Experimental study on the width of the turbulent area around bridge pier

At present, the method of calculating the turbulent flow width around the bridge pier is not given in the "Standard for Inland River Navigation" (GB50139-2004) in China, and the bridge designer usually increases the bridge span in order to ensure the navigation safety, which increases both of the structural design difficulty and the project investments. Therefore, it is extremely essential to give a research on the turbulent flow width around the bridge pier. Through the experiments of the fixed bed and the mobile bed, the factors influencing the turbulent flow width around the bridge pier have been analyzed, such as the approaching flow speed, the water depth, the angles between the bridge pier and the flow direction, the sizes of bridge pier, the shapes of the bridge pier, and the scouring around the bridge pier, etc. Through applying the dimension analytic method to the measured data, the formula of calculating the turbulent flow width around the bridge pier is then inferred.     

A second order volume of fluid （VOF） scheme for numerical simulation of 2-D breaking waves

Among all environmental forces acting on ocean structures and marine vessels, those resulting from wave impacts are likely to yield the highest loads. Being highly nonlinear, transient and complex, a theoretical analysis of their impact would be impossible without numerical simulations. In this paper, a pressure-split two-stage numerical algorithm is proposed based on Volume Of Fluid (VOF) methodology. The algorithm is characterized by introduction of two pressures at each half and full cycle time step, and thus it is a second-order accurate algorithm in time. A simplified second-order Godunov-type solver is used for the continuity equations. The method is applied to simulation of breaking waves in a 2-D water tank, and a qualitative comparison with experimental photo observations is made. Quite consistent results are observed between simulations and experiments. Commercially available software and Boundary Integral Method (BIM) have also been used to simulate the same problem. The results from present code and BIM are in good agreement with respect to breaking location and timing, while the results obtained from the commercial software which is only first-order accurate in time has clearly showed a temporal and spatial lag, verifying the need to use a higher order numerical scheme.     

Using a SVM to evaluate damage to vibration isolators in an elastic raft system

Predicting damage to vibration isolators in a raft experiencing heavy shock loadings from explosions is an important task when designing a raft system. It is also vital to be able to research the vulnerability of heavily shocked floating rafts unreliable, especially when the allowable values The conventional approach to prediction has been or ultimate values of vibration isolators of supposedly uniform standard in a raft actually have differing and uncertain values due to defective workmanship. A new model for predicting damage to vibration isolators in a shocked floating raft system is presented in this paper. It is based on a support vector machine（SVM）, which uses Artificial Intelligence to characterize complicated nonlinear mapping between the impacting environment and damage to the vibration isolators. The effectiveness of the new method for predicting damage was illustrated by numerical simulations, and shown to be effective when relevant parameters of the model were chosen reasonably. The effect determining parameters, including kernel function and penalty factors, has on prediction results is also discussed. It can be concluded that the SVM will probably become a valid tool to study damage or vulnerability in a shocked raft system.     

高速公路交通管理综合评价指标体系构建研究———以浙江省为例

随着交通信息化的发展, 交通数据的数量和类型都在不断增长。 现有的公安交通管理评价指标以违法查处量、 道路交通事故起数和死亡人数为主要评价指标, 无法满足海量交通数据量下的交通管理评价。 为了更好的量化和评估交通安全管理, 本研究利用数学和运筹学理论方法进行定性定量处理, 提出一种更为完备的高速公路交通管理综合评价体系。 模型构建以浙江省 2013-2017 年的数据计算权重系数, 并应用 2018 年的数据进行验证, 结果表明本研究所提出的体系更为科学、 合理、 客观。     

Study on launch dynamics of the tank marching fire

As an army main battle equipment, it is required that the tank should have high firing accuracy and high first round hit probability during marching. The initial disturbance of the projectile is the premier factor that takes effect on the marching fire accuracy of the tank. And the marching fire accuracy of the tank depends on the launch dynamics behaviors of the tank. In this paper, the launch dynamics theory of a tank marching fire is studied, and its launch dynamics model is established. Based on the transfer matrix method for multibody system(MSTMM) and the automatic deduction theorem of overall transfer equations, the overall transfer equation and the overall transfer matrix of a tank multibody system are deduced; the launch dynamics equations of the tank marching fire are deduced, and the dynamic response of the tank system, the motion of projectile in barrel, the initial disturbance of the projectile and the vertical target dispersion are exactly simulated; meanwhile, the results of simulation are verified by tests. This work provides both theoretical foundation and simulation approaches for improving the marching fire accuracy of the tank.     

静压PTC管桩施工技术

本文根据沪宁高速公路扩建工程HN—D1—1标静压桩的施工实践,对静压胛c桩施工原理、主要施工技术作一介绍,供同类工程借鉴参考。     

250km／h高速铁路轨道不平顺的安全管理

利用根据车辆－轨道耦合动力学思想所建立车辆－轨道垂横耦合模型,在充分考虑多种波长并存的情况下,仿真计算了250km/h高速铁路各种轨道不平顺的管理目标值。计算结果与日本和德国高速铁路轨道不平顺的经验管理目标值基本一致。     

磁悬浮列车横风稳定性的数值分析

利用二维定常不可压缩Navier-Stokes方程、K-E两方程紊流模型,采用有限体积法分析计算了不同车轨结构的磁浮列车横风稳定性,并与轮轨型列车的横风稳定性作了比较。数值分析结果表明,在横向风的作用下,轮轨型列车的横向稳定性优于磁浮列车,而吸力型磁浮列车的横向稳定性又优于U型线路斥力型磁浮列车。     

Timing sequence changes of landscape plants in Shanghai Area,China

Based on published reports and direct observation, the common resources of landscape plant species in the Shanghai area were identified and studied in terms of the landscape characteristics of timing sequence changes over a one year time period. The results showed that there were 199 common landscape plant species in Shanghai, distributed in 67 families and 129 genera. These plants were categorized by three ornamental characteristics: flowers, foliage and fruits. The species were thus further analyzed according to the time periods which these characteristics were present. The results showed that flower ornamental distributed throughout the year, particularly from April to June, and plant species with colorful foliage could be seen every month, and particularly in November and December. On the other hand, few plant species with fruit ornamentals were observed in Shanghai area. The diversity of landscape timing sequence changes of the 199 plant species under examination was then analyzed by using the Shannon-Weiner and Simpson index formulas. The results showed that the higher diversity was observed in January, February and from August to October, while the lowest diversity was recorded from March to July and during November and December. The diversity of landscape characteristics of these plants was ranked according to foliage, flowers and fruit. Using this method, one park and one plant community were selected to evaluate the advantages and disadvantages of their time-changing plant landscape, with the goal of assessing the validity of the chosen ranking method. These results in the present study would be helpful to evaluate the plant landscape in a specified space and further enrich the diversity of plant and landscape by a target-oriented way.     

Numerical modeling of ground response during diaphragm wall construction

Construction of diaphragm wall panels may cause considerable stress changes in heavily overconsolidated soil deposits and can induce substantial ground movement. The 3D Lagrangian method was adopted to model the mechanical response of ground, including horizontal normal stress and shear stress, lateral ground displacement and vertical ground surface settlement, during the slurry trenching and concreting of diaphragm wall panels. Numerical results show that slurry trenching leads to horizontal stress relief of ground, reducing the horizontal stress of the ground from initial K0 pressure to hydrostatic betonite pressure. Wet concrete pressure lies between the hydrostatic bentonite pressure and the initial K0 pressure, so it can compensate partially the horizontal stress loss of the ground adjacent to the trench and thus reduce the lateral movement of the trench face as well as the vertical settlement of the ground surface.