Development and prospects of initial alignment method for strap-down inertial navigation system北大核心CSCD

Initial alignment technology is directly related to the navigation accuracy and startup time of the strap-down inertial navigation system (SINS), and has always been regarded as a challenging focal point in the research field of inertial navigation. This paper makes a comprehensive survey of SINS initial alignment technology, briefly introduces the basic principles of initial alignment without latitude, coarse alignment with known latitude and precise alignment, and points out their advantages, disadvantages and applicable conditions. The research and effects of existing initial alignment error suppression techniques are then analyzed and discussed. Finally, according to the problems of existing initial alignment methods and the development requirements of the carrier, the future research direction of SINS initial alignment technology is predicted. © 2022 Journal of Clinical Hepatology. All rights reserved.     

Influence of initial heeling angle on ship roll motion response北大核心CSCD

[目的]系统地研究初始横倾角对随机横浪下船舶横摇运动响应的影响。[方法]以路径积分法为基础,通过数值求解控制横摇运动微分方程概率属性的Fokker-Planck方程,得到横摇运动响应的概率分布。[结果]结果显示,初始横倾角对船舶横摇运动响应谱的影响有限,但对横摇角概率分布以及横摇运动响应极值分布的影响十分明显,且会造成船舶安全性的显著恶化。[结论]路径积分法可作为研究随机海浪下船舶横摇运动特性的有效数值方法。     

基于核磁共振与无侧限抗压试验对纤维加固红黏土的宏微观特性研究

红黏土因其具有孔隙比大、易压缩等不良工程特性,常在工程建设中引起一列工程问题.为此,采用聚丙烯纤维对红黏土进行加固,并采用核磁共振(NMR)技术和无侧限抗压强度试验对不同含量纤维加固后土体的宏微观特性进行测试,得到以下结论:1)不同含量纤维加固后红黏土的T2谱形态基本保持一致,均在弛豫时间为1 ms附近出现峰值,且纤维含量为0.2％时,试样内部信号最强;不同含量纤维加筋土内部的孔径主要分布在0.01μm到0.05μm之间,且0.02μm孔径所占比例最大;试样的孔隙度和T2谱峰值面积随纤维含量的增加表现出先增加后减小的趋势,且均在纤维含量为0.2％时到达最大值;2)纤维能够明显增加红黏土的抗压强度,加筋土的抗压强度与纤维含量保持良好的线性增加关系;且随着纤维含量的增加,试样由脆性破坏逐渐表现为韧性破坏特征.3)纤维在土体中起到加筋作用,显著增加了土体间的连接力,且纤维相互交叉连接形成了空间网状结构,限制了土体的变形,使得加筋土抗压强度增加并表现出韧性破坏特征.     

冲绳城市单轨运输系统

简要介绍了冲绳城市单轨运输系统的设施和车辆概况.     

Fluxes of dissolved inorganic carbon in three estuarine systems of the Cantabrian Sea (north of Spain)

The diffusive and in situ fluxes of dissolved inorganic carbon (DIC) and total alkalinity (TA) have been measured and an estimation has been made of the water–atmosphere fluxes of CO₂ in three estuarine systems of the Cantabrian Sea during the spring of 1998. Each of these systems undergoes a different anthropogenic influence. The diffusive fluxes of dissolved inorganic carbon and total alkalinity obtained present values ranging between 0.54–2.65 and 0.0–2.4 mmol m⁻² day⁻¹, respectively. These ranges are in agreement with those of other coastal systems. The in situ fluxes are high and extremely variable (35–284 mmol TA m⁻² day⁻¹, 43–554 mmol DIC m⁻² day⁻¹ and 22–261 mmol dissolved oxygen (DO) m⁻² day⁻¹), because the systems studied are very heterogeneous. The values of the ratio of the in situ fluxes of TA and DIC show on average that the rate of dissolution of CaCO₃ is 0.37 times that of organic carbon oxidation. Equally, the interval of variation of the relationship between the benthic fluxes of inorganic carbon and oxygen (F_DIC/F_DO) is very wide (0.3–13.9), which demonstrates the different contributions made by the processes of aerobic and anaerobic degradation of the organic matter, as well as by the dissolution–precipitation of CaCO₃. The water–atmosphere fluxes of CO₂ present a clear dependence on the salinity. The brackish water of these systems (salinity<20), where maximum fluxes of 989 mmol m⁻² day⁻¹ have been estimated, act as a source of CO₂ to the atmosphere. The more saline zones of the estuary (salinity>30) act as a sink of CO₂, with fluxes between −5 and −10 mmol m⁻² day⁻¹.     

