Simulation of mixed gas formation for a spray-wall complex guided LPG direct injection engine

To obtain an ultralean air-fuel ratio and to reduce engine-out NOX and HC emissions induced by the richer mixture near the spark plug, a spray and wall complex guided combustion system has been developed by utilizing the fuel characteristics of LPG. The new combustion system configuration is optimized by using a commercial CFD code, FIRE V2013, and the reliability of the system has been experimentally demonstrated by Plane Laser-Induced Fluorescence (PLIF). The mixture formation in the new combustion system under part load (2,000 rpm) is numerically simulated. With an injection timing of 40°CA BTDC, the LPG spray which is injected from two upper holes, reaches the ignition point, and the other part of the LPG spray which is injected from the bottom hole, is directed to the ignition point through the vertical vortices at the same time. At the ignition timing of about 20°CA BTDC, the two-part mixtures have been shown to form a stable and richer stratified mixture around the ignition point, and the maximum global air-fuel ratio reaches to 60: 1.     

Robust control for four-wheel-independent-steering electric vehicle with steer-by-wire system

A four-wheel-independent-steering (4WIS) electric vehicle (EV) with steer-by-wire (SBW) system is proposed in this paper. The fast terminal sliding mode controller (FTSMC) is designed for the SBW system to suppress external disturbances. Taking unstructured and structured uncertainties into consideration, a robust controller is designed for the 4WIS EV utilizing μ synthesis approach and the controller order reduction is implemented based on Hankel-Norm approximation. Since sideslip angle is the feedback signal of robust controller and it is hard to measure, the extended Kalman filter (EKF) is employed to estimate sideslip angle. To evaluate the vehicle performance with the designed control system, step and sinusoidal steering maneuvers are simulated and analyzed. Simulation results show that the designed control system have good tracking ability, strong robust stability and good robust performance to improve vehicle stability and handing performance.     

约束对隧道二次衬砌早期温度应力分布的影响

为了解决隧道工程渗水问题,基于某隧道工程,采用MIDAS-GEN对其二次衬砌早期模筑混凝土进行非稳定温度应力场以及周围约束进行研究。研究结果表明:约束可以改变隧道的早期拉应力场的分布,具有外围约束的隧道二次衬砌的拉应力为隧道厚度中间最大,无约束隧道的拉应力为外部最大,约束可以减小隧道外部区域的拉应力,使得远离约束区域的拉应力变大,而无约束隧道的拉应力分布与之相反。根据温度应力分布特点,建议在设计方面适当增大二次衬砌中间与外侧的配筋,在施工方面减小初期支护与二次砌衬之间约束等。     

基于发动机台架考核方法的气缸盖高周疲劳特性研究

依据发动机台架考核规范,运用疲劳强度理论,对某铸铁气缸盖进行高周疲劳强度评估。明确温度和应力随考核工况改变的变化行为,研究气缸盖各区域受工作载荷的影响状况,为缸盖寿命评估模型提供载荷边界。结合疲劳理论,在考虑材料修正的基础上进行了疲劳特性分析和损伤状况分析。分析表明,气缸盖各区域的疲劳安全系数均大于1,视为安全,但冷却钻孔区域的安全裕度较小。     

VVL耦合喷油策略对GDI汽油机混合气形成的影响

利用三维仿真软件Ansys Fluent建立了GDI汽油机的仿真计算模型,就变气门升程耦合不同喷油策略对缸内气流运动和混合气形成的影响进行了模拟计算。结果表明,与大气门升程工况相比,小气门升程工况的缸内湍流运动强度、燃油蒸发和湿壁情况以及点火时刻混合气质量都明显改善;在小气门升程工况,采用两段喷油会缩短油气混合时间,过度推迟二次喷油时刻会恶化混合气质量和燃油湿壁情况;在大气门升程工况,两段喷油会改善混合气均匀性,随着二次喷油时刻推迟,燃油蒸发量增加,湿壁情况加剧,混合气质量得到改善;小气门升程工况下采用二次喷油时刻为470°曲轴转角,前后两次喷油量比例为7∶3的两段喷油方案在燃油蒸发和湿壁以及点火时刻缸内混合气质量这几个方面的效果都很好,是最合理的方案。     

航空客运收益管理无约束需求预测方法研究

无约束需求预测是提高收益管理决策准确性的重要前提,需求修复是其关键的组成部分.本文基于航空客运的需求特点,对无约束需求预测方法进行了定量研究和讨论.首先对研究的问题进行了描述,提出先将Holt模型用于需求修复,再使用Holt-Winters模型进行无约束需求预测的思想,并结合组合预测方法,建立了基于Holt的组合需求修复模型和基于Holt-Winters的组合预测模型.最后,通过数值仿真,验证了本文的无约束需求预测方法和组合模型对航空客运收益管理的可行性和有效性.     

