THE STUDY ON THE CHANGES OF ZINC, COPPER, CALCIUM AND MAGNESIUM IN PLASMA AND ERYTHROCYTES DURING CARDIOPULMONARY BYPASS

Objective To study the changes and their influence factors involved of zinc, copper, calcium and magnesium in plasma and erythrocytes during cardiopulmonary hypass(CPB). Methods Zinc, copper, calcium and magnesium values in plasma and erythrocytes were measured by atomic absorption spectrophotometer during CPB. Results Zinc and copper levels in plasma were significantly elevated above preinduction level before perfusion, hut calcium and magnesium levels did not change significantly; zinc, copper and calcium levels in plasma were significantly below preoperation level during CPB, hut magnesium level in plasma was significantly increased above preoperation; zinc level in plasma was increased to preoperation level after CPB and began to decrease again at 8 hours after CPB,copper level in plasma was increased to preoperation level at 20 hours after CPB, calcium in plasma was increased significantly from beginning to 8 hours after CPB, magnesium level in plasma was decreased to preoperation level at 8 hours afterCPB. Concentration of zinc , copper, calcium and magnesium in erythrocytes did not change significantly. Conclusion During CPB, the changes of zinc, copper, calcium and magnesium had relation to hemodilution, operative wound, carrier protein, stress and component of priming Solution and cardioplegic solution, hut no relation to transferfrom plasma erythrocytes. The results indicate that it is beneficial to patient‘s recovery to supplement zinc, copper, calcium and magnesium properly by different ways during cardiac perioperation.     

道路黑点识别与改善

针对道路黑点识别方法、黑点成因及改善措施,总结了国内外经验,提出质量控制法识别路网中事故多发道路,经验一鉴别指数法识别道路事故多发点(段),以及确定黑点改善优先排序方法．并进行了系统的说明与论述。应用结果表明该方法识别道路黑点准确,改善措施效果显著。     

基于多级可拓评价的城市大型建筑物交通影响程度判定

本文提出了将多级可拓评价应用于城市大型建筑物交通影响程度的判定。首先建立了城市大型建设项目影响因素的评价指标体系并给出了每个指标的计算方法;其次将可拓工程方法和城市大型建设项目的影响因子相结合,建立了城市大型建设项目交通影响评价的多级可拓评价模型;最后结合实例分析了该方法的实用性。     

基于投影的车牌倾斜检测方法

图像倾斜检测是车牌识别中的关键环节之一。典型的倾斜检测算法是进行Hough变换后寻找长直线的倾斜角度．在实际应用中,车牌图像中未必有明显的较长直线,或者长直线对正确检测形成干扰．本文介绍一种基于投影的车牌图像倾斜检测方法,通过对车牌图像做各种角度投影,寻找投影图像峰宽最窄的角度,即是图像的倾斜角度。测试结果表明了这种方法的有效性。     

柴油机MFB2型凸轮的设计与优化方法

MFB2型凸轮能够兼顾充气性能及平稳性两方面的要求，已在国内多种柴油机上获得应用，效果良好。本文推导了MFB2型凸轮的设计过程并介绍了其优化设计方法。     

Relations Among Some Fuzzy Entropy Formulae

Fuzzy entropy has been widely used to analyze and design fuzzy systems，and many fuzzy entropy formulae have been proposed.For further in-deepth analysis of fuzzy entropy，the axioms and some important formulae of fuzzy entropy are intoduced.Some equivalence results among these fuzzy entropy formulae are proved，and it is shown that fuzzy entropy is aspedal distance measurement．     

公路声屏障设计浅析

首先结合《公路环境保护设计规范》以及《环境影响评价技术导则声环境》,对公路声屏障声学原理、设计步骤及计算公式进行了论述,并以合阳至铜川高速公路作为设计实例,利用软件程序进行辅助设计,得到声屏障设计相关参数,对公路声屏障设计有一定的参考价值。     

基于出行成本分析的公交系统乘车均衡模型与制度安排

公交优先是缓解城市拥堵的重要方法.按照Wardrop 用户均衡原则,通过考虑乘客候车时间成本、乘车时间成本、换乘时间成本和车内拥挤成本,对包含两条线路（一条为一票直达线路,一条为支线干线线路）的公交系统建立出行选择均衡模型,并基于乘客个人出行成本的分析,得到了固定需求下用户均衡时两条线路选择人数和系统最优时两线路的最优发车频率.还在弹性需求情形下比较了系统最优和公交公司垄断情形两种不同政策所导致的均衡出行人数、公交票价、发车频率、公司利润和社会净收益等指标.算例结果验证了理论分析,得到了与传统经济学理论研究一致的结果,为相关管理政策的制定提供了理论科学依据.     

考虑汉语句子阅读阈限的交通辅助标志字高设计

为保障驾驶员对交通辅助标志的有效视认,运用实验方法,研究辅助标志字高设计.建模分析驾驶员对交通标志信息的视认过程,构建基于车速和字数的交通辅助标志字高模型;设计实验分析交通辅助标志汉字阅读阈限;根据阅读阈限,分别确定门架式和悬臂式两种交通辅助标志在不同速度和字数条件的最小字高要求,并与《道路交通标志和标线(第2部分):...     

复合式路面层间界面剪切滑移特性

依托南大梁高速公路复合式路面试验段, 测试了不同糙化界面的露骨率和构造深度, 并钻取芯样进行45°剪切试验。结合45°剪切试验测试结果与层间剪切过程力学特性, 将层间剪变特性曲线划分为弹性阶段、破坏阶段、剪切强度衰减阶段和残余阶段, 采用界面构造深度、剪切强度峰值、剪切强度峰值对应层间相对滑动位移和残余剪切强度等指标评价层间剪变特性, 分析了界面糙化方式、防水黏结材料类型和用量、温度和加载速率对复合式路面层间剪变特性的影响。测试结果表明: 凿毛界面构造深度(1.17mm) 大于喷砂界面构造深度(0.37mm), 结合不同糙化界面下剪切过程的层间力学特性差异, 凿毛界面较喷砂界面所成型复合试件具有更优的抗剪性能; 防水黏结材料相同时, 凿毛界面层间剪切强度峰值对应层间相对滑动位移(0.19~0.79mm) 较喷砂界面(0.16~0.33mm) 更大, 且防水黏结材料对残余剪切强度和剪切强度峰值的影响大于层间剪切强度峰值对应层间相对滑动位移的影响; 整体而言, 温度对层间剪变特性影响显著, 5℃时层间剪切强度峰值为40℃时的7.0~10.0倍, 测试条件对层间剪切强度影响较大, 50mm·min^-1加载速率时测试层间剪切强度峰值为5mm·min^-1加载速率时的1.9~3.5倍。可见, 凿毛糙化方式更有助于提高复合式路面层间剪切强度, 且复合式路面层间剪变特性需采用多指标予以评价。