Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

An environmental assessment of air traffic speed constraints in the departure phase of flight: A case study at Gothenburg Landvetter Airport,Sweden

This paper considers the environmental effects of air traffic management speed constraints during the departure phase of flight. We present a CO₂ versus noise trade-off study that compares aircraft departure procedures subject to speed constraints with a free speed scenario. A departure route at Gothenburg Landvetter Airport in Sweden is used as a case study and the analysis is based on airline flight recorded data extracted from the Airbus A321 aircraft. Results suggest that CO₂ emissions could be reduced by 180 kg per flight if all departure speed constraints were removed at a cost of increased noise exposure below 70 dB(A).     

State estimation in roll dynamics for commercial vehicles

Accurate lateral load transfer estimation plays an important role in improving the performance of the active rollover prevention system equipped in commercial vehicles. This estimation depends on the accurate prediction of roll angles for both the sprung and the unsprung subsystems. This paper proposes a novel computational method for roll-angle estimation in commercial vehicles employing sensors which are already used in a vehicle dynamic control system without additional expensive measurement units. The estimation strategy integrates two blocks. The first block contains a sliding-mode observer which is responsible for calculating the lateral tyre forces, while in the second block, the Kalman filter estimates the roll angles of the sprung mass and those of axles in the truck. The validation is conducted through MATLAB/TruckSim co-simulation. Based on the comparison between the estimated results and the simulation results from TruckSim, it can be concluded that the proposed estimation method has a promising tracking performance with low computational cost and high convergence speed. This approach enables a low-cost solution for the rollover prevention in commercial vehicles.     

Employability skills of maritime business graduates: industry perspectives

The maritime industry underpins international business and world trade. As to be expected, business management is critical for the maritime industry, requiring highly trained individuals and teams to lead the development, implementation and control of sound contemporary management practices. Maritime business degrees are developed by universities to meet such demand by providing graduates with sufficient skills for the onshore business-related roles. This empirical study conducted in Australia, USA and Canada, investigates current and future industry employability skills for maritime business graduates through focus groups, individual interviews and an online survey with senior managers in maritime organisations. This study found the important employability skills for maritime business graduates which include communication, problem solving, adaptability, self-management, team work, and digital literacy and technology. Demand for digital literacy and technology knowledge and skills have increased due to the maritime industry having a trend of moving towards digitalisation and automation. However, the survey findings revealed that a skills focus for maritime business graduates will not be the technology itself but the use and management of technology. In relation to future skills/knowledge required from maritime business degree graduates in 10 years’ time, communication and adaptability are recognised as being the most important. Employers expect that maritime business graduates should be able to adopt new technology and be competent in communication, and be more adaptable given the highly dynamic nature of the maritime industry. Moreover, they require graduates to be equipped with a higher level of computer skills, have a strong work ethic and multilingual skills.     

Genetics of traffic assignment models for strategic transport planning

This paper presents a review and classification of traffic assignment models for strategic transport planning purposes by using concepts analogous to genetics in biology. Traffic assignment models share the same theoretical framework (DNA), but differ in capability (genes). We argue that all traffic assignment models can be described by three genes. The first gene determines the spatial capability (unrestricted, capacity restrained, capacity constrained, and capacity and storage constrained) described by four spatial assumptions (shape of the fundamental diagram, capacity constraints, storage constraints, and turn flow restrictions). The second gene determines the temporal capability (static, semi-dynamic, and dynamic) described by three temporal assumptions (wave speeds, vehicle propagation speeds, and residual traffic transfer). The third gene determines the behavioural capability (all-or-nothing, one shot, and equilibrium) described by two behavioural assumptions (decision-making and travel time consideration). This classification provides a deeper understanding of the often implicit assumptions made in traffic assignment models described in the literature. It further allows for comparing different models in terms of functionality, and paves the way for developing novel traffic assignment models.     

Quasi-two-dimensional flow on the polar β-plane: Laboratory experiments

Geophysical turbulence is strongly affected by the variation of the Coriolis parameter with latitude. This variation results in the so-called β-effect, which forces energy from small-scales to be transferred preferentially into zonal motions. This effect results in the formation of narrow jet-like zonal flows that dominate the dynamics and act as transport barriers. Here, laboratory experiments are used to reproduce this effect in decaying turbulent flows. An electromagnetic cell is used to generate an initial field of vorticity in a rotating tank. Under conditions of quasi-geostrophic flow, the β-effect is produced by depth variation of the flow instead of variation of the Coriolis parameter. The effects of changing the container geometry and the overall fluid depth on the production of jets are investigated. The results suggest that this laboratory configuration can be used to model jet formation in the oceans and that increasing fluid depth is a practical way to decrease viscous effects.     

Analysis of velocity fluctuations and their intermittency properties in the surf zone using empirical mode decomposition

We consider here surf zone turbulence measurements, recorded in the Eastern English Channel using a sonic anemometer. In order to characterize the intermittent properties of their fluctuations at many time scales, we analyze the experimental time series using the Empirical Mode Decomposition (EMD) method. The series is decomposed into a sum of modes, each one narrow-banded, and we show that some modes are associated with the energy containing wave breaking scales, and other modes are associated with small-scale intermittent fluctuations. We use the EMD approach in association with a newly developed method based on Hilbert spectral analysis, representing the probability density function in an amplitude–frequency space. We then characterize the fluctuations in a stochastic framework using a cumulant generating function for all scales, and compare the results obtained from direct and classical structure function analysis, to EMD–Hilbert spectral analysis results, showing that the former method saturates at large scales, whereas the latter method is more precise in its scale approach. These results show the strength of the new EMD–Hilbert spectral analysis method for data presenting a strong forcing such as found in shallow water, wave dominated situations.     

