公路桥梁高承台桩基沉降分析研究

桩基的沉降计算是桩基工程设计不可忽视的关键问题之一。为探讨高承台桩基沉降特性，基于荷载传递法提出一种高承台桩基沉降计算方法，并采用多组不同参数对某高承台群桩的沉降特性进行了比较计算和深入分析，得到了多个影响因素下群桩沉降的变化规律。     

倾斜偏心荷载下基桩内力位移分析

针对工程中地基土性质变化的具体情况,假定地基系数满足(mz+C)的线性增长规律,考虑P - Δ效应并计入桩身自重、桩侧摩阻力和桩体微倾的影响,采用矩阵计算方法,分别得到单层土中倾斜偏心荷载作用、桩段顶端倾斜偏心荷载作用以及桩身水平分布荷载共同作用下的单桩计算分析的幂级数解答.结合某具体实例,对上述方法进行了验证,结果表明,该解答与实际吻合较好,具有一定的应用价值,并得出结论:桩体倾斜对桩基受力性能有显著影响.     

小东江电站左岸边坡稳定性分析及治理措施

为了确定小东江电站左岸边坡体的稳定性状况,以边坡体工程地质条件为基础,对该边坡体的滑坡成因进行分析.通过运用极限平衡法和有限元法计算分析,边坡体可能产生蠕滑失稳,须进行加固治理.经综合比较分析,加固方式采用格构式加固体系更加合理,阐述了方案设计过程及格构梁与锚索(杆)的布置.加固的效果表明,分析计算及加固方案是合理的.     

连续刚构桥的群桩基础计算模型研究

群桩基础是连续刚构最常用的基础形式之一，分析探讨了群桩基础的几种建模方法，给出了建模思路和参数取值。结合苏通大桥辅航道桥预应力混凝土连续刚构的工程需要，提出了考虑群桩基础与上部结构共同工作的计算模型，并将计算结果与不考虑桩基的模型计算结果进行了对比分析，计算方法对类似工程有直接参考价值。     

石灰土中石灰活性衰减规律研究

通过试验的方法研究松散石灰土在常温和低温开放状态、常温密封状态条件下石灰活性衰减的规律，推定出不同状态条件下石灰活性衰减率公式，以确定石灰土合理的闷料时间，减少不必要的石灰活性衰减和未消解石灰对路面基层的破坏，为石灰土路面基层质量问题的界定提供依据。     

V形刚构桥施工中倒三角区域支架的拆除时机分析

采用桥梁博士软件模拟一座典型的V形墩连续刚构桥的施工过程,为找出支架拆除对传力途径的影响,分别单独计算结构自重、预应力以及收缩徐变内力,然后对单因素分析的结果进行组合。分析结果表明倒三角区域支架的拆除时机对桥梁在施工阶段及成桥后的内力均有显著影响,可达50%以上。建议优先采用早拆支架方案,以使结构受力明确,且对V形墩区域受力有利。     

特种弹药铁路运输可调式定位装置研究

概述了特种弹药铁路运输可调试定位装置的主要功能、技术要求、主要战技术指标，介绍了特种弹药铁路运输采用的从箱体顶部固定方式，并进行了相应的可调式定位装置研究，将装置分为整体固定和单点独立固定两种，用于固定弹箱在敞车内的位置，确保弹体运输安全。     

关于沥青混凝土路面的常见病害及防治措施

沥青混凝土路面主要应用于公路的面层,由于沥青混凝土材料本身的差异,以及受设计、施工水平的影响,沥青路面常常出现松散、脱皮、冻胀翻浆、水破坏、沉陷、开裂、泛油、坑槽等病害。这些病害的出现严重影响了路面行车速度、行车安全、加大了汽车磨损、缩短了沥青路面的使用寿命,使行车不畅,行成交通压力,造成道路使用年限缩短。本文具体结合工程项目阐述沥青混凝土的施工工艺、病害分析及防治措施。     

Effect of interference fits on the fatigue lives of bolted composite joints

The effect of interference fits on the fatigue lives of bolted composite joints is investigated by conducting mechanical tests. Static and fatigue tests are carried out on specimens made of carbon-bismaleimide composites joined together as double-lap single-bolt joints. The bolts having interference fits ranging of 0 (neat fit), 0.5%, 0.75% and 1% are performed. The results demonstrate the relationship between fatigue life and different values of interference fits. After the fatigue tests, non-destructive evaluation (NDE) and scanning electron microscope (SEM) are used to observe the damage of the surrender and surface of the hole. The test results show that the interference fitted specimens have improved fatigue life compared to the neat fitted specimen. The NDE and SEM results reveal that the damage degree of interference fitted specimen is weaker than that for the neat fitted one.     

Two degree of freedom flow-induced vibration of cylindrical structures in marine environments: frequency ratio effects

The flow-induced vibration of a cylindrical structure is a very common problem in marine environments such as undersea pipelines, offshore risers, and cables. In this study, the vortex-induced vibration (VIV) of an elastically mounted cylinder at a low Reynolds number is simulated by a transient coupled fluid–structure interaction numerical model. Considering VIV with low damping ratio, the response, hydrodynamic forces, and vortex shedding modes of the cylinder is systematically analyzed and summed up the universal rule under different frequency ratios. On the basis of the analysis, we find that the frequency ratio α is a very important parameter. It decides the locked-in, beat, and phase-switch phenomena of the cylinder, meanwhile, it also influence the vortex mode of the cylinder. The trajectory of the two degrees of freedom (2 DOF) case at different natural frequency ratios is discussed, with most trajectories having a “figure of 8” shape and a few having a “crescent” shape. A fast Fourier transformation technique is used to obtain the frequency characteristics of the vibration of the cylindrical structure. Using the 2 DOF cylinder model in place of the 1 DOF model presents several advantages in simulating the nonlinear characteristics of cylindrical structures, including the capacity to model the crosswise vibration generated by in-line vibration.