驾驶员统计特性对人—车闭环系统响应的影响与汽车主动安全性评价

基于预瞄跟随理论，本文应用一般随机摄动法，对考虑驾驶员不确定性的人－车闭环系统进行响应分析，结合实例，说明该方法在汽车主动安全性评价中的应用。     

沥青混凝土摊铺机液压系统的计算机故障诊断

通过对ＬＴＬ４５００型沥青摊铺机液压系统现有故障诊断方案进行分析，探讨了计算机辅助故障诊断技术的可行性，同时总结出一种确定最佳维修期的方法。     

钢管混凝土系杆拱桥预应力技术及结构分析测试研究

南京栖霞大桥为一座主跨８６．５ｍ的大跨度宽桥面钢管混凝土系杆拱桥。阐述了该桥的预应力施工技术，分析了桥梁在施工各阶段的受力特征，并结合系梁的实测应力，对实施过程中的结构安全性进行评价。同时还研究了大跨度宽桥面系杆拱桥独特的力学特征。     

连续刚构桥的群桩基础计算模型研究

群桩基础是连续刚构最常用的基础形式之一，分析探讨了群桩基础的几种建模方法，给出了建模思路和参数取值。结合苏通大桥辅航道桥预应力混凝土连续刚构的工程需要，提出了考虑群桩基础与上部结构共同工作的计算模型，并将计算结果与不考虑桩基的模型计算结果进行了对比分析，计算方法对类似工程有直接参考价值。     

石灰土中石灰活性衰减规律研究

通过试验的方法研究松散石灰土在常温和低温开放状态、常温密封状态条件下石灰活性衰减的规律，推定出不同状态条件下石灰活性衰减率公式，以确定石灰土合理的闷料时间，减少不必要的石灰活性衰减和未消解石灰对路面基层的破坏，为石灰土路面基层质量问题的界定提供依据。     

V形刚构桥施工中倒三角区域支架的拆除时机分析

采用桥梁博士软件模拟一座典型的V形墩连续刚构桥的施工过程,为找出支架拆除对传力途径的影响,分别单独计算结构自重、预应力以及收缩徐变内力,然后对单因素分析的结果进行组合。分析结果表明倒三角区域支架的拆除时机对桥梁在施工阶段及成桥后的内力均有显著影响,可达50%以上。建议优先采用早拆支架方案,以使结构受力明确,且对V形墩区域受力有利。     

特种弹药铁路运输可调式定位装置研究

概述了特种弹药铁路运输可调试定位装置的主要功能、技术要求、主要战技术指标，介绍了特种弹药铁路运输采用的从箱体顶部固定方式，并进行了相应的可调式定位装置研究，将装置分为整体固定和单点独立固定两种，用于固定弹箱在敞车内的位置，确保弹体运输安全。     

关于沥青混凝土路面的常见病害及防治措施

沥青混凝土路面主要应用于公路的面层,由于沥青混凝土材料本身的差异,以及受设计、施工水平的影响,沥青路面常常出现松散、脱皮、冻胀翻浆、水破坏、沉陷、开裂、泛油、坑槽等病害。这些病害的出现严重影响了路面行车速度、行车安全、加大了汽车磨损、缩短了沥青路面的使用寿命,使行车不畅,行成交通压力,造成道路使用年限缩短。本文具体结合工程项目阐述沥青混凝土的施工工艺、病害分析及防治措施。     

Effect of interference fits on the fatigue lives of bolted composite joints

The effect of interference fits on the fatigue lives of bolted composite joints is investigated by conducting mechanical tests. Static and fatigue tests are carried out on specimens made of carbon-bismaleimide composites joined together as double-lap single-bolt joints. The bolts having interference fits ranging of 0 (neat fit), 0.5%, 0.75% and 1% are performed. The results demonstrate the relationship between fatigue life and different values of interference fits. After the fatigue tests, non-destructive evaluation (NDE) and scanning electron microscope (SEM) are used to observe the damage of the surrender and surface of the hole. The test results show that the interference fitted specimens have improved fatigue life compared to the neat fitted specimen. The NDE and SEM results reveal that the damage degree of interference fitted specimen is weaker than that for the neat fitted one.     

Two degree of freedom flow-induced vibration of cylindrical structures in marine environments: frequency ratio effects

The flow-induced vibration of a cylindrical structure is a very common problem in marine environments such as undersea pipelines, offshore risers, and cables. In this study, the vortex-induced vibration (VIV) of an elastically mounted cylinder at a low Reynolds number is simulated by a transient coupled fluid–structure interaction numerical model. Considering VIV with low damping ratio, the response, hydrodynamic forces, and vortex shedding modes of the cylinder is systematically analyzed and summed up the universal rule under different frequency ratios. On the basis of the analysis, we find that the frequency ratio α is a very important parameter. It decides the locked-in, beat, and phase-switch phenomena of the cylinder, meanwhile, it also influence the vortex mode of the cylinder. The trajectory of the two degrees of freedom (2 DOF) case at different natural frequency ratios is discussed, with most trajectories having a “figure of 8” shape and a few having a “crescent” shape. A fast Fourier transformation technique is used to obtain the frequency characteristics of the vibration of the cylindrical structure. Using the 2 DOF cylinder model in place of the 1 DOF model presents several advantages in simulating the nonlinear characteristics of cylindrical structures, including the capacity to model the crosswise vibration generated by in-line vibration.