烟台某工程循环水取、排水工程压水试验

为确定烟台某工程地基基岩的渗透特性,阐述水上岩体压水试验的主要操作过程、试验数据处理和试验结果分析评价方法．测定区域内的各岩层的透水率和渗透系数,给出不同风化程度岩层的渗透性评价,为设计提供防渗设计所需参数。     

气体灭火系统受干扰的原因及防范措施

介绍气体灭火系统受外界干扰导致误喷放的情况,从探测器、控制器和线路方面,探讨形成干扰的主要类型和原因,结合实际工程中的应用情况,有针对性地提出防范措施.     

摆式列车受电弓垂向振动主动控制

建立了摆式列车机电耦合动力学模型、受电弓线性和非线性动力学模型及接触网有限元模型和静态接触刚度模型,组成摆式列车-受电弓-接触网耦合动力学模型,分别设计了P和H∞鲁棒控制器,应用数值仿真方法,研究了摆式列车直线和曲线通过时两种控制器对摆式列车受电弓垂向主动控制的效果。结果表明受电弓若无垂向控制,其弓网接触压力波动较大;P和H∞鲁棒控制均能减小弓网接触压力的波动;控制延时对P控制比对H∞鲁棒控制的影响大;是否考虑接触网的振动对接触压力影响较大,对控制效果影响不大。这说明摆式列车受电弓垂向主动控制能明显改善弓网接触压力波动;H∞鲁棒控制比P控制效果更好;接触网的静态接触刚度模型可用于受电弓主动控制的定性分析。     

Structural Optimization and Strength Analysis of the Lifting Arm of a Wet Shotcrete Spraying Unit北大核心CSCD

Wet shotcrete spraying units are widely used in underground engineering, for railways, highways, water conservancy and hydropower stations, municipal works, mining and military and other industries. Structural analysis and mechanical behavior optimization are conducted regarding the lifting arm of a TKJ series shotcrete spraying unit, and optimization of the hinge point position and working scope of the lifting arm is realized. The optimal layout scheme for the hinge force is given based on the Monte Carlo method, the hinge force of the lifting arm is improved for the mean and maximum values, and the maximum and average hinge force of the lifting cylinder decrease by 23.14% and 7.70%, respectively, compared with that of the original scheme. The static strength is checked using Ansys-Workbench for the optimized scheme, and the results show that the optimized scheme has a larger safety re-serve and that the structural design is more reasonable than the original scheme. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

A Study of Prevention Techniques for Tunnel Lining Defects北大核心CSCD

Defects of tunnel lining, such as inadequate thickness, voids, cracks, rock falling and water leakage etc., endanger the safety of railway tunnel operation. Based on the site construction, an analysis of the reasons for lining defects was conducted; technical measures against lining defects were proposed and tests were carried out at site. The results show that these measures are reliable and effective, and the purposes of prevention and treatment are re⁃ alized. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

舰船中压直流综合电力推进系统稳态分析研究

本文对舰船中压直流综合电力推进系统进行稳态分析。首先,根据舰船中压直流综合电力系统基本特点,选定直流分层前推回代法作为基本方法加以改进;同时,提出了适用于该方法的支路计算等效模型,并将上述思想进行程序实现。通过算例分析结果可知,论文所提出的基于直流分层前推回代法的潮流计算方法,能够适用于舰船中压直流综合电力推进系统。     

Modeling the interactions between car and bicycle in heterogeneous traffic

In this paper, a new cellular automata model is proposed to simulate the car and bicycle heterogeneous traffic on urban road. To capture the complex interactions between these two types of vehicles, a novel occupancy rule is adopted in the proposed model to consider the variable lateral distances of mixed vehicular traffic. Based on massive simulations, microscopic fundamental diagrams under different bicycle densities are devised. With these, the bicycle's spilling behavior is then investigated and discussed. In order to reflect the interference of a bicycle on a car, the interference transformation from friction state to block state is modeled explicitly. Finally, different simulation results under different occupancy rules indicate that the constant and fixed occupancy rule adopted in the previous studies might lead to overestimation of car flux in the heterogeneous traffic flows with different bicycle densities. Copyright © 2013 John Wiley & Sons, Ltd.     

“工厂法”沉管隧道早期性能的足尺试验研究

由于沉管隧道管段体积大、结构形式复杂、施工工艺复杂,容易因温度、收缩以及约束等原因,造成管段结构在预制阶段出现危害性裂缝,进而影响结构的服役性能和耐久性能。文章依托在建港珠澳大桥沉管隧道工程实例,开展了足尺试验,对"工厂法"沉管管节关键部位的温度和应变发展实施了监测,分析对比了温度发展规律和应变发展规律。分析结果表明:在早期因混凝土水化热引起温度上升,整个管段结构膨胀受拉,温度到达峰值后逐渐下降,结构也收缩恢复;但由于混凝土自收缩等因素的存在,结构最终收缩受压。研究所提供的试验结果可作为深入进行数值分析的一个基础。     

富水砂层中暗挖隧道施工沉降控制技术

富水砂层中暗挖隧道施工是地铁施工中的一大难点,常常因沉降过大而引发安全事故。在深圳地铁安-侨区间隧道工程中,通过洞内帷幕注浆、水平旋喷桩、地表井点降水等辅助措施做到了超前控制,在解决隧道开挖安全问题的同时有效地减少了沉降量;施工过程中严格执行了"管超前、短进尺、强支护、早封闭、勤量测"的方针,控制了时空效应,解决了富水砂层中暗挖隧道沉降过大的问题。文章重点分析了沉降原因及控制沉降的关键技术和有效措施。     

齐岳山隧道施工中物探与钻探的应用比较研究

在岩溶山区隧道工程的施工过程中,地质超前预报是重要的施工工序,以宜万铁路齐岳山隧道为例,研究了基于地震波理论的TSP203探测设备的应用方法和目前在国内外水平钻探领域功能最完善的RPD-150多功能地质钻机的应用方法;分析比较了地球物理探测和地质钻探方法在隧道地质超前预报中的特点,提出了岩溶山区隧道地质超前预报技术方法的应用原则.研究结果表明:TSP203地质预报系统探测、解译距离远,分辨率高,系统智能化程度高,数据记录基本采用自动记录系统,试验过程简单,对施工影响较小,但是整个系统数据记录与分析比较单一、公式化;RPD-150C多功能钻机系统具有探测准确、探测结果受外界影响小等优点,但是数据分析往往不能对有些数据和图形进行量化,只能作出定性的分析.从而得出结论,RPD-150C多功能钻机系统与TSP203地质预报系统有很大的互补性,综合两种手段,可以及时预测预报到大部分地质不良地段,为隧道工程的施工奠定基础.