Experimental study on the width of the turbulent area around bridge pier

At present, the method of calculating the turbulent flow width around the bridge pier is not given in the "Standard for Inland River Navigation" (GB50139-2004) in China, and the bridge designer usually increases the bridge span in order to ensure the navigation safety, which increases both of the structural design difficulty and the project investments. Therefore, it is extremely essential to give a research on the turbulent flow width around the bridge pier. Through the experiments of the fixed bed and the mobile bed, the factors influencing the turbulent flow width around the bridge pier have been analyzed, such as the approaching flow speed, the water depth, the angles between the bridge pier and the flow direction, the sizes of bridge pier, the shapes of the bridge pier, and the scouring around the bridge pier, etc. Through applying the dimension analytic method to the measured data, the formula of calculating the turbulent flow width around the bridge pier is then inferred.     

A second order volume of fluid （VOF） scheme for numerical simulation of 2-D breaking waves

Among all environmental forces acting on ocean structures and marine vessels, those resulting from wave impacts are likely to yield the highest loads. Being highly nonlinear, transient and complex, a theoretical analysis of their impact would be impossible without numerical simulations. In this paper, a pressure-split two-stage numerical algorithm is proposed based on Volume Of Fluid (VOF) methodology. The algorithm is characterized by introduction of two pressures at each half and full cycle time step, and thus it is a second-order accurate algorithm in time. A simplified second-order Godunov-type solver is used for the continuity equations. The method is applied to simulation of breaking waves in a 2-D water tank, and a qualitative comparison with experimental photo observations is made. Quite consistent results are observed between simulations and experiments. Commercially available software and Boundary Integral Method (BIM) have also been used to simulate the same problem. The results from present code and BIM are in good agreement with respect to breaking location and timing, while the results obtained from the commercial software which is only first-order accurate in time has clearly showed a temporal and spatial lag, verifying the need to use a higher order numerical scheme.     

Using a SVM to evaluate damage to vibration isolators in an elastic raft system

Predicting damage to vibration isolators in a raft experiencing heavy shock loadings from explosions is an important task when designing a raft system. It is also vital to be able to research the vulnerability of heavily shocked floating rafts unreliable, especially when the allowable values The conventional approach to prediction has been or ultimate values of vibration isolators of supposedly uniform standard in a raft actually have differing and uncertain values due to defective workmanship. A new model for predicting damage to vibration isolators in a shocked floating raft system is presented in this paper. It is based on a support vector machine（SVM）, which uses Artificial Intelligence to characterize complicated nonlinear mapping between the impacting environment and damage to the vibration isolators. The effectiveness of the new method for predicting damage was illustrated by numerical simulations, and shown to be effective when relevant parameters of the model were chosen reasonably. The effect determining parameters, including kernel function and penalty factors, has on prediction results is also discussed. It can be concluded that the SVM will probably become a valid tool to study damage or vulnerability in a shocked raft system.     

基于电解海水法的船舶废气脱硫脱硝装置设计

设计一种利用海水淡化的生成物浓缩海水作为电解海水的原料,通过隔膜电解海水生成强氧化性溶液和强碱性溶液,利用强氧化性溶液与船舶废气中的SOX进行反应,强碱性溶液与船舶废气的NOX进行反应,从而达到废气的脱硫脱硝.为此,设计一套完整的基于电解海水的脱硫脱硝方案,将强氧化性溶液与强碱性溶液通过喷淋雾化的形式喷射出来,与船舶废...     

Study on launch dynamics of the tank marching fire

As an army main battle equipment, it is required that the tank should have high firing accuracy and high first round hit probability during marching. The initial disturbance of the projectile is the premier factor that takes effect on the marching fire accuracy of the tank. And the marching fire accuracy of the tank depends on the launch dynamics behaviors of the tank. In this paper, the launch dynamics theory of a tank marching fire is studied, and its launch dynamics model is established. Based on the transfer matrix method for multibody system(MSTMM) and the automatic deduction theorem of overall transfer equations, the overall transfer equation and the overall transfer matrix of a tank multibody system are deduced; the launch dynamics equations of the tank marching fire are deduced, and the dynamic response of the tank system, the motion of projectile in barrel, the initial disturbance of the projectile and the vertical target dispersion are exactly simulated; meanwhile, the results of simulation are verified by tests. This work provides both theoretical foundation and simulation approaches for improving the marching fire accuracy of the tank.     

神经网络集成在工程造价估算中的应用研究

工程造价和主要工程量是评价一建筑工程的重要经济指标,特别是工程量清单于2003年7月1日在全国范围内展开以来,快速估算工程造价和主要工程量更具有其重要意义.文中采用神经网络集成方法建立了工程造价和主要工程量估算数学模型,并采用matlab6 1计算软件,以深圳市已完典型工程资料为例,验证了该模型的正确性及实用性,得出了神经网络集成方法泛化能力更高的结论.     

飞行器磁流变自适应半主动冲击缓冲器

为解决传统飞行器着陆缓冲系统刚度和阻尼不可调节的问题,设计了磁流变变阻尼器件和磁流变弹性体变刚度单元并联的半主动控制缓冲器,建立了变刚度变阻尼控制模型,提出了基于能量守恒原理的磁流变自适应变刚度变阻尼控制策略.飞行器着陆过程缓冲控制的仿真实验结果表明:采用磁流变自适应变刚度变阻尼半主动控制技术后,飞行器受到的冲击能量在整个时间历程的分布更为合理,最大冲击载荷下降17%左右.     

Timing sequence changes of landscape plants in Shanghai Area,China

Based on published reports and direct observation, the common resources of landscape plant species in the Shanghai area were identified and studied in terms of the landscape characteristics of timing sequence changes over a one year time period. The results showed that there were 199 common landscape plant species in Shanghai, distributed in 67 families and 129 genera. These plants were categorized by three ornamental characteristics: flowers, foliage and fruits. The species were thus further analyzed according to the time periods which these characteristics were present. The results showed that flower ornamental distributed throughout the year, particularly from April to June, and plant species with colorful foliage could be seen every month, and particularly in November and December. On the other hand, few plant species with fruit ornamentals were observed in Shanghai area. The diversity of landscape timing sequence changes of the 199 plant species under examination was then analyzed by using the Shannon-Weiner and Simpson index formulas. The results showed that the higher diversity was observed in January, February and from August to October, while the lowest diversity was recorded from March to July and during November and December. The diversity of landscape characteristics of these plants was ranked according to foliage, flowers and fruit. Using this method, one park and one plant community were selected to evaluate the advantages and disadvantages of their time-changing plant landscape, with the goal of assessing the validity of the chosen ranking method. These results in the present study would be helpful to evaluate the plant landscape in a specified space and further enrich the diversity of plant and landscape by a target-oriented way.     

Numerical modeling of ground response during diaphragm wall construction

Construction of diaphragm wall panels may cause considerable stress changes in heavily overconsolidated soil deposits and can induce substantial ground movement. The 3D Lagrangian method was adopted to model the mechanical response of ground, including horizontal normal stress and shear stress, lateral ground displacement and vertical ground surface settlement, during the slurry trenching and concreting of diaphragm wall panels. Numerical results show that slurry trenching leads to horizontal stress relief of ground, reducing the horizontal stress of the ground from initial K0 pressure to hydrostatic betonite pressure. Wet concrete pressure lies between the hydrostatic bentonite pressure and the initial K0 pressure, so it can compensate partially the horizontal stress loss of the ground adjacent to the trench and thus reduce the lateral movement of the trench face as well as the vertical settlement of the ground surface.