Shape Optimization of Elliptical Road Containers Due to Liquid Load in Steady-State Turning

A numerical analysis of liquid load in elliptical road containers undergoing a steady-state turning manoeuvre is presented for containers of unrestricted size and for containers of fixed capacity. The liquid load is expressed in terms of the horizontal and vertical forces and the overturning moment created by these forces around the middle bottom point of the container. The moment is obtained by integrating the liquid free-surface equation and using numerical calculation of the resulting expressions. An optimization study with an objective to minimize the peak overturning moment is performed on containers of fixed capacity to identify the optimal height/width ratio of the container. The results of this investigation being of a general nature, i.e. with no restriction for an application, are particularly intended for road tankers under a steady turning manoeuvre, where they can be applied with high degree of accuracy.     

Young drivers and graduated licensing: The Ontario case

Despite improvements in road safety over the past several decades, accident rates remain high for young drivers. One accident countermeasure that is expected to improve the safety record of this group is graduated licensing. The philosophy behind this licensing system is that novice drivers, of whom the majority are young, should be restricted to relatively safe driving environments during the initial learning period. Graduated licensing was implemented in the Province of Ontario, Canada in 1994. The objective of this study is to estimate the potential benefits and costs for young drivers associated with two components of the Ontario graduated licensing package: the late-night driving curfew and the high-speed roadway restrictions. Based on accident and travel data for the year 1988, accident-involvement rates per kilometre driven were calculated for different driver groups for various combinations of time of day and roadway speed limit. These rates were then applied to the expected mobility profiles of young drivers affected by graduated licensing. The results of the study support the late-night curfew and suggest that this component of the licensing package should reduce total accident involvements for the affected group by up to 10 percent and fatal accident involvements by up to 24 percent, while reducing their total driving by only four percent. By contrast, the empirical evidence suggest that the high-speed roadway restrictions are likely to increase accident involvements, and thus it is strongly recommended that this component of Ontario's graduated licensing package be changed.     

Active Roll Control for Passenger Cars

The development of a mathematical model of a limited bandwidth hydro-pneumatic suspension that is incorporated into a vehicle handling model is described. The combined model is used to evaluate a suitable control strategy for eliminating body roll during a cornering manoeuvre. The philosophy behind the roll control strategy has been to use feedback measurements of the body motions which do not compromise the ride control. A study of the influence of the position of the body motion feedback transducer on the effectiveness of the system to reduce the body roll is presented. Non-linear modelling of the suspension components for a 0.8g cornering manoeuvre has revealed performance limitations. Conclusions are drawn as to the effectiveness of the control scheme.     

Basic Analytical Study of Pantograph-catenary System Dynamics

For a high speed electrical rail system, good dynamic performance of the pantograph-catenary system is vital for smooth and continuous current collection. It has been known for many years that to achieve this the head of the pantograph should be made as light as possible and the average stiffness of the catenary should be high. These conclusions, however, have been reached by numerical modelling and operational experience. In this paper the pantograph-catenary system is modelled as a time-varying, single degree-of-freedom system to facilitate an analytical investigation of the system dynamics. Although the model is very simple, it allows physical insight into the dynamic behaviour of the system, and because the excitation is parametric it also allows the stability of the system to be investigated. The finite element method is used to determine the catenary characteristics and Floquet theory is used to analyse the behaviour of the coupled system.     

Analysis of Driver's Decelerating Strategy in a Car-following Situation

This report describes a decelerating driver-model expressed by driving mode transition in car-following situations. The assumptions for constructing the model are that decelerating strategy of a driver is classified into several simple driving modes and that a driver changs his driving modes based on his perceptible characteristics and experiential rules. Deceleration action is divided into three states; following, standing and braking, which are applied to the model. The model has two paths for driver's decelerating action, one of which is selected by the driver based on the perceptible characteristics and experiential rules. The suitability of the model has been experimentally verified.