Design and evaluation of sideslip angle observer for vehicle stability control

This paper presents a method for estimating the vehicle side slip angle, which is considered as a significant signal in determining the vehicle stability region in vehicle stability control systems. The proposed method combines the model-based method and kinematics-based method. Side forces of the front and rear axles are provided as a weighted sum of directly calculated values from a lateral acceleration sensor and a yaw rate sensor and from a tire model according to the nonlinear factor, which is defined to identify the degree of nonlinearity of the vehicle state. Then, the side forces are fed to the extended Kalman filter, which is designed based on the single-track vehicle model associated with a tire model. The cornering stiffness identifier is introduced to compensate for tire force nonlinearities. A fuzzy-logic procedure is implemented to determine the nonlinear factor from the input variables: yaw rate deviation from the reference value and lateral acceleration. The proposed observer is compared with a model-based method and kinematics-based method. An 8 DOF vehicle model and Dugoff tire model are employed to simulate the vehicle state in MATLAB/SIMULINK. The simulation results shows that the proposed method is more accurate than the model-based method and kinematics-based method when the vehicle is subjected to severe maneuvers under different road conditions.     

Application study on a control strategy for a hybrid electric public bus

This paper first describes the control strategy used in a hybrid electric public bus and then proposes a torque-balancing control strategy. Simulations were performed using the designed control strategies, and the results were analyzed under different conditions. The torque-balancing control strategy was improved on the basis of the efficiency-first ideas of the hybrid system. Finally, experiments were performed to verify that the efficiency-first and torque-balancing control strategy (EFCS) is both feasible and reliable. The simulation results showed that, compared with a conventional public bus, the hybrid electric bus could save approximately 27.3 percent on fuel consumption using the EFCS control strategy in a public bus in China, while under the Wuhan urban driving cycle.     

European advanced driver training programs: Reasons for optimism

Post license advanced driver training programs in the US and early programs in Europe have often failed to accomplish their stated objectives because, it is suspected, that drivers gain self perceived driving skills that exceed their true skills—leading to increased post training crashes. The consensus from the evaluation of countless advanced driver training programs is that these programs are a detriment to safety, especially for novice, young, male drivers.Some European countries including Sweden, Finland, Austria, Luxembourg, and Norway, have continued to refine these programs, with an entirely new training philosophy emerging around 1990. These ‘post-renewal’ programs have shown considerable promise, despite various data quality and availability concerns. These programs share in common a focus on teaching drivers about self assessment and anticipation of risk, as opposed to teaching drivers how to master driving at the limits of tire adhesion. The programs focus on factors such as self actualization and driving discipline, rather than low level mastery of skills. Drivers are meant to depart these renewed programs with a more realistic assessment of their driving abilities. These renewed programs require considerable specialized and costly infrastructure including dedicated driver training facilities with driving modules engineered specifically for advanced driver training and highly structured curriculums. They are conspicuously missing from both the US road safety toolbox and academic literature. Given the considerable road safety concerns associated with US novice male drivers in particular, these programs warrant further attention.This paper reviews the predominant features and empirical evidence surrounding post licensing advanced driver training programs focused on novice drivers. A clear articulation of differences between the renewed and current US advanced driver training programs is provided. While the individual quantitative evaluations range from marginally to significantly effective in reducing novice driver crash risk, they have been criticized for evaluation deficiencies ranging from small sample sizes to confounding variables to lack of exposure metrics. Collectively, however, the programs sited in the paper suggest at least a marginally positive effect that needs to be validated with further studies. If additional well controlled studies can validate these programs, a pilot program in the US should be considered.     

On the capacity of isolated, curbside bus stops

The maximal rates that buses can discharge from bus stops are examined. Models were developed to estimate these capacities for curbside stops that are isolated from the effects of traffic signals. The models account for key features of the stops, including their target service levels assigned to them by a transit agency. Among other things, the models predict that adding bus berths to a stop can sometimes return disproportionally high gains in capacity. This and other of our findings are at odds with information furnished in professional handbooks.     

