving and, on the other hand, the risk of accident associated with this practice. The overview of these studies allowed first of all to show that the driving task is altered during the period of mobile phone use, and to quantify the disturbance (experimental studies), then to verify that this disturbance can be at the origin of accidents and quantify this risk (epidemiological studies). The naturalistic studies, consisting in following-up fleet vehicles, give some more explanations and tend to confirm the results. Advantages and limits of each approach are also discussed.     

A Practice-Based Coupling of the Precautionary Principle to the Large Marine Ecosystem Fisheries Management Concept with a Policy Orientation: The Northeast United States Continental Shelf as a Case Example

This article addresses interdisciplinary sustainable aspects of fisheries as part of ocean management. Human-caused impacts and their role as modifiers of living marine resources is discussed. The research note also theorizes about contemporary global change and its prospective biological consequences, especially when coupled with human-induced factors in coastal marine waters. Also addressed is the management and ecological aspects of fish stock populations as part of a large marine ecosystem (LME) in the Northeast United States continental shelf of the Atlantic Ocean with suggestions for an interdisciplinary policy orientation paradigm to foster the sustainability of marine life in the sea.     

A Training Framework for Understanding Conflict in the Coastal Zone

The coastal zone is attractive for human settlement because it tends to be resource rich, providing a good location to generate incomes and livelihoods. Equally, however, it is a complex and powerful natural environment, which means that the coastal zone often becomes a focus of conflict with multiple users competing for limited space and resources. Understanding the causes of, and determining solutions to, the ensuing problems requires inputs from a range of analyses across sectors and disciplines. However, different disciplinary and sectoral approaches frequently use different investigative methods, language, and means of presenting results. This article presents a framework that has been developed in collaboration with Indian institutions over the past three years in an effort to address some of these fundamental problems of analysis and translation into policy action. Key components addressed by the framework are strengthening the capacity to practice, knowing how to proceed and how to find out what needs to be known using experience-based problem solving.     

Coastal Management and Economic Development in Developed Nations: The Forth Estuary Forum

This article considers the issue of economic development as a component of coastal management initiatives in developed countries, focusing on the Forth Estuary Forum as a case study. The evolution of coastal management into integrated coastal management is briefly considered, as is the context of the Scottish coastal management system and a brief discussion of the variations between the different legal systems within the UK. The current hurdles to economic development and the views of developers and economic agencies being considered in the coastal management process itself are highlighted, illustrating the process of integration and the current voluntary regime in the UK, particularly in the Forth Estuary Forum. The article concludes that economic development issues must be taken seriously if coastal management is to be integrated and inclusive.