大岭铺隧道坍方处理

介绍西康线大岭铺隧道软弱破碎围岩坍方处理施工。洞口段坍方采用钢轨棚架支护；隧道内拱部坍方采用全断面超前小导管预注浆固结松散体再进行开挖的方法。     

相参脉压末制导雷达抗箔条干扰分析

根据箔条对雷达干扰的作用机理，分析相参脉压末制导雷达在抗箔条干扰方面的优势，明确了分辨力的提高对雷达抗箔条干扰的重要性，而相参脉压雷达能很好地解决提高分辨力的问题，为今后弹上雷达的选型提供参考。     

既有线顶进框架立交桥软土地基加固设计

文章主要介绍了利用钢筋混凝土方桩加固框架桥主体地基时,钢筋混凝土方桩单桩容许承载力和地基强度的计算方法,以及防止框架顶进“扎头”,需要换填快硬混凝土的深度。     

Research on probability distribution of port cargo throughput

In order to more accurately examine developing trends in gross cargo throughput, we have modeled the probability distribution of cargo throughput. Gross cargo throughput is determined by the time spent by cargo ships in the port and the operating efficiency of handling equipment. Gross cargo throughput is the sum of all compound variables determining each aspect of cargo throughput for every cargo ship arriving at the port. Probability distribution was determined using the Wald equation. The results show that the variability of gross cargo throughput primarily depends on the different times required by different cargo ships arriving at the port. This model overcomes the shortcoming of previous models： inability to accurately determine the probability of a specific value of future gross cargo throughput. Our proposed model of cargo throughput depends on the relationship between time required by a cargo ship arriving at the port and the operational capacity of handling equipment at the port. At the same time, key factors affecting gross cargo throughput are analyzed. In order to test the efficiency of the model, the cargo volume of a port in Shandong Province was used as an example. In the case study the actual results matched our theoretical analysis.     

汽车拖拉机盘状转子平衡设备设计中的一些新技术

介绍了新研制成的汽车拖拉机盘状转子平衡校正组合机床的一些技术梗概，汽车拖拉机盘状转子的平衡特性，转子不平衡量的测量与计算，微机系统的硬软件及该机的工作的流程等；给出了计算夹具偏心、转子不平衡量、不平衡量─钻深转换公式；详细说明了适应多品种转子平衡校正的硬软件设计     

粉尘测定相对质量浓度与质量浓度转换方法的研究

应用P-5L_2型数字粉尘计与配有符合BMRC粒度分级标准予捕集器的粉尘采样器,置于各粉尘作业场,同时、同步测定呼吸性粉尘与总粉尘质量浓度及相对质量浓度,通过相关分析与计算,求得粉尘质量浓度转换K与K_1值,及CPM与mg/m~3换算图。     

Analysis of Automatic Steering Control for Highway Vehicles with Look-down Lateral Reference Systems

In this paper, steering control for passenger cars on automated highways is analyzed, concentrating on look-down reference systems. Extension of earlier experimental results for low speed to highway speed is shown to be non-trivial. The limitations of pure output-feedback of lateral vehicle displacement from the road reference are examined under practical constraints and performance requirements like robustness, maximum lateral error and comfort. The in-depth system analysis directly leads to a new alternative design direction which allows to preserve look-ahead reference systems for highway speed automatic driving.     

城市轨道交通低压直流配电系统研究

城市轨道交通低压配电广泛采用交流配电系统。随着直流用电设备在城市轨道交通的大量应用,采用低压直流配电系统将成为趋势。但是,中外均缺乏城市轨道交通低压直流配电系统的工程案例和设计标准。因此,对城市轨道交通低压直流配电的电压等级选取、配电系统结构、接地类型和电气保护方式进行研究。结果表明,相同供电距离时,DC 750(±375)V供电网络的供电能力约为AC 380V的4倍。根据城市轨道交通用电负荷特点,低压直流供电系统主母线电压等级采用DC 750(±375)V、DC 220V(±110)V两级,主接线结构采用双极三线制,城市轨道交通低压直流配电系统应采用IT接地型式。     

新安江流域综合规划:兼谈流域防洪与生态保护

针对普遍存在的流域防洪和生态保护问题,该文以新安江流域为例,提出站在流域综合规划的高度来统筹防洪与生态保护,采取综合措施来调控洪峰流量和生态基流、采用低影响开发理念减少城市化对水文过程的影响,以及减小河流大型水利设施对生物多样性的影响等4点建议,可为流域综合管理提供参考。     

An Experimental Study on the Effects of Exhaust Valve Timing on the Cold Start and Its Emission Performance of Gasoline Engine

通过对一台可变排气正时的汽油机进行试验,研究了不同排气门关闭正时对汽油机冷起动及其排放性能的影响.试验结果表明,通过提前排气门关闭时刻,改变气门重叠角,适当增大缸内残余废气量,可以显著改善汽油机冷起动燃烧性能,缩短起动时间.适当提前排气关闭时刻,也有利于降低冷起动过程的HC和CO排放.