Impact of macrozoobenthic structures on near-bed sediment fluxes

Sandy sediments in shallow coastal waters of the Baltic Sea are often characterised by large numbers of biogenic structures which are produced by macrozoobenthos species. A series of experiments was devised to quantify how the interaction of such structures with the near-bed flow regime affects the sediment flux. Most experiments were done with simplified replicates of structures generated by typical species commonly found in the Mecklenburg Bight, starting with solitary structures and regularly-spaced arrays in a range of characteristic population densities, followed by a complex benthic macrofauna community, both artificial and alive. A laboratory flume channel, equipped with an acoustic Doppler flow sensor and a topography scanning laser, was used for high-resolution measurements (2 mm horizontal step size and 0.3 mm vertical resolution) of sand erosion (220 µm median grain size, at 20 cm s^− 1) and fine particle deposition (8 µm grain size, at 5 cm s^− 1). Sediment transport threshold values were measured for each layout. As a rule-of-thumb, both the erosion fluxes and the deposition of suspended matter increased considerably at low population densities (below 2%, expressed as percent of the sediment surface covered, i.e. roughness density RD). Above densities of 4%, erosion almost stopped inside the test arrays, and deposition remained well below the level of unpopulated areas. An attempt to extrapolate these findings to field conditions (using field current velocity data from 2001) showed that the net flux switched from erosion to deposition for densities above 5%. These parameters can now be integrated into a numerical sediment transport model coupling waves, currents, sediment dynamics and biological processes, which is currently under construction at the Baltic Sea Research Institute (IOW), Rostock, Germany.     

The importance of oceanographic fronts to marine birds and mammals of the southern oceans

During the last 30 years, at-sea studies of seabirds and marine mammals in the oceans south of the Subtropical Front have described an association with major frontal areas. More recently, the advancement in microtechnology has allowed the tracking of individuals and investigations into how these marine predators actually use the frontal zones. In this review, we examine 1) the relative importance to apex predators of the different frontal zones in terms of spatial distribution and carbon flux; 2) the processes that determine their preferential use; and 3) how the mesoscale dynamics of frontal structures drive at-sea foraging strategies of these predators. We review published results from southern waters and place them in a broader context with respect to what has been learned about the importance of fronts in oceans farther north.Some fronts constitute important boundaries for seabird communities in southern waters. At a mesoscale the maximum values of seabird diversity and abundance correspond to the location of the main fronts. At-sea surveys show a strong curvilinear correlation between seabird abundance and sea surface temperatures. High mean species richness and diversity for whales and seabirds are consistently associated with the southern water mass boundary of the Antarctic Circumpolar Current, the Subtropical Front and the Subantarctic Front; in the case of the Polar Front mean seabird densities are more variable. At small-scales, variation in seabird occurrence has been directly related to the processes at fronts in a limited number of cases. A significant positive relation was found between some plankton feeding species and frontal temperature gradient–phytoplankton variables.Telemetric studies have revealed that several apex predators (penguins, albatrosses, seals) perform long, directed foraging trips either to the Subtropical front or Polar Front, depending on locality. Seabirds with low flight costs, such as albatrosses, are able to reach fronts at long distances from colonies, showing variable foraging strategies as a function of the distances involved. Diving birds such as King penguins, that travel at a higher cost and lower speed, rely on the predictable spatial distribution of mesopelagic fish found close to the Polar Front. They may use the currents associated with eddies as oceanographic cues in the active search for frontal zones. Once in these areas they dive preferentially in and below the depth of the thermocline where catches per unit effort are high. Elephant seals concentrate foraging activity principally inside or at the boundary of cyclonic eddies. These mesoscale features appear to offer exceptional productivity favourable for foraging by various diving top predators.The connection between biophysical parameters at fronts and predators is likely to be made through biological enhancement. Top predators appear to forage at locations where prey are advected by physical processes and others where prey are produced locally. Long-term research on at-sea distributions and demographic parameters of top predators are essential to assess the consequences of potential shift in front distributions in relation to global warming. Such environmental changes would add to the impact of fish extraction by the industrial fisheries on the southern food webs.     

The use of polycyclic aromatic hydrocarbons as a particulate tracer in the water column of Gaoping (Kaoping) Submarine Canyon

Time-series samples of settling particles were collected in the water column of Gaoping (formerly spelled Kaoping) Submarine Canyon (KPSC) with two sediment traps on taut-line moorings deployed at two different depths (60 and 280 m) between May 26 and June 27, 2004. Average total polycyclic aromatic hydrocarbon (PAH) concentrations of upper and lower trap array samples were 310 ± 61 ng g^− 1 dw (range: 200–440) and 240 ± 36 ng g^− 1 dw (range: 180–290), respectively. Principal component analysis results suggest that PAH sources in the trap-collected particles included diesel vehicle/coal burning, diagenetic sources, and petroleum release. PAH downward fluxes based on settling particles were estimated to be 12–44 μg m^− 2 d^− 1. These values are higher than those reported in the literature for most coastal areas. During the sampling period, both traps were significantly tilted by tidal current and fluctuated vertically. The upper traps experienced greater vertical movements, thus their particle characteristics (e.g., POC, particle mass, and fine particle fraction) varied more than those of the lower traps. Hourly depth variations of the tilted sediment trap array were echoed by the corresponding total PAH concentrations. Moreover, the PAH composition of the collected particles was related to the flow direction and speed. These observations suggest that PAHs can be used as an effective chemical tracer for the transport of terrestrial and marine particulates in a complex aquatic environment like Gaoping (Kaoping) Submarine Canyon.