An evaluation of vehicle deceleration profiles

Vehicles stopping at signalized intersections were examined for the purpose of evaluating the validity of the common assumption of constant and uniform deceleration rates. The data set consisted of the first vehicles to stop upon the onset of the yellow signal interval with measurements of the initial approach speed, deceleration time, and deceleration distance. The deceleration rate may be computed using only two of the three measured values; thus the rate for each vehicle can be determined by three different equations. With nonuniform deceleration profiles, the equations will produce different values; and the degree of nonuniformity can be determined by comparing the differences in the computed deceleration rates. The analysis of the field observations indicated that 69 percent of the vehicles demonstrated deceleration profiles associated with nonuniform deceleration rates. Furthermore, the deceleration profile and the degree of nonuniformity were found to be a function of the initial approach speed.     

D9L推土机铸造铲刃,铲角的研制

在检测分析进口抗磨件基础上,采用空冷贝氏体铸钢制造了D9L推土机铲刃、铲角.实验室试验及1200h运行试验结果表明,国产件的性能和使用寿命均不低于进口产品.     

Effect of Connecting the Front and Rear Air Suspensions of a Vehicle on the Transmissibility of Road Undulation Inputs

Airsprings have been used for vehicle suspensions over the last 40 years. They are mostly used as independent suspensions. Analysis of air springs available in literature is mostly limited to a single-degree-of-freedom system or a two-degrees-of-freedom system only in the translation mode. This paper deals with a model of a vehicle where the front and the rear springs are connected by a capillary tube. A two-degrees-of-freedom model having motion in bounce and pitch mode is presented. Equations of mass flow are linearized on the assumption of small variations in volume and pressure. Expressions for the transmissibility and the phase angle in the bounce and the pitch mode are derived. Road inputs to the front and the rear axles are assumed to be identical except for a phase difference between them. The effect of the capillary flow coefficient and that of the phase angle between the front and the rear axle excitation are studied. It is shown that an optimum value of the capillary flow coefficient exists which minimizes the transmissibility of motion in both modes over the entire frequency range. It is also observed that a phase angle of 180 degrees presents ideal transmissibility characteristics. Thus, a promising application of air springs for a vehicle suspension is presented.     

出口苏丹米轨平车研制

介绍了出口苏丹米轨平车的技术参数、结构特点和试制情况。     

低噪声车轮的原理、试验及应用前景

通过理论分析和试验，对欧洲近几年的几种低噪声车轮的设计原理及试验效果做出了评价，对低噪声车轮在货运及高速运输中的应用前景做了分析。     

The influence of food quality on the nutritional acclimation of the copepod Acartia clausi

The influence of food quality on the nutritional metabolism of Acartia clausi was studied experimentally using four different diets: (1) diatom cells of Thalassiosira weissflogii, (2) detritus prepared from the same culture, (3) 50 : 50 mix on a protein basis of the two previous diets, and 4) dinoflagellate cells of Prorocentrum micans. For each trophic, ingestion, gut transit time, trypsin activity and K_m (half saturation constant) were measured at limiting and saturating concentration. Assimilation rates were also estimated for both pure diatoms and mixed live–detrital cell diets. Ingestion followed a Holling type 2 response for diets 1 and 4, a linear one for detritus and an intermediate response for diet 3. Gut transit time displayed different adaptive changes with food regime depending on protein concentration. Trypsin activity was lower for detrital food and trypsin K_m significantly decreased with increasing concentration of live diatoms. Assimilation rates were higher for live food than for mixed live–detrital food. Results illustrated that Acartia-type copepods optimize nitrogen or protein uptake. They suggest that besides chemoreception-mediated selectivity, internal controls by digestion and assimilation also regulate ingestion (feed-back).