Cooling effect of methanol on an n-heptane HCCI engine using a dual fuel system

Homogeneous charge compression ignition (HCCI) engines have the potential to raise the efficiency of reciprocating engines during partial load operation. However, the performance of the HCCI engine at high loads is restricted by severe knocking, which can be observed by the excessive pressure rise rate. This is due to the rapid combustion process occurring inside the cylinder, which does not follow the flame propagation that is seen in conventional engines. In this study, a low compression ratio of 9.5:1 for a gasoline engine was converted to operate in HCCI mode with the goal being to expand the stable operating region at high loads. Initially, pure n-heptane was used as the fuel at equivalence ratios of 0.30 to 0.58 with elevated intake charge temperatures of 180 and 90 °C, respectively. The n-heptane HCCI engine could reach a maximum performance at an indicated mean effective pressure (IMEP) of 0.38 MPa, which was larger than the performance found in the literature. To reach an even higher performance, a dual-fuel system was exploited. Methanol, as an anti-detonant additive, was introduced into the intake stream with various amounts of n-heptane at fixed equivalence ratios in the range of 0.42 to 0.52. It was found that the methanol addition cooled the mixture down prior to combustion and resulted in an increased coefficient of variation (COV). In order to maintain stable combustion and keep the pressure rise rate below the limit, the intake charge temperature should be increased. Introduction of 90% and 95% (vol/vol) hydrous methanol showed a similar trend but a lower thermal conversion efficiency and IMEP value. Therefore, a dual fuel HCCI engine could maintain a high thermal conversion efficiency across a wide load and enhance a 5% larger load compared to a pure n-heptane-fuelled HCCI engine. The hydrocarbon (HC) and carbon monoxide (CO) emissions were lower than 800 ppm and 0.10%, respectively. They were less at higher loads. The nitrogen oxides (NO _x ) emissions were below 12 ppm and were found to increase sharply at higher loads to a maximum of 23 ppm.     

Development of a fail-safe control strategy based on evaluation scenarios for an FCEV electronic brake system

This study presents a few fail-safe control strategies based on reliability evaluation scenarios for the electronic brake systems of green cars in several critical cases. CarSim and MATLAB Simulink were used to develop the FCEV model with regenerative braking involving EWBs and EMBs. The proposed reliability evaluation scenarios were simulated, and a few fail-safe control algorithms were verified using the proposed reliability evaluation scenarios with the developed FCEV simulation model. The reliability evaluation scenarios were developed using a combination of driving modes and FMEA results for these electronic brake systems.     

Adaptive neural network based fuzzy control for a smart idle stop and go vehicle control system

Idle stop and go (ISG) is a low cost but very effective technology to improve fuel efficiency and reduce engine emissions by preventing unnecessary engine idling. In this study, a new method is developed to improve the performance of conventional ISG by monitoring traffic conditions. To estimate frontal traffic conditions, an ultra-sonic ranging sensor is employed. Several fuzzy logic algorithms are developed to determine whether the engine idling is on or off. The algorithms are evaluated experimentally using various data gathered in real areas with traffic congestion. The evaluation results show that the method developed can reduce the chance of false application of ISG significantly while improving fuel efficiency up to 15%.     

Social and political implications of new transport technologies

The mechanism of change in society is discussed in terms of power and interest groups, and some of the past changes in transport technology are examined in terms of the degree of threat posed to the established order and the interest groups benefiting from change. On the basis of such a power/benefit model, three of the new transport technologies which have been proposed — “guideway”, “dial‐a‐bus” and “network cab”, are discussed as to their likely social and political acceptability.     

The vertical disintegration of ship management: choice criteria for third party selection and evaluation

An assessment of the rationale for the vertical disintegration of ship management suggests that there might be compelling economic benefits for the separation of ownership from management. In this context, as a means for developing effective marketing strategies, it is important for ship managers to know the criteria used by current and prospective clients for ship manager selection and evaluation. The aim of this paper is to empirically identify the dimensions for ship manager selection and performance evaluation and their relative importance and to discuss the implications for marketing emanating from such an assessment. The methodology adopted includes the collection of secondary and primary data, both from ship managers and their clients, using interviews and a mail survey. The results indicate the prevailing importance of certain dimensions in selection (e.g. technical ability, reputation, competency) and evaluation (responsiveness, trustworthiness, technical ability), whereas it also found that price alone is not perceived to be as important in ship manager selection. It is concluded that placing emphasis on such dimensions in the formulation of a marketing strategy will contribute towards the attraction and retention of clients, whereas cost-cutting measures to allow price reduction, as well as advertising, will be ineffective over the long term.     

The Value of a Spillover Fishery for Spiny Lobsters Around a Marine Reserve in Northern New Zealand

The contribution that Leigh Marine Reserve in northern New Zealand makes to the local spiny lobster fishery was examined by comparing the catch characteristics of Jasus edwardsii around the reserve boundary with those from Coastal Leigh, 0.3-2 km from the reserve, and Little Barrier Island, 22-30 km from the reserve. Seasonal trends were apparent in the reserve catch characteristics, consistent with lobster movements into and out of offshore fishing areas adjacent to the boundary. No significant difference was detected in catch per unit effort (kg.trap haul -1 ) among locations. However, the catch around the marine reserve consisted of fewer but larger lobsters than at Little Barrier Island, while the size and number of lobsters caught per trap haul at Coastal Leigh was intermediate between the other two locations. Catch rates around the reserve were more variable than at the other sites, but on average, the amount of money made per trap haul was similar to Little Barrier Island and Coastal Leigh.