全文获取类型
收费全文 | 4300篇 |
免费 | 131篇 |
专业分类
公路运输 | 1183篇 |
综合类 | 1101篇 |
水路运输 | 1058篇 |
铁路运输 | 946篇 |
综合运输 | 143篇 |
出版年
2024年 | 4篇 |
2023年 | 15篇 |
2022年 | 101篇 |
2021年 | 134篇 |
2020年 | 95篇 |
2019年 | 40篇 |
2018年 | 47篇 |
2017年 | 63篇 |
2016年 | 63篇 |
2015年 | 121篇 |
2014年 | 167篇 |
2013年 | 246篇 |
2012年 | 292篇 |
2011年 | 321篇 |
2010年 | 324篇 |
2009年 | 385篇 |
2008年 | 379篇 |
2007年 | 464篇 |
2006年 | 410篇 |
2005年 | 277篇 |
2004年 | 88篇 |
2003年 | 53篇 |
2002年 | 38篇 |
2001年 | 49篇 |
2000年 | 72篇 |
1999年 | 36篇 |
1998年 | 36篇 |
1997年 | 10篇 |
1996年 | 25篇 |
1995年 | 18篇 |
1994年 | 18篇 |
1993年 | 11篇 |
1992年 | 8篇 |
1991年 | 8篇 |
1990年 | 5篇 |
1989年 | 4篇 |
1988年 | 3篇 |
1984年 | 1篇 |
排序方式: 共有4431条查询结果,搜索用时 764 毫秒
91.
92.
93.
With the development of vehicle gearbox to high-power-density and high-speed, how to predict and optimize the dynamic characteristics of vehicle gearbox becomes increasingly prominent. Aiming at the vehicle gearbox, this paper comprehensively and deeply studies the dynamic characteristics under the multi-boundary conditions. The generation mechanism of the multi-source excitations triggering the gearbox vibration is analyzed firstly. The vibration transfer path of the gearbox is explored. Secondly, the engine excitation, the gear meshing excitation and the bearing support load are numerically calculated. According to the finite element method, a fluid-solid coupling finite element model of the gearbox body is established to predict the gearbox dynamic responses based on the Galerkin method and the Hamiltonian variational principle. Finally, the effects of the excitation condition, oil height and reinforcement forms on the vibration responses of the gearbox body are thoroughly studied by simulation. The analysis indicates that it not only helps to modify and improve the method of forecasting the gearbox dynamic response, and also provides the theoretical and technical guidance for the gearbox design and optimization. 相似文献
94.
设备比对作为一种有效的质量监控方法,在汽车检测行业得到了广泛应用.众所周知,影响整车排放检测结果的因素较多,试验结果的偏差较大;但因排放检测设备价值昂贵,具备两套及以上排放检测设备的实验室较少,因此,在进行质量监控时,受检测设备数量的限制,难以选择设备比对的方式.本文以5家实验室比对的数据为例,选择其中的极端数据模拟进行两套设备间的设备比对,得出了假设检验用于设备比对的分析方法,并给出了试验数据的置信区间.与实验室间比对结果相比,使用该方法进行两套设备间的比对,比对结果可信. 相似文献
95.
主要介绍了50 000 DWT散货船轮机设计特点,通过选用大缸径柴油机提升经济性,申请螺旋桨轴状态监控(SCM)和轮机循环检验(CMS)附加符号减少船东使用成本,可供内贸散货船设计借鉴.最后对此船型后续优化提出了建议,从降低上层建筑风阻、采用TIER Ⅱ主机,进一步提升节能环保性. 相似文献
96.
An improved numerical method is used to simulate the dynamic behavior of a two part towing cable systems during turnings. In U turns and full turns, periodical heave motions are found both for the towed vehicle and for the depressor. Periodic motions of the subsea units and of the cable surface tension are closely related to the turning parameters, such as turning velocity and turning radius. System parameters, such as length of the second cable and the vehicle hydrodynamics, also damp turning instability. 相似文献
97.
针对宽幅压变化的直流电机驱动通风机速度性能差的情况,在不需要速度闭环的前提下,为电机所带风阻性负载稳速准确度在10%以内,设计出了一种稳速装置。基本能满足此类电机负载的要求。文章介绍了稳速装置的工作原理和设计方法,通过实验验证可对直流通风电机进行有效控制。 相似文献
98.
压载水管理公约D2对压载水中颗粒物粒径范围及含量做出了明确规定。为满足此规定,水力旋流器逐步开始应用于船舶压载水处理系统中。为了提高水力旋流器的分离效率,通过改变水力旋流器的入口结构对水力旋流器进行优化,即将入口结构设计为阿基米德螺线形入口来增加流体转动速度,降低能量消耗,从而提高分离效率。应用Fluent软件,结合雷诺应力模型(RSM)和混合多相流(Mixture)分析方法,对优化前、后的水力旋流器进行固-液两相流数值模拟。模拟内容包括水力旋流器内的速度分布、固相体积分数分布以及分离效率等。通过对比2种模型的模拟结果,说明优化的水力旋流器内部的流场速度以及分离效率均有一定的提高,达到了优化目的。 相似文献
99.
为探究振动荷载作用下熔融石英砂液化破坏过程中动变形和动强度变化规律, 促进透明土技术在岩土工程动力特性可视化模型试验中的推广和应用, 对构成透明砂土骨架结构的典型粒径(0.5~1.0 mm)熔融石英砂开展饱和试样动三轴试验; 研究了不同围压、加载频率和动应力比等试验条件下熔融石英砂试样的累积轴向应变、动孔压发展模式、动应力衰减、动弹性模量和阻尼比的变化规律, 并将试验结果与相同级配的标准砂进行了对比。分析结果表明: 熔融石英砂累积轴向应变随动应力比的增大呈现出由稳定型向破坏型转变的趋势, 加载频率为0.5~1.5 Hz时, 临界动应力比为0.150~0.175, 小于标准砂的0.200~0.225;升高围压、增大动应力比、降低加载频率会加快试样塑性应变累积, 缩短液化破坏时间; 熔融石英砂孔压发展模式随围压增大逐渐由Seed孔压模型向指数型过渡, 增大加载动应力会加剧液化破坏后孔压的振动幅度; 相同动应力比下, 熔融石英砂与标准砂的动应力与动应变呈现线性相关, 在围压大于200 kPa时, 二者动应力衰减幅度随围压的增大而逐渐减小; 熔融石英砂的动弹性模量和阻尼比表现为线性关系, 动弹性模量随动应变的增大呈现出双曲线型减小的趋势, 并随围压的增大而增大; 阻尼比随动应变的增加先增大后基本稳定在0.22, 发展曲线受围压影响较小。 相似文献
100.
基于同一级配低剂量半刚性基层混合料,本文分析了振动法和击实法两种方法成型试件的强度和力学特点。并通过实体工程对试验结果进行了验证。 相似文献