���˹���������������ɢ��������ʵ֤����

国家体育场作为北京奥运会的主会场成功地承担了开闭幕式和田径赛事任务。本文研究了其停车场车辆的交通疏散问题,制定了疏散方案。首先,分析了国家体育场停车场和泊位布局及车辆疏散的具体条件。其次,通过给定环境的场景和参数设定,对具体的奥运场馆停车场车辆的疏散方案进行了仿真和评价。最后,利用奥运会开幕式的车辆疏散实测数据进行了对比分析,在仿真中要员和贵宾车辆的总疏散时间为26min,而奥运会开幕式车辆疏散实测结果表明,全部要员、贵宾疏散完毕,共用时27min,从而验证了车辆疏散方案的准确性和实用性。     

Effect of ABCA1-V771M polymorphism on plasma lipid levels and its relationship with coronary atherosclerotic heart disease

Objective To explore the risk association of ABCA1-V771M polymorphism with coronary heart disease (CHD) in Hart nationality in Northwest of China. Methods With case-control study, ABCA1-V771M polymorphism was detected in 204 unrelated Hart nationality people in Northwest of China, and all the subjects by coronary angiography were grouped into 106 cases and 98 controls. The genotypes and alleles frequency distribution of ABCA1-V771M polymorphisms were analyzed by PCR-RFLP analysis, and the clinical statistics of serum lipids were compared and its effects of ABCA1-V771M polymorphism on the plasma lipid levels and coronary atherosclerotic heart disease were analyzed. Results The genotypic frequencies of ABCA1-V771M polymorphism matched well under Hardy-Weinberg equilibrium (P>0.05), V and M allelic frequencies were 33.3% and 66.7%. In comparison with VV VM genotype carriers, MM genotypes carriers had much lower plasma levels of HDL-C (P<0. 001) and much higher plasma levels of TG (P<0. 05). M allelic frequency in CHD group was significantly higher than V allelic frequency (P<0. 05). M allele was related with more severity of atherosclerosis in the coronary artery than V allele (P<0.05). However, there was no obvious difference in the incidence of AMI among carriers with three genotypes of ABCA1-V771M polymorphism (P>0.05). Conclusion ABCA1-V771M polymorphism was not only associated with the plasma levels of HDL-C and TG, but also related to the susceptibility and severity of coronary atheroselerotic heart disease. Moreover, M771 allele appeared to be atherogenie among Han population in Northwest of China.     

饲料加硼对摄入过量氟的实验大鼠骨损伤的预防作用

目的探讨饲料加硼对过量氟摄入的大鼠骨损伤的预防作用。方法24只4-5周龄Sprague-Dawley(SD)大鼠分为:对照组(喂饲基础饲料,饮蒸馏水)、过量氟组[喂饲基础饲料,饮含100mg/LF-(氟化钠221mg/L的蒸馏水)]、硼预防组(喂饲加硼饲料,饮含100mg/LF-的蒸馏水)。实验3月后测量大鼠血清氟、硼含量及血清碱性磷酸酶(alkaline phosphatase,AKP)活性、骨氟和骨总RNA含量、胫骨纵径横径和干重及骨密度(bone mineral density,BMD),并检测大鼠股骨生物力学特性。结果和对照组比较,过量氟组大鼠血清氟、骨氟含量和血清AKP活性显著增高;骨总RNA含量、全身骨骼平均BMD和胫骨BMD降低;胫骨纵径、横径和干重减小;股骨最大负荷减低,最大形变增加。相比过量氟组,硼预防组大鼠血清氟和骨氟含量及AKP活性明显下降;骨总RNA含量、全身骨骼平均BMD、腰椎和胫骨BMD显著增高;胫骨纵径、横径和干重,股骨最大负荷明显增加。3组大鼠血清硼含量无显著性差异。结论大鼠摄入过量氟可出现明显的骨损伤,饲料加硼对此有一定的预防作用。     

京珠高速公路隧道病害检测与处治对策研究

通过京珠高速公路隧道病害现场检测,对其主要病害进行了分类统计。考虑该隧道的勘察、设计、施工等因素影响,对该隧道主要病害产生原因进行了分析,在此基础上,对隧道病害等级进行了判定,并针对不同等级病害,提出了具体的处